正常二尖瓣与不同反流程度二尖瓣脱垂的瓣膜应变定量研究
本研究对82例患者行三维经食管超声心动图,构建二尖瓣数字模型并计算收缩期峰值应变,比较正常瓣膜、二尖瓣脱垂伴轻度或无显著反流(MVP-MR)及伴中重度反流(MVP+MR)三组。结果显示MVP+MR应变最高、正常瓣膜最低,后叶在MVP-MR组已高于正常;多变量分析中瓣叶厚度是平均二尖瓣应变的唯一独立相关参数。
要点
- 二尖瓣脱垂患者瓣膜应变高于正常瓣膜,尤其在后叶。
- 应变随反流加重和瓣环/瓣叶增大而升高。
- 瓣叶厚度是二尖瓣应变的独立相关参数。
核心结论
- 二尖瓣脱垂瓣膜较正常瓣膜应变更高,尤其在后叶;尽管应变随反流加重及瓣环、瓣叶增大而升高,瓣叶厚度是最显著的独立决定因素。
研究设计与样本
- 研究纳入82例患者行三维经食管超声心动图,其中正常二尖瓣32例、二尖瓣脱垂50例(MVP-MR 12例,MVP+MR 38例),基于专有软件生成三维模型并计算收缩期峰值应变。
关键影像表现/征象
- MVP+MR组瓣环面积最大(13.8 ± 0.7 cm2),MVP-MR组(10.6 ± 1 cm2)与正常瓣膜组(10.5 ± 0.3 cm2)相当(方差分析 p < 0.001)。
- MVP+MR组瓣叶面积最大,尤其后叶(8.7 ± 0.5 cm2);MVP-MR组居中(6.5 ± 0.7 cm2);正常瓣膜组最小(5.5 ± 0.2 cm2;p < 0.0001)。
- 应变总体在MVP+MR组最高、正常瓣膜组最低;MVP-MR组后叶应变高于正常瓣膜组(p = 0.001)。
临床应用与阅片要点
- 三维经食管超声可动态建模并定量二尖瓣收缩期应变,后叶应变在MVP-MR组已高于正常,提示后叶应变可能较早反映瓣膜形变异常。
- 多变量分析中瓣叶厚度与平均二尖瓣应变独立相关(r = 0.34;p = 0.008),阅片时需关注瓣叶厚度与瓣环、瓣叶尺寸。
局限性
- 原文未述局限性
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVES: The aim of this study was to quantitate patient-specific mitral valve (MV) strain in normal valves and in patients with mitral valve prolapse with and without significant mitral regurgitation (MR) and assess the determinants of MV strain.
BACKGROUND: Few data exist on MV deformation during systole in humans. Three-dimensional echocardiography allows for dynamic MV imaging, enabling digital modeling of MV function in health and disease.
METHODS: Three-dimensional transesophageal echocardiography was performed in 82 patients, 32 with normal MV and 50 with mitral valve prolapse (MVP): 12 with mild mitral regurgitation or less (MVP - MR) and 38 with moderate MR or greater (MVP + MR). Three-dimensional MV models were generated, and the peak systolic strain of MV leaflets was computed on proprietary software.
RESULTS: Left ventricular ejection fraction was normal in all groups. MV annular dimensions were largest in MVP + MR (annular area: 13.8 ± 0.7 cm2) and comparable in MVP - MR (10.6 ± 1 cm2) and normal valves (10.5 ± 0.3 cm2; analysis of variance: p < 0.001). Similarly, MV leaflet areas were largest in MVP + MR, particularly the posterior leaflet (8.7 ± 0.5 cm2); intermediate in MVP - MR (6.5 ± 0.7 cm2); and smallest in normal valves (5.5 ± 0.2 cm2; p < 0.0001). Strain was overall highest in MVP + MR and lowest in normal valves. Patients with MVP - MR had intermediate strain values that were higher than normal valves in the posterior leaflet (p = 0.001). On multivariable analysis, after adjustment for clinical and MV geometric parameters, leaflet thickness was the only parameter that was retained as being significantly correlated with mean MV strain (r = 0.34; p = 0.008).
CONCLUSIONS: MVs that exhibit prolapse have higher strain compared to normal valves, particularly in the posterior leaflet. Although higher strain is observed with worsening MR and larger valves and annuli, mitral valve leaflet thickness-and, thus, underlying MV pathology-is the most significant independent determinant of valve deformation. Future studies are needed to assess the impact of MV strain determination on clinical outcome.
引用
- El-Tallawi KC, Zhang P, Azencott R, et al. Valve Strain Quantitation in Normal Mitral Valves and Mitral Prolapse With Variable Degrees of Regurgitation. JACC Cardiovasc Imaging. 2021. PMID: 33744129. doi:10.1016/j.jcmg.2021.01.006
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。