匹配与均一化计算机断层扫描定量研究中的卷积核
该研究用GE、Philips、Siemens和Toshiba扫描仪对放射组学纹理体模成像,重建时改变卷积核从平滑到锐利,提取38个放射组学特征。Philips C、Siemens B30f和Toshiba FC24核产生的特征值与GE Standard最相似;核均一化滤波器可将中位差异降至患者群体变异系数以下(GE Edge和Toshiba核除外)。
要点
- Philips C、Siemens B30f和Toshiba FC24核的特征值与GE Standard最相似
- 核均一化滤波器可降低核相关特征差异,但GE Edge和Toshiba核除外
- 前瞻性放射组学研究应在扫描协议中指定已证明产生相似特征值的核
核心结论
- Philips C、Siemens B30f和Toshiba FC24核产生的特征值与GE Standard最相似。
- 核均一化滤波器将GE、Philips和Siemens所有核(GE Edge和Toshiba核除外)的中位差异降至患者群体中小于1个变异系数。
- 前瞻性CT放射组学研究应指定产生相似特征值的核;回顾性研究可设计应用核均一化滤波器减少核相关差异。
研究设计与样本
- 研究使用GE、Philips、Siemens和Toshiba扫描仪对放射组学纹理体模成像。
- 体模包含10个不同纹理的 cartridge,图像多次重建,核从平滑到锐利变化。
- 采用半自动方法为每个cartridge和所有扫描生成8×2×2 cm感兴趣区。
- 从每个感兴趣区提取38个放射组学特征:强度直接12个、灰度共生矩阵21个、邻域灰度差矩阵5个。
- 以GE Standard为基线核计算特征分数差异,并用非小细胞肺癌患者队列中同一特征的变异系数缩放。
诊断标准与关键数值
- Philips C、Siemens B30f和Toshiba FC24核产生的特征值与GE Standard最相似。
- 核均一化滤波器使GE、Philips和Siemens所有核(GE Edge和Toshiba核除外)的中位差异降至患者群体中小于1个变异系数。
临床应用与阅片要点
- 前瞻性CT放射组学研究的扫描协议应指定已证明产生相似特征值的核。
- 回顾性研究可设计并应用核均一化滤波器以减少核相关特征值差异。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
The sharpness of the kernels used for image reconstruction in computed tomography affects the values of the quantitative image features. We sought to identify the kernels that produce similar feature values to enable a more effective comparison of images produced using scanners from different manufactures. We also investigated a new image filter designed to change the kernel-related component of the frequency spectrum of a postreconstruction image from that of the initial kernel to that of a preferred kernel. A radiomics texture phantom was imaged using scanners from GE, Philips, Siemens, and Toshiba. Images were reconstructed multiple times, varying the kernel from smooth to sharp. The phantom comprised 10 cartridges of various textures. A semiautomated method was used to produce 8 × 2 × 2 cm regions of interest for each cartridge and for all scans. For each region of interest, 38 radiomics features from the categories intensity direct (n = 12), gray-level co-occurrence matrix (n = 21), and neighborhood gray-tone difference matrix (n = 5) were extracted. We then calculated the fractional differences of the features from those of the baseline kernel (GE Standard). To gauge the importance of the differences, we scaled them by the coefficient of variation of the same feature from a cohort of patients with non-small cell lung cancer. The noise power spectra for each kernel were estimated from the phantom's solid acrylic cartridge, and kernel-homogenization filters were developed from these estimates. The Philips C, Siemens B30f, and Toshiba FC24 kernels produced feature values most similar to GE Standard. The kernel homogenization filters reduced the median differences from baseline to less than 1 coefficient of variation in the patient population for all of the GE, Philips, and Siemens kernels except for GE Edge and Toshiba kernels. For prospective computed tomographic radiomics studies, the scanning protocol should specify kernels that have been shown to produce similar feature values. For retrospective studies, kernel homogenization filters can be designed and applied to reduce the kernel-related differences in the feature values.
引用
- Mackin D, Ger R, Gay S, et al. Matching and Homogenizing Convolution Kernels for Quantitative Studies in Computed Tomography. Invest Radiol. 2019. PMID: 30570504. doi:10.1097/RLI.0000000000000540
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。