负重CT三维定量评估膝关节间隙宽度
本研究回顾性分析负重CT图像,验证关节间隙映射(JSM)在膝关节三维关节间隙宽度(JSW)评估中的可重复性、重复性和可行性。结果显示JSM在无放射学疾病个体中最小可检测差异小于±0.1 mm,平均RMS-CV小于5%,且三维JSW分布与Kellgren-Lawrence分级相关,中央至后部内侧间隙每增加一级狭窄0.5 mm(P<.05)。
要点
- 负重CT的JSM可定量生成膝关节三维JSW图,重复性高,最小可检测差异小于±0.1 mm。
- 内侧胫股关节中央至后部间隙随KLG每增加一级显著狭窄0.5 mm(P<.05)。
- JSM可由新手可靠学习,并能个性化适应疾病表型。
关键影像表现/征象
- JSM生成三维JSW图,在无放射学疾病个体的中央内侧胫股关节间隙最小可检测差异小于±0.1 mm。
- 统计参数映射显示中央至后部内侧关节间隙随KLG每增加一级显著狭窄0.5 mm(阈值P<.05)。
- 一例KLG 2膝关节在24个月随访中三维JSW分布变化超过外侧关节间隙的最小可检测差异。
诊断标准与关键数值
- 可重复性和重复性最低性能出现在无放射学疾病个体的中央内侧胫股关节间隙,最小可检测差异小于±0.1 mm。
- 所有组平均均方根变异系数小于5%。
- 统计参数映射阈值P<.05,中央至后部内侧关节间隙每增加一级KLG狭窄0.5 mm。
临床应用与阅片要点
- JSM可用于负重CT图像的三维JSW定量评估,辅助骨关节炎结构病变的早期检测和随访。
- 注意最小可检测差异在无放射学疾病个体中央内侧间隙小于±0.1 mm,阅片时应关注该区域细微变化。
- JSM可由新手经过训练可靠使用,适合临床推广。
局限性
- 回顾性研究设计。
- 使用便利样本,样本量较小(可重复性20人、重复性9人、统计参数映射33人)。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Background Imaging of structural disease in osteoarthritis has traditionally relied on MRI and radiography. Joint space mapping (JSM) can be used to quantitatively map joint space width (JSW) in three dimensions from CT images. Purpose To demonstrate the reproducibility, repeatability, and feasibility of JSM of the knee using weight-bearing CT images. Materials and Methods Two convenience samples of weight-bearing CT images of left and right knees with radiographic Kellgren-Lawrence grades (KLGs) less than or equal to 2 were acquired from 2014 to 2018 and were analyzed retrospectively with JSM to deliver three-dimensional JSW maps. For reproducibility, images of three sets of knees were used for novice training, and then the JSM output was compared against an expert's assessment. JSM was also performed on 2-week follow-up images in the second cohort, yielding three-dimensional JSW difference maps for repeatability. Statistical parametric mapping was performed on all knee imaging data (KLG, 0-4) to show the feasibility of a surface-based analysis in three dimensions. Results Reproducibility (in 20 individuals; mean age, 58 years ± 7 [standard deviation]; mean body mass index, 28 kg/m2 ± 6; 14 women) and repeatability (in nine individuals; mean age, 53 years ± 6; mean body mass index, 26 kg/m2 ± 4; seven women) reached their lowest performance at a smallest detectable difference less than ±0.1 mm in the central medial tibiofemoral joint space for individuals without radiographically demonstrated disease. The average root mean square coefficient of variation was less than 5% across all groups. Statistical parametric mapping (33 individuals; mean age, 57 years ± 7; mean body mass index, 27 kg/m2 ± 6; 23 women) showed that the central-to-posterior medial joint space was significantly narrower by 0.5 mm for each incremental increase in the KLG (threshold P < .05). One knee (KLG, 2) demonstrated a baseline versus 24-month change in its three-dimensional JSW distribution that was beyond the smallest detectable difference across the lateral joint space. Conclusion Joint space mapping of the knee using weight-bearing CT images is feasible, demonstrating a relationship between the three-dimensional joint space width distribution and structural joint disease. It is reliably learned by novice users, can be personalized for disease phenotypes, and can be used to achieve a smallest detectable difference that is at least 50% smaller than that reported to be achieved at the highest performance level in radiography. © RSNA, 2021 Online supplemental material is available for this article. See also the editorial by Roemer in this issue.
引用
- Turmezei TD, B Low S, Rupret S, et al. Quantitative Three-dimensional Assessment of Knee Joint Space Width from Weight-bearing CT. Radiology. 2021. PMID: 33847516. doi:10.1148/radiol.2021203928
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。