肩关节后关节囊皱襞的MR关节造影特征
回顾性分析2010年4月至2018年1月604例肩关节MR图像及MR关节造影,其中35例(5.8%)见后滑膜皱襞,最常见为三角形(17/35,48.6%),常规MRI上后盂唇关节囊复合体最常见为后盂唇重影(15/35,42.9%)。后滑膜皱襞与后盂唇最短距离在关节镜阳性组显著大于阴性组(p=0.047)。后滑膜皱襞为正常关节囊解剖变异,某些类型在常规MRI上可模仿后盂唇撕裂。
要点
- MR关节造影上后滑膜皱襞少见,最常见呈三角形(17/35,48.6%),多位于后上和后下部分。
- 常规MRI上后盂唇关节囊复合体最常见形态为后盂唇重影(15/35,42.9%),可模仿后盂唇撕裂。
- 后滑膜皱襞与后盂唇最短距离在关节镜阳性组显著大于阴性组(p=0.047)。
核心结论
- 后滑膜皱襞是正常关节囊解剖变异,在MR关节造影上少见,倾向位于后关节囊后上和后下部分,某些类型在常规MRI上可模仿后盂唇撕裂。
研究设计与样本
- 回顾性研究,纳入2010年4月至2018年1月604例连续肩关节MR图像和MR关节造影,以关节镜为参考标准(35例中8例经关节镜证实)。
关键影像表现/征象
- MR关节造影上后滑膜皱襞最常见类型为三角形,35例中17例(48.6%)。
- 常规MRI上后盂唇关节囊复合体最常见形态为后盂唇重影,35例中15例(42.9%)。
- 后滑膜皱襞最常见位于后盂唇关节囊结构的后上和后下部分。
- 17%经MR关节造影诊断后滑膜皱襞的患者常规MRI表现正常。
诊断标准与关键数值
- 后滑膜皱襞与后盂唇最短距离均值在关节镜阳性组显著高于关节镜阴性组(p=0.047)。
临床应用与阅片要点
- 在MR关节造影上识别后滑膜皱襞时,注意其多位于后上和后下部分,呈正常解剖变异。
- 常规MRI上见后盂唇重影等形态时,需考虑后滑膜皱襞可能,避免误判为后盂唇撕裂;后滑膜皱襞与后盂唇最短距离在关节镜阳性组更大(p=0.047)。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
METHODS:: This was a retrospective study of 604 consecutive shoulder MR images and MR arthrograms obtained from April 2010 to January 2018. Extension in the vertical-oblique plan of the posterior synovial fold on MR arthrography was identified according to the posterosuperior, posteroinferior, superoposterior, and inferoposterior portions. The morphologies of the posterior synovial folds on MR arthrography were divided three subtypes. Morphologic appearances of the posterior labrocapsular complex on conventional MR images were described with four subtypes.
RESULTS:: A posterior synovial fold in the shoulder joint was identified in 35 of 604 (5.8%) MR arthrography patients. 8 of 35 posterior synovial fold identified on MR arthrography were confirmed at arthroscopy. The most common MR arthrographic type of the posterior synovial fold was triangular-this was detected in 17 of 35 (48.6%) patients. The most common MRI morphology of the posterior labrocapsular complex was doubled posterior labrum. This was detected in 15 of 35 (42.9%) patients. 17 % of patients with posterior synovial folds who were diagnosed with MR arthrography had normal MRI features. The most common localization of the posterior synovial fold was posterosuperior and posteroinferior portions of the posterior labrocapsular structures. The mean of the shortest distance between the posterior synovial fold and the posterior labrum was significantly higher in the positive arthroscopic synovial fold group than in the negative arthroscopic synovial fold group (p = 0.047).
CONCLUSION:: Posterior synovial folds, normal capsular anatomic variants, are seen rarely on MR arthrography, and tend to be in the posterosuperior and posteroinferior portions of the posterior capsule. Some types of the posterior synovial fold can mimic a posterior labral tear in conventional MRI.
ADVANCES IN KNOWLEDGE:: On a direct MR arthrographic image, a posterior capsular synovial fold may be a normal anatomic variant. A fold is more commonly occur in the posterosuperior and posteroinferior capsular portions. The results of our study may allow differentiation of normal variations from abnormalities in patients with symptomatic shoulder joint.
引用
- Ogul H, Tuncer K, Kose M, et al. MR arthrographic characterization of posterior capsular folds in shoulder joints. Br J Radiol. 2018. PMID: 30412422. doi:10.1259/bjr.20180527
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。