文献速递心血管胸部外周血管MR

右心室三维面积应变评估球囊肺动脉成形术治疗慢性血栓栓塞性肺动脉高压疗效的临床价值:与二维特征追踪MRI的比较

Clinical usefulness of right ventricular 3D area strain in the assessment of treatment effects of balloon pulmonary angioplasty in chronic thromboembolic pulmonary hypertension: comparison with 2D feature-tracking MRI.
PubMed 文献 · Eur Radiol · 2019-02-21

回顾性分析21例接受球囊肺动脉成形术的慢性血栓栓塞性肺动脉高压患者,比较术前术后右心室三维面积应变与二维特征追踪MRI应变。ROC分析显示面积应变识别平均肺动脉压<30 mmHg和右心室射血分数>50%的AUC分别为0.75和0.81,可能比二维应变更有用。

要点

  • 面积应变识别术后平均肺动脉压<30 mmHg的AUC为0.75,与径向应变相同。
  • 面积应变识别术后右心室射血分数>50%的AUC为0.81,高于纵向、圆周和径向应变。
  • 面积应变分析的可重复性与二维应变分析相当。

核心结论

  • 通过心脏MRI的面积应变分析可能是评估慢性血栓栓塞性肺动脉高压患者球囊肺动脉成形术疗效的比二维特征追踪MRI应变更有用的工具。

研究设计与样本

  • 回顾性分析21例接受球囊肺动脉成形术的慢性血栓栓塞性肺动脉高压患者,术前术后测量右心室整体面积应变、纵向应变、圆周应变和径向应变。

诊断标准与关键数值

  • 识别平均肺动脉压<30 mmHg患者的最佳截断值:整体面积应变-41.2%、纵向应变-13.8%、圆周应变-16.7%、径向应变14.4%,AUC分别为0.75、0.56、0.65、0.75。识别右心室射血分数>50%患者的最佳截断值:整体面积应变-37.2%、纵向应变-29.5%、圆周应变-2.9%、径向应变14.4%,AUC分别为0.81、0.60、0.56、0.56。

临床应用与阅片要点

  • 作者认为面积应变分析可能比二维特征追踪MRI应变更有助于评估球囊肺动脉成形术的治疗效果,且可重复性与二维应变分析相当。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

OBJECTIVES: To evaluate the usefulness of right ventricular (RV) area strain analysis via cardiac MRI (CMRI) as a tool for assessing the treatment effects of balloon pulmonary angioplasty (BPA) in inoperable chronic thromboembolic pulmonary hypertension (CTEPH), RV area strain was compared to two-dimensional (2D) strain with feature-tracking MRI (FTMRI) before and after BPA.

METHODS: We retrospectively analyzed 21 CTEPH patients who underwent BPA. End-systolic global area strain (GAS), longitudinal strain (LS), circumferential strain (CS), and radial strain (RS) were measured before and after BPA. Changes in GAS and RV ejection fraction (RVEF) values after BPA were defined as ΔGAS and ΔRVEF. Receiver operating characteristic (ROC) analyses were performed to determine the optimal cutoff of the strain at after BPA for detection of improved patients with decreased mean pulmonary artery pressure (mPAP) less than 30 mmHg and increased RVEF more than 50%.

RESULTS: ROC analysis revealed the optimal cutoffs of strains (GAS, LS, CS, and RS) for identifying improved patients with mPAP < 30 mmHg (cutoff (%) = - 41.2, - 13.8, - 16.7, and 14.4: area under the curve, 0.75, 0.56, 0.65, and 0.75) and patients with RVEF > 50% (cutoff (%) = - 37.2, - 29.5, - 2.9, and 14.4: area under the curve, 0.81, 0.60, 0.56, and 0.56).

CONCLUSIONS: Area strain analysis via CMRI may be a more useful tool for assessing the treatment effects of BPA in patients with CTEPH than 2D strains with FTMRI.

KEY POINTS: • Area strain values can detect improvement of right ventricular (RV) pressure and function after balloon pulmonary angioplasty (BPA) equally or more accurately than two-dimensional strains. • Area strain analysis is a useful analytical method that reflects improvements in complex RV myocardial deformation by BPA. • Area strain analysis is a robust method with reproducibility equivalent to that of 2D strain analysis.

来源:Eur Radiol,查看原文。版权归原作者所有。

引用

  1. Kawakubo M, Yamasaki Y, Kamitani T, et al. Clinical usefulness of right ventricular 3D area strain in the assessment of treatment effects of balloon pulmonary angioplasty in chronic thromboembolic pulmonary hypertension: comparison with 2D feature-tracking MRI. Eur Radiol. 2019. PMID: 30790024. doi:10.1007/s00330-019-6008-3

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。