文献速递介入外周血管泌尿生殖CTDSA

术前CT血管成像预测前列腺动脉栓塞技术结局的因素

Predictors of technical outcome for prostatic artery embolisation using pre-procedural CT angiography.
PubMed 文献 · Eur Radiol · 2020-09-09

该回顾性研究纳入75例连续接受前列腺动脉栓塞(PAE)的患者,从术前计划性CT血管成像(CTA)客观测量主动脉粥样硬化、前列腺动脉直径、前列腺体积等变量,并与透视时间、空气比释动能、剂量面积乘积、锥形束CT次数及双侧栓塞可行性进行相关分析。结果显示主动脉粥样硬化严重程度显著增加透视时间(p=0.004),较小前列腺动脉(p=0.009)和较小术前前列腺体积(p=0.038)与更高空气比释动能相关,较小前列腺动脉尺寸(p=0.007)增加单侧栓塞或技术失败的可能性。作者认为血管钙化、前列腺动脉直径和前列腺体积可能是权衡PAE风险/获益时的重要因素。

要点

  • 主动脉粥样硬化越重,PAE透视时间越长(p=0.004)。
  • 前列腺动脉越小,空气比释动能越高(p=0.009),单侧栓塞或技术失败可能性越大(p=0.007)。
  • 术前前列腺体积越小,空气比释动能越高(p=0.038)。

核心结论

  • 术前预测PAE技术结局指标仍具挑战性,但血管钙化、前列腺动脉直径和前列腺体积可能是考虑PAE风险/获益时的重要因素。

研究设计与样本

  • 回顾性收集75例连续接受PAE患者的数据。
  • 从计划性CT血管成像(CTA)识别并客观测量多个患者预测变量。
  • 将术中导航血管角度、前列腺体积、前列腺动脉直径、前列腺动脉起源、主动脉粥样硬化、髂动脉迂曲度和基线人口学特征与结局变量(透视时间、空气比释动能、剂量面积乘积、锥形束CT次数及是否可行双侧栓塞)进行相关分析。
  • 数据分析采用线性回归、方差分析、t检验和卡方检验。

诊断标准与关键数值

  • 主动脉粥样硬化严重程度显著增加透视时间(p=0.004)。
  • 较小前列腺动脉患者空气比释动能显著更高(p=0.009)。
  • 较小术前前列腺体积患者空气比释动能显著更高(p=0.038)。
  • 较小前列腺动脉尺寸增加单侧栓塞或技术失败的可能性(p=0.007)。
  • 血管迂曲度增加和前列腺动脉起源未显示对透视时间或剂量面积乘积有显著影响。

临床应用与阅片要点

  • 阅片时可参考术前CTA评估的主动脉粥样硬化严重程度、前列腺动脉直径和前列腺体积,这些因素可能与PAE术中剂量及技术成功相关。
  • 作者认为血管钙化、前列腺动脉直径和前列腺体积可能是考虑PAE风险/获益时的重要因素。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

OBJECTIVES: Predicting patients that will pose procedural technical challenges in prostate artery embolisation (PAE) remains difficult, with prolonged procedural times impacting on both patient dose and resource planning. Understanding the factors that influence these parameters as well as the likelihood of technical success is therefore important in effective patient selection and procedural planning.

METHODS: Data were collected retrospectively for 75 consecutive patients who underwent PAE. Multiple patient predictor variables available from planning computed tomography angiography (CTA) were identified and measured objectively. The vessel angles navigated during the procedure, prostate volume, prostate artery (PA) diameter, PA origin, aortic atheroma, iliac tortuosity and baseline demographics were correlated with outcome variables (fluoroscopy time, air kerma (AK), dose area product (DAP), the number of cone beam CTs (CBCTs)) performed and whether bilateral embolisation was possible (technical success). Data were analysed using linear regression, ANOVA, t tests and chi-squared tests.

RESULTS: Aortic atheroma severity significantly increased fluoroscopy time (p = 0.004), whilst air kerma (AK) was significantly greater in patients with smaller prostatic arteries (p = 0.009) and smaller pre-procedural prostate volumes (p = 0.038). Increased vascular tortuosity and prostatic artery origin were not shown to significantly affect fluoroscopy time or DAP. Smaller prostate artery size (p = 0.007) also increases the likelihood of either unilateral embolisation or technical failure.

CONCLUSIONS: Pre-operative prediction of technical outcome measures in PAE remains challenging. However, vascular calcification, prostatic artery diameter and prostate volume are likely to be important factors when considering the risk/benefits of PAE.

KEY POINTS: • Increased severity of atheroma and the presence of small prostate arteries increase fluoroscopy time and AK respectively during prostate artery embolisation. • Lower pre-procedural prostate volume increases the AK during procedures. • Smaller prostate artery size increases the likelihood of either unilateral embolisation or technical failure.

来源:Eur Radiol,查看原文。版权归原作者所有。

引用

  1. Lintin L, Barge T, Boardman P, et al. Predictors of technical outcome for prostatic artery embolisation using pre-procedural CT angiography. Eur Radiol. 2020. PMID: 32909056. doi:10.1007/s00330-020-07244-3

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。