管电压与冠状动脉CT血管成像斑块成分的关联:PARADIGM注册研究结果
该研究基于国际注册PARADIGM中1236例间隔≥2年行系列CCTA的患者,探讨低管电压扫描所致管腔衰减异质性对斑块量化的影响。结果显示管腔HU升高与钙化斑块比例增加、纤维脂肪斑块和坏死核心减少相关;高kV扫描降低管腔衰减并改变斑块成分构成。中介分析提示100kV对斑块成分的影响主要通过血池衰减间接介导,而80kV对纤维脂肪斑块和坏死核心还保留直接效应。
要点
- 管腔HU越高,钙化斑块占比越高、纤维脂肪和坏死核心占比越低
- 管电压升高使管腔衰减降低,钙化斑块体积占比下降、纤维脂肪和坏死核心占比上升
- 以CCTA斑块成分为治疗反应指标时需考虑管电压和管腔衰减的影响
核心结论
- 低管电压使用主要通过升高管腔HU导致钙化斑块增加、纤维脂肪斑块和坏死核心减少,从而影响斑块形态学评估。
研究设计与样本
- 研究为国际注册PARADIGM(NCT02803411)的回顾性分析,纳入1236例间隔≥2年行系列CCTA的连续患者,年龄60±9岁,41%为女性。
- 排除既往血运重建或无法分析的冠状动脉CTA;评估总冠状动脉斑块体积并按特定HU阈值分为坏死核心、纤维脂肪斑块、纤维斑块和致密钙化。
- 管腔衰减在主动脉内测量;比较不同管腔HU区间(<350、350-500、>500 HU)和不同管电压(80、100、120 kV)下的斑块成分差异,并行中介分析。
诊断标准与关键数值
- 随管腔HU升高(<350、350-500、>500 HU),钙化斑块百分比中位数增加(16%、27%、40%,P<0.001),纤维脂肪斑块(26%、13%、4%,P<0.001)和坏死核心(1.6%、0.3%、0.0%,P<0.001)降低。
- 随管电压升高(80、100、120 kV),管腔衰减降低(689±135、497±89、391±73 HU,P<0.001),钙化斑块体积占比降低(59%、34%、23%,P<0.001),纤维脂肪斑块(3%、9%、18%,P<0.001)和坏死核心(0.2%、0.1%、0.6%,P<0.001)升高。
- 中介分析显示,与120 kV相比,100 kV对斑块成分的影响主要通过血池衰减的间接效应介导;80 kV对纤维脂肪斑块和坏死核心除间接效应外还保留直接效应。
临床应用与阅片要点
- 阅片和报告斑块成分时需注意管电压和管腔衰减对HU阈值分类的影响,避免将扫描条件差异误判为斑块成分变化。
- 在系列CCTA随访比较斑块成分或评估治疗反应时,应尽量保持管电压和对比剂方案一致,或对管腔衰减差异进行校正。
- 低管电压(尤其80 kV)下管腔HU升高可能高估钙化成分、低估纤维脂肪和坏死核心,解读斑块进展或消退时需谨慎。
局限性
- 原文未明确列出局限性;作为注册研究的回顾性分析,扫描方案异质性及HU阈值分类对管电压的依赖性可能影响结果外推。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVES: This study sought to investigate the impact of low tube voltage scanning heterogeneity of coronary luminal attenuation on plaque quantification and characterization with coronary computed tomography angiography (CCTA).
BACKGROUND: The impact of low tube voltage and coronary luminal attenuation on quantitative coronary plaque remains uncertain.
METHODS: A total of 1,236 consecutive patients (age: 60 ± 9 years; 41% female) who underwent serial CCTA at an interval of ≥2 years were included from an international registry. Patients with prior revascularization or nonanalyzable coronary CTAs were excluded. Total coronary plaque volume was assessed and subclassified based on specific Hounsfield unit (HU) threshold: necrotic core, fibrofatty plaque, and fibrous plaque and dense calcium. Luminal attenuation was measured in the aorta.
RESULTS: With increasing luminal HU (<350, 350-500, and >500 HU), percent calcified plaque was increased (16%, 27%, and 40% in the median; P < 0.001), and fibrofatty plaque (26%, 13%, and 4%; P < 0.001) and necrotic core (1.6%, 0.3%, and 0.0%; P < 0.001) were decreased. Higher tube voltage scanning (80, 100, and 120 kV) resulted in decreasing luminal attenuation (689 ± 135, 497 ± 89, and 391 ± 73 HU; P < 0.001) and calcified plaque volume (59%, 34%, and 23%; P < 0.001) and increased fibrofatty plaque (3%, 9%, and 18%; P < 0.001) and necrotic core (0.2%, 0.1%, and 0.6%; P < 0.001). Mediation analysis showed that the impact of 100 kV on plaque composition, compared with 120 kV, was primarily caused by an indirect effect through blood pool attenuation. Tube voltage scanning of 80 kV maintained a direct effect on fibrofatty plaque and necrotic core in addition to an indirect effect through the luminal attenuation.
CONCLUSIONS: Low tube voltage usage affected plaque morphology, mainly through an increase in luminal HU with a resultant increase in calcified plaque and a reduction in fibrofatty and necrotic core. These findings should be considered as CCTA-based plaque measures are being used to guide medical management and, in particular, when being used as a measure of treatment response. (Progression of Atherosclerotic Plaque Determined by Computed Tomographic Angiography Imaging [PARADIGM]; NCT02803411).
引用
- Takagi H, Leipsic JA, Indraratna P, et al. Association of Tube Voltage With Plaque Composition on Coronary CT Angiography: Results From PARADIGM Registry. JACC Cardiovasc Imaging. 2021. PMID: 34419398. doi:10.1016/j.jcmg.2021.07.011
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。