利用深度卷积神经网络在多排探测器CT图像中进行机会性骨质疏松筛查
本回顾性研究纳入1449例因其他指征行脊柱或腹部CT扫描的患者,来自三家不同CT厂商,其中586例用于训练、863例用于测试。采用U-Net自动分割椎体、DenseNet-121计算骨密度,以定量CT后处理值为标准;自动分割与手动分割相关性良好,自动回归计算的骨密度与定量CT高度相关(r>0.98),深度学习法可全自动识别骨质疏松、骨量减少和骨密度正常。
要点
- 深度学习可在CT图像上对腰椎椎体进行准确的全自动分割。
- 深度学习计算的平均骨密度与定量CT derived值高度相关(r>0.98)。
- 该方法可能有助于临床医生在脊柱或腹部CT扫描中进行机会性骨质疏松筛查。
关键影像表现/征象
- 自动分割与手动分割在L1-L4四个腰椎椎体上相关性良好,三个测试集的最小平均Dice系数分别为0.823、0.786和0.782。
- 对于来自不同厂商的测试集,自动回归计算的平均骨密度与定量CT derived值高度相关(r>0.98)且一致性好。
诊断标准与关键数值
- 以定量CT后处理值作为骨密度分析的标准。
- 自动分割以手动勾画的椎体区域作为对照基准,三个测试集的最小平均Dice系数分别为0.823、0.786和0.782。
- 自动回归计算的平均骨密度与定量CT derived值高度相关(r>0.98)。
临床应用与阅片要点
- 深度学习法可在脊柱或腹部CT扫描中用于机会性骨质疏松筛查,可能有助于临床医生。
- 自动分割在L1-L4椎体上与手动分割相关性良好,最小平均Dice系数分别为0.823、0.786和0.782。
- 自动回归计算的平均骨密度与定量CT derived值高度相关(r>0.98),可用于骨密度评估。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVE: To explore the application of deep learning in patients with primary osteoporosis, and to develop a fully automatic method based on deep convolutional neural network (DCNN) for vertebral body segmentation and bone mineral density (BMD) calculation in CT images.
MATERIALS AND METHODS: A total of 1449 patients were used for experiments and analysis in this retrospective study, who underwent spinal or abdominal CT scans for other indications between March 2018 and May 2020. All data was gathered from three different CT vendors. Among them, 586 cases were used for training, and other 863 cases were used for testing. A fully convolutional neural network, called U-Net, was employed for automated vertebral body segmentation. The manually sketched region of vertebral body was used as the ground truth for comparison. A convolutional neural network, called DenseNet-121, was applied for BMD calculation. The values post-processed by quantitative computed tomography (QCT) were identified as the standards for analysis.
RESULTS: Based on the diversity of CT vendors, all testing cases were split into three testing cohorts: Test set 1 (n = 463), test set 2 (n = 200), and test set 3 (n = 200). Automated segmentation correlated well with manual segmentation regarding four lumbar vertebral bodies (L1-L4): the minimum average dice coefficients for three testing sets were 0.823, 0.786, and 0.782, respectively. For testing sets from different vendors, the average BMDs calculated by automated regression showed high correlation (r > 0.98) and agreement with those derived from QCT.
CONCLUSIONS: A deep learning-based method could achieve fully automatic identification of osteoporosis, osteopenia, and normal bone mineral density in CT images.
KEY POINTS: • Deep learning can perform accurate fully automated segmentation of lumbar vertebral body in CT images. • The average BMDs obtained by deep learning highly correlates with ones derived from QCT. • The deep learning-based method could be helpful for clinicians in opportunistic osteoporosis screening in spinal or abdominal CT scans.
引用
- Fang Y, Li W, Chen X, et al. Opportunistic osteoporosis screening in multi-detector CT images using deep convolutional neural networks. Eur Radiol. 2020. PMID: 33001308. doi:10.1007/s00330-020-07312-8
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。