常染色体显性多囊肾病肾脏体积CT评估:准确性、可重复性与辐射剂量
前瞻性研究纳入30例ADPKD成人,比较低剂量与超低剂量CT及三种体积测量方程与MRI手工描画金标准的准确性、可重复性和辐射剂量;所有方法与金标准相关性极好(r²>0.98),超低剂量CT联合基于离散线性测量的体积方程可获得与MRI手工描画相当的准确且可重复的肾脏总体积测量。
要点
- 超低剂量CT联合基于离散线性测量的体积方程,可获得与MRI手工描画金标准相当的肾脏总体积测量。
- 所有成像方式与测量方程同金标准相关性极好(r²>0.98),组内相关系数均>0.98。
- 椭球法测量时间平均4.6–5.2分钟,明显短于手工描画的平均27.7分钟。
核心结论
- 采用剂量最小化的超低剂量CT方案联合基于离散线性测量的体积测量,可获得与MRI手工描画金标准相当的准确且可重复的肾脏总体积测量。
研究设计与样本
- 前瞻性研究,2016年9月至2017年6月纳入30例成人ADPKD患者,平均年龄41岁(范围24–67岁)。
- 每例接受一次MRI和两次CT检查;低剂量与超低剂量CT的辐射剂量分别比作者所在机构的标准腹盆CT低1.4倍和2.6倍。
- 超低剂量CT采用基于模型的迭代重建;三种肾脏总体积测量方程应用于所有图像集;以MRI手工描画为参考标准。
诊断标准与关键数值
- 所有成像方式与测量方程同参考标准的相关性均极好(r²>0.98)。
- 均方根误差为80.5–157.3 mL,相当于平均肾脏总体积的5.9%–11.5%。
- 所有方法的组内相关系数均>0.98。
- 超低剂量与低剂量CT的中位剂量长度乘积分别为58.8与115.5 mGy·cm(P=.01),CT剂量指数分别为1.2与3.9 mGy(P<.001)。
- 椭球法平均测量时间为4.6–5.2分钟,手工描画平均为27.7分钟(范围14–60分钟)。
临床应用与阅片要点
- 超低剂量CT联合基于离散线性测量的体积方程,可获得与MRI手工描画金标准相当的肾脏总体积测量。
- 椭球法测量时间平均4.6–5.2分钟,明显短于手工描画的平均27.7分钟。
局限性
- 原文未报告局限性
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Background Total kidney volume (TKV) assessment is valuable in autosomal dominant polycystic kidney disease (ADPKD) but the reference standard method of MRI planimetry requires access to MRI and time-consuming interpretation. Purpose To determine whether accurate TKV measurements comparable to the resource-intensive reference standard of MRI planimetry can be obtained by using alternate methods including dose-reducing CT protocols and time-saving measurement equations. Materials and Methods In this prospective study conducted September 2016 to June 2017, adult participants with ADPKD underwent one MRI and two CT examinations. Low-dose (LD) and ultra-low-dose (ULD) CT examinations were performed with radiation doses 1.4 and 2.6 times lower, respectively, than the authors' institution's standard abdomen and pelvis CT. ULD CT examinations were reconstructed via model-based iterative reconstruction. Three TKV measurement equations were applied to all image sets, and MRI manual planimetry was the reference standard. Spearman correlation with the reference standard, simple linear regression, and root mean square error (RMSE) calculation analyzed accuracy of these methods; intraclass correlation coefficient examined reproducibility. Results Thirty participants (mean age, 41 years; age range, 24-67 years) had a mean TKV of 1368.9 mL ± 1146.13 (standard deviation). The ULD and LD CT protocols had median dose-length product of 58.8 and 115.5 mGy ∙ cm, respectively (P = .01), and CT dose index of 1.2 and 3.9 mGy, respectively (P < .001). All imaging modalities and measurement equations had excellent correlation with the reference standard (r2 > 0.98). RMSE ranged from 80.5 to 157.3 mL (5.9%-11.5% of mean TKV). Intraclass correlation coefficients were greater than 0.98 for all methods. Mean measurement times for the ellipsoid method ranged from 4.6 to 5.2 minutes compared with a mean of 27.7 minutes (range, 14-60 minutes) for manual planimetry. Conclusion Accurate and reproducible total kidney volume measurements comparable to the reference standard of MRI planimetry can be obtained by using a dose-minimizing ultra-low-dose CT protocol and volume measurement based on discrete linear measurements. © RSNA, 2019 Online supplemental material is available for this article.
引用
- Bevilacqua MU, Hague CJ, Romann A, et al. CT of Kidney Volume in Autosomal Dominant Polycystic Kidney Disease: Accuracy, Reproducibility, and Radiation Dose. Radiology. 2019. PMID: 30964424. doi:10.1148/radiol.2019181830
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。