基于人工智能的3D血管造影用于复杂脑血管病变可视化
本研究用人工智能3D血管造影后处理方法重建了10例脑动脉瘤、10例AVM和10例dAVF的3D-DSA数据,并与常规3D-DSA对比。结果显示两者图像质量相当,病变定性定量评估几乎完全一致,且3D血管造影无需掩模采集,有望显著降低患者辐射剂量。
要点
- AI 3D血管造影与3D-DSA在动脉瘤、AVM、dAVF的评估中高度一致
- 该方法无需掩模采集,可显著降低患者辐射剂量
- 图像质量与3D-DSA等效,注射血管几何评估无显著差异
核心结论
- 基于人工智能的3D血管造影是可视化复杂脑血管病变的可靠方法,结果与3D-DSA相当。
- 3D血管造影无需掩模采集,有望显著降低患者辐射剂量。
研究设计与样本
- 对每例3D-DSA数据分别用常规软件和原型软件重建,共60个容积。
- 由2名神经放射学家共识阅读,评估图像质量、注射血管直径、血管几何指数及病变特异性参数。
关键影像表现/征象
- 3D血管造影与3D-DSA在AVM、dAVF和脑动脉瘤的定性定量评估中几乎完全一致。
诊断标准与关键数值
- AVM评估参数包括位置、病灶大小、供血动脉、相关动脉瘤、引流静脉及Spetzler-Martin评分。
- dAVF评估参数包括瘘点、主要供血动脉、主要供血动脉直径及引流静脉。
- 脑动脉瘤评估参数包括位置、瘤颈及大小。
临床应用与阅片要点
- 日常阅片可考虑用AI 3D血管造影替代3D-DSA进行脑血管病变的无创或低剂量评估。
- 重建图像质量与3D-DSA等效,可用于测量动脉瘤大小、AVM病灶大小及供血动脉直径。
- 需注意本研究为共识阅读,实际应用中应关注不同操作者间的一致性。
局限性
- 研究采用共识阅读,未评估观察者间一致性。
- 未报告辐射剂量降低的具体数值,仅提出潜在优势。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
BACKGROUND AND PURPOSE: By means of artificial intelligence, 3D angiography is a novel postprocessing method for 3D imaging of cerebral vessels. Because 3D angiography does not require a mask run like the current standard 3D-DSA, it potentially offers a considerable reduction of the patient radiation dose. Our aim was an assessment of the diagnostic value of 3D angiography for visualization of cerebrovascular pathologies.
MATERIALS AND METHODS: 3D-DSA data sets of cerebral aneurysms (n CA = 10), AVMs (n AVM = 10), and dural arteriovenous fistulas (dAVFs) (n dAVF = 10) were reconstructed using both conventional and prototype software. Corresponding reconstructions have been analyzed by 2 neuroradiologists in a consensus reading in terms of image quality, injection vessel diameters (vessel diameter [VD] 1/2), vessel geometry index (VGI = VD1/VD2), and specific qualitative/quantitative parameters of AVMs (eg, location, nidus size, feeder, associated aneurysms, drainage, Spetzler-Martin score), dAVFs (eg, fistulous point, main feeder, diameter of the main feeder, drainage), and cerebral aneurysms (location, neck, size).
RESULTS: In total, 60 volumes have been successfully reconstructed with equivalent image quality. The specific qualitative/quantitative assessment of 3D angiography revealed nearly complete accordance with 3D-DSA in AVMs (eg, mean nidus size3D angiography/3D-DSA= 19.9 [SD, 10.9]/20.2 [SD, 11.2] mm; r = 0.9, P = .001), dAVFs (eg, mean diameter of the main feeder3D angiography/3D-DSA= 2.04 [SD, 0.65]/2.05 [SD, 0.63] mm; r = 0.9, P = .001), and cerebral aneurysms (eg, mean size3D angiography/3D-DSA= 5.17 [SD, 3.4]/5.12 [SD, 3.3] mm; r = 0.9, P = .001). Assessment of the geometry of the injection vessel in 3D angiography data sets did not differ significantly from that of 3D-DSA (vessel geometry indexAVM: r = 0.84, P = .003; vessel geometry indexdAVF: r = 0.82, P = .003; vessel geometry indexCA: r = 0.84, P <.001).
CONCLUSIONS: In this study, the artificial intelligence-based 3D angiography was a reliable method for visualization of complex cerebrovascular pathologies and showed results comparable with those of 3D-DSA. Thus, 3D angiography is a promising postprocessing method that provides a significant reduction of the patient radiation dose.
引用
- Lang S, Hoelter P, Schmidt M, et al. Artificial Intelligence-Based 3D Angiography for Visualization of Complex Cerebrovascular Pathologies. AJNR Am J Neuroradiol. 2021. PMID: 34503946. doi:10.3174/ajnr.A7252
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。