文献速递外周血管心血管CT

结合CT的容积与壁面剪切应力分析评估腹主动脉瘤进展风险

Combining Volumetric and Wall Shear Stress Analysis from CT to Assess Risk of Abdominal Aortic Aneurysm Progression.
PubMed 文献 · Radiology · 2020-03-31

本研究为多中心前瞻性注册研究(NCT01599533)的一部分,纳入126例腹主动脉瘤患者,按动脉瘤体积增加≤10 mL或>10 mL分为稳定组与进展组,分析基线最大直径、管腔容积及壁面剪切应力(WSS)等参数。推导队列中进展组管腔容积更高、WSS更低,联合管腔容积与WSS的回归模型预测动脉瘤增大的AUC为0.78,优于最大直径的0.52(P=0.003),在直径小于50 mm的动脉瘤中同样更优(AUC 0.79 vs 0.53,P=0.01);验证队列中两者无差异(AUC 0.79 vs 0.71,P=0.51)。

要点

  • 进展组基线管腔容积高于稳定组、WSS低于稳定组,二者均与总体积增长相关。
  • 推导队列中联合管腔容积与WSS的模型预测动脉瘤增大优于最大直径(AUC 0.78 vs 0.52)。
  • 直径小于50 mm的动脉瘤中联合模型仍优于最大直径(AUC 0.79 vs 0.53)。

核心结论

  • 联合分析管腔容积与壁面剪切应力与腹主动脉瘤1年时增大相关,尤其在直径小于50 mm的动脉瘤中。

研究设计与样本

  • 研究为多中心前瞻性注册研究(NCT01599533)的一部分,共纳入126例腹主动脉瘤患者。
  • 按动脉瘤体积增加≤10 mL为稳定组、>10 mL为进展组进行分组。
  • 最终纳入分析81例(平均年龄73岁±7岁,78例男性),推导队列50例、验证队列31例。
  • 分析基线最大直径与表面积、血栓与管腔容积、最大壁压及壁面剪切应力(WSS)等参数。

诊断标准与关键数值

  • 进展组与稳定组相比,平均管腔容积为60 mL±14 vs 46 mL±18(P=0.005),平均WSS为66%±6 vs 53%±9(P=0.02)。
  • 基线平均管腔容积与总体积增长相关(r=0.47,P=0.002),基线平均WSS与总体积增长相关(r=-0.42,P=0.006)。
  • 推导队列中联合管腔容积与WSS的回归模型预测动脉瘤增大的AUC为0.78,最大直径单独为0.52(P=0.003)。
  • 验证队列中联合模型AUC为0.79,最大直径为0.71(P=0.51),两者无差异。
  • 直径小于50 mm的动脉瘤中,联合基线WSS与管腔容积的模型AUC为0.79,最大直径为0.53(P=0.01)。

临床应用与阅片要点

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

Background Despite known limitations, the decision to operate on abdominal aortic aneurysm (AAA) is primarily on the basis of measurement of maximal aneurysm diameter. Purpose To identify volumetric and computational fluid dynamics parameters to predict AAAs that are likely to progress in size. Materials and Methods This study, part of a multicenter prospective registry (NCT01599533), included 126 patients with AAA. Patients were sorted into stable (≤10-mL increase in aneurysm volume) and progression (>10-mL increase in aneurysm volume) groups. Initial AAA characteristics of the derivation cohort were analyzed (maximal diameter and surface, thrombus and lumen volumes, maximal wall pressure, and wall shear stress [WSS]) to identify relevant parameters for a logistic regression model. Model and maximal diameter diagnostic performances were assessed in both cohorts and for AAAs smaller than 50 mm by using area under the receiver operating characteristic curve (AUC). Results Eighty-one patients were included (mean age, 73 years ± 7 years [standard deviation]; 78 men). The derivation and validation cohorts included, respectively, 50 and 31 participants. In the derivation cohort, there was higher mean lumen volume and lower mean WSS in the progression group compared with the stable group (60 mL ± 14 vs 46 mL ± 18 [P = .005] and 66% ± 6 vs 53% ± 9 [P = .02], respectively). Mean lumen volume and mean WSS at baseline were correlated to total volume growth (r = 0.47 [P = .002] and -0.42 [P = .006], respectively). In the derivation cohort, a regression model including lumen volume and WSS to predict aneurysm enlargement was superior to maximal diameter alone (AUC, 0.78 vs 0.52, respectively; P = .003); although no difference was found in the validation cohort (AUC, 0.79 vs 0.71, respectively; P = .51). For AAAs smaller than 50 mm, a regression model that included both baseline WSS and lumen volume performed better than maximal diameter (AUC, 0.79 vs 0.53, respectively; P = .01). Conclusion Combined analysis of lumen volume and wall shear stress was associated with enlargement of abdominal aortic aneurysms at 1 year, particularly in aneurysms smaller than 50 mm in diameter. © RSNA, 2020 Online supplemental material is available for this article. See also the editorial by Mitsouras and Leach in this issue.

来源:Radiology,查看原文。版权归原作者所有。

引用

  1. Meyrignac O, Bal L, Zadro C, et al. Combining Volumetric and Wall Shear Stress Analysis from CT to Assess Risk of Abdominal Aortic Aneurysm Progression. Radiology. 2020. PMID: 32228297. doi:10.1148/radiol.2020192112

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。