使用蒙特卡罗程序计算骨盆X线摄影的剂量面积乘积-有效剂量转换系数
该研究对25例骨盆骨折患者的五体位骨盆X线系列片进行回顾性记录分析,用基于PC的蒙特卡罗程序结合按身高体重调整的人体模体模拟ICRP第103号出版物给出的有效剂量,回归得出各体位及整体的剂量面积乘积-有效剂量转换系数。结果显示有效剂量与剂量面积乘积强相关(整体R²=0.95,平均转换系数0.0125 mSv/dGy·cm²),各体位转换系数为0.0101–0.0143 mSv/dGy·cm²(R²均≥0.94),作者认为这些系数可用于可靠估算有效剂量并确认骨盆创伤管理中的协议设计变更。
要点
- 五体位骨盆X线系列整体DAP/E转换系数为0.0125 mSv/dGy·cm²,R²=0.95。
- 正位、入口位、出口位、Judet左斜位、Judet右斜位转换系数分别为0.0133、0.0110、0.0143、0.0113、0.0101 mSv/dGy·cm²。
- 有效剂量与DAP强相关且独立于体重指数,各体位R²均≥0.94。
核心结论
- 作者提供了五体位骨盆X线系列的DAP/E转换系数,用于可靠估算有效剂量;测量累积有效剂量可能有助于确认骨盆创伤管理中的协议设计变更。
研究设计与样本
- 回顾性记录回顾,纳入1家一级创伤中心的25例骨盆骨折并需五体位骨盆X线系列检查的患者。
- 使用基于PC的蒙特卡罗程序结合按患者身高和体重调整的人体模体,模拟ICRP第103号出版物给出的有效剂量值。
- 输入参数包括管电压(kV)、管过滤(毫米铝)、阳极角度、X线束准直、几何距离和各体位投照角度,生成入射多色X线能谱并与各体位DAP值匹配后进行回归分析。
诊断标准与关键数值
- 整体平均DAP/E转换系数为0.0125 mSv/dGy·cm²(R²=0.95)。
- 正位、入口位、出口位、Judet左斜位、Judet右斜位转换系数分别为0.0133、0.0110、0.0143、0.0113、0.0101 mSv/dGy·cm²,各体位R²均≥0.94。
临床应用与阅片要点
- 作者提供的五体位骨盆X线系列DAP/E转换系数可用于可靠估算有效剂量。
- 作者认为测量累积有效剂量可能有助于确认骨盆创伤管理中的协议设计变更。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVE. The purpose of this study was to determine dose-area product-to-effective dose (DAP/E) conversion coefficients for a five-view pelvic radiograph series. DAP/E conversion coefficients may be used for radiation dose optimization when designing institutional protocols for pelvic trauma evaluation. MATERIALS AND METHODS. We conducted a retrospective record review of 25 patients at a level 1 trauma center who had sustained pelvic fractures and required a five-view pelvic radiograph series during workup. E values given in International Commission on Radiological Protection Publication 103 were simulated with a PC-based Monte Carlo program in conjunction with anthropomorphic phantoms adjusted on the basis of patient height and weight. Inputs included tube voltage (in kV), tube filtration (in millimeters of aluminum), anode angle, x-ray beam collimation, geometric distances, and angle of projection for each radiograph in the series. An incident polychromatic x-ray spectrum was generated and matched to the corresponding DAP values of each radiograph, and regression analysis was performed for the DAP/E conversion coefficients. RESULTS.E was strongly correlated with DAP independent from body mass index, with a mean global DAP/E conversion coefficient of 0.0125 mSv/dGy · cm2 for all radiographs (R2 = 0.95). Mean DAP/E conversion coefficients were 0.0133, 0.0110, 0.0143, 0.0113, and 0.0101 mSv/dGy · cm2 for anteroposterior, inlet, outlet, Judet left, and Judet right views, respectively (all R2 ≥ 0.94). CONCLUSION. DAP/E conversion coefficients are provided for a five-view pelvic radiograph series to allow reliable estimation of E. Measurement of cumulative E may affirm protocol design changes for the management of pelvic trauma.
引用
- Chen DS, Escobedo EM, Eastman JG, et al. Dose-Area Product-to-Effective Dose Conversion Coefficients for Pelvic Radiography Using a Monte Carlo Program. AJR Am J Roentgenol. 2020. PMID: 32755183. doi:10.2214/AJR.19.22013
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。