文献速递心血管US

心外膜换能器测量的心肌应变——不同速度估计方法的比较

Myocardial Strain Measured by Epicardial Transducers-Comparison Between Velocity Estimators.
PubMed 文献 · Ultrasound Med Biol · 2021-02-13

研究描述一种将微型换能器直接缝合于心外膜表面并连续测量心脏收缩的实验超声系统,用于获取心肌内速度分布并追踪四个不同深度心肌层的运动与区域应变。四种速度估计方法经仿真模型和五只动物超声记录测试,均能重现心肌速度分布、追踪心肌层运动并估计应变;数字化超声扫描线先上采样10倍再做互相关时延估计结果最准确,但计算耗时长,实时系统可能更倾向计算更快的恒定加速度多普勒。

要点

  • 实验系统将微型换能器直接缝合于心外膜表面,可连续测量心脏收缩并获取心肌内速度分布。
  • 四种速度估计方法在仿真模型和五只动物超声记录中均能追踪四个不同深度心肌层的运动并估计区域应变。
  • 数字化扫描线先上采样10倍再行互相关时延估计结果最准确,但计算耗时长,可能最适合实验室环境。

核心结论

  • 所测试的速度估计方法均能在仿真和真实超声记录中重现心肌速度分布、追踪心肌层运动并估计心肌内不同位置的应变。
  • 数字化超声扫描线先上采样10倍再行互相关时延估计时结果最准确,但该方法计算耗时长,可能最适合实验室环境。
  • 允许速度在脉冲包持续时间内随时间线性变化的改进多普勒算法(恒定加速度多普勒)在捕捉快速变化速度方面优于传统多普勒处理,实时系统可能更倾向使用计算更快的该方法。

研究设计与样本

  • 实验超声系统研究,使用直接缝合于心外膜表面的微型换能器连续测量心脏收缩。
  • 在仿真模型和五只动物的超声记录上测试四种速度估计方法。
  • 参考标准为仿真模型中移动组织的超声回声。

关键影像表现/征象

  • 心肌内速度从心外膜到心内膜边界存在变化。
  • 通过心肌内速度分布追踪四个不同深度心肌层的运动,并计算各层的区域应变。

临床应用与阅片要点

  • 作者指出,上采样联合时延估计因计算耗时长,可能最适合实验室环境;实时系统可能更倾向计算更快的恒定加速度多普勒。

局限性

  • 上采样联合时延估计所需计算时间长,可能使其最适合实验室环境。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

This study describes results from an experimental ultrasound system with miniature transducers sutured directly onto the epicardial surface and used to measure heart contractions continuously. This system was used to find velocity distributions through the myocardium. The resulting velocities were used to track the motion of four layers at different depths through the myocardium and to find the regional strain in each of the four layers. Velocities inside the myocardium vary from the epicardial to the endocardial borders. Conventional velocity estimators based on Doppler and on time delay estimation were modified to better handle these variations. Results from four different velocity estimators were tested against a simulation model for ultrasound echoes from moving tissue and on ultrasound recordings from five animals. We observed that the tested velocity estimators were able to reproduce the myocardial velocity distributions, track the myocardial layer motion and estimate strain at different positions inside the myocardium for both simulated and real ultrasound recordings. The most accurate results were obtained when the digitized ultrasound scanlines were upsampled by a factor of 10 before applying cross-correlation to estimate time delays. A modified Doppler algorithm allowing the velocity to vary linearly with time throughout the duration of the pulse packet (constant acceleration Doppler) was found to be better at capturing rapidly changing velocities compared with conventional Doppler processing. The best results were obtained using upsamling and time delay estimation, but the long computation time required by this method may make it best suited in a laboratory setting. In a real-time system, the computationally quicker constant acceleration Doppler may be preferred.

来源:Ultrasound Med Biol,查看原文。版权归原作者所有。

引用

  1. Nguyen TT, Espinoza AW, Hyler S, et al. Myocardial Strain Measured by Epicardial Transducers-Comparison Between Velocity Estimators. Ultrasound Med Biol. 2021. PMID: 33593489. doi:10.1016/j.ultrasmedbio.2021.01.012

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。