文献速递神经介入DSA

基于常规二维测量与Sim&Size软件虚拟模拟的Pipeline栓塞装置尺寸选择比较:一项一致性研究

Comparison of Pipeline Embolization Device Sizing Based on Conventional 2D Measurements and Virtual Simulation Using the Sim&Size Software: An Agreement Study.
PubMed 文献 · AJNR Am J Neuroradiol · 2019-02-07

这项多中心研究纳入74例接受Pipeline栓塞装置治疗的动脉瘤患者,比较神经介入医师基于旋转血管造影二维测量手动确定的装置尺寸与Sim&Size专家盲法计算的最佳尺寸。手动选择与计算最佳尺寸之间的一致性低(直径κ=0.219,长度κ=0.149,P<.01),计算的最佳装置长度显著更短(中位数14 vs 16 mm,P<.01),直径无显著差异。作者认为低一致性本身不能证明虚拟模拟优于手动选择,但反映尺寸选择过程有优化潜力,使用Sim&Size软件尤其可缩短装置长度,尚需进一步评估装置尺寸改变对结局的影响。

要点

  • 手动选择与Sim&Size计算的最佳装置尺寸一致性低:直径κ=0.219,长度κ=0.149(P<.01)。
  • 计算的最佳装置长度显著短于手动选择(中位数14 vs 16 mm,P<.01),直径无显著差异。
  • 作者指出低一致性本身不能证明虚拟模拟优于手动选择,尚需进一步评估尺寸改变对结局的影响。

核心结论

  • 手动确定的装置尺寸与Sim&Size计算的最佳尺寸一致性低,计算长度显著更短;低一致性本身不能证明虚拟模拟优于手动选择,但反映尺寸选择过程有优化潜力,使用Sim&Size软件尤其可缩短装置长度,尚需进一步评估装置尺寸改变对结局的影响。

研究设计与样本

  • 多中心队列研究,纳入74例接受Pipeline栓塞装置治疗的动脉瘤患者,比较神经介入医师基于旋转血管造影二维测量手动确定的明显最佳尺寸与Sim&Size专家盲法计算的最佳尺寸;一致性用Cohen κ评估,差异用Wilcoxon符号秩检验分析。

诊断标准与关键数值

  • 手动选择与计算最佳尺寸的一致性指数低:直径κ=0.219,长度κ=0.149(P<.01)。
  • 计算的最佳装置长度显著短于手动选择:中位数14 vs 16 mm(T=402,r=-0.28,P<.01)。
  • 装置直径在手动选择与计算最佳尺寸之间无显著差异。

临床应用与阅片要点

  • 作者认为低一致性反映装置尺寸选择过程有优化潜力,使用Sim&Size软件尤其可缩短装置长度。
  • 作者指出低一致性本身不能证明虚拟模拟优于手动选择,尚需进一步评估装置尺寸改变对结局的影响。

局限性

  • 作者指出低一致性本身不能证明虚拟模拟优于手动选择。
  • 作者指出尚需进一步评估以明确装置尺寸改变对结局的影响。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

BACKGROUND AND PURPOSE: The Sim&Size software simulates case-specific intraluminal Pipeline Embolization Device behavior, wall apposition, and device length in real-time on the basis of rotational angiography DICOM data. The purpose of this multicenter study was to evaluate whether preimplantation device simulation with the Sim&Size software results in selection of different device dimensions than manual sizing.

MATERIALS AND METHODS: In a multicenter cohort of 74 patients undergoing aneurysm treatment with the Pipeline Embolization Device, we compared apparent optimal device dimensions determined by neurointerventionalists with considerable Pipeline Embolization Device experience based on manual 2D measurements taken from rotational angiography with computed optimal dimensions determined by Sim&Size experts blinded to the neurointerventionalists' decision. Agreement between manually determined and computed optimal dimensions was evaluated with the Cohen κ. The significance of the difference was analyzed with the Wilcoxon signed rank test.

RESULTS: The agreement index between manual selection and computed optimal dimensions was low (κ for diameter = 0.219; κ for length = 0.149, P < .01). Computed optimal device lengths were significantly shorter (median, 14 versus 16 mm, T = 402, r = -0.28, P < .01). No significant difference was observed for device diameters.

CONCLUSIONS: Low agreement between manually determined and computed optimal device dimensions is not proof, per se, that virtual simulation performs better than manual selection. Nevertheless, it ultimately reflects the potential for optimization of the device-sizing process, and use of the Sim&Size software reduces, in particular, device length. Nevertheless, further evaluation is required to clarify the impact of device-dimension modifications on outcome.

来源:AJNR Am J Neuroradiol,查看原文。版权归原作者所有。

引用

  1. Ospel JM, Gascou G, Costalat V, et al. Comparison of Pipeline Embolization Device Sizing Based on Conventional 2D Measurements and Virtual Simulation Using the Sim&Size Software: An Agreement Study. AJNR Am J Neuroradiol. 2019. PMID: 30733254. doi:10.3174/ajnr.A5973

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。