3特斯拉磁共振成像下正常睾丸的弥散张量成像特性
研究前瞻性纳入16名健康志愿者在3T下行睾丸弥散张量成像,采用24个方向扩散梯度和3个b值(0、100、700 s/mm²)。结果显示正常睾丸弥散较慢、各向异性低(平均FA 0.13±0.05),且低b值排除后弥散仅轻微下降而FA基本不变,提示DTI参数不受组织结构各向异性或微灌注效应主导。
要点
- 正常睾丸在3T DTI上表现为低各向异性,平均FA值为0.13±0.05。
- 以0和700 s/mm²分析时平均λ1为1.36±0.21×10⁻³ mm²/s,弥散相对较慢。
- 改用100和700 s/mm²分析时弥散仅下降4%–5%,FA保持相似。
核心结论
- 正常睾丸弥散相对较慢、接近各向同性,且几乎不受低b值排除的影响,DTI参数既不由 underlying 结构各向异性决定,也不由微灌注效应决定。
研究设计与样本
- 前瞻性研究,纳入16名健康志愿者,在3T磁共振上采集T2加权和DTI序列,DTI使用24个方向扩散梯度和3个b值(0、100、700 s/mm²),并分别以参考b值0或100 s/mm²进行两组数据分析。
关键影像表现/征象
- DTI可生成正常睾丸的扩散矢量图及λ1、λ2、λ3、平均弥散率和FA的参数图。
- 以0和700 s/mm² b值对分析时,睾丸弥散相对较慢,平均λ1为1.36±0.21×10⁻³ mm²/s,各向异性低,平均FA为0.13±0.05。
- 以100和700 s/mm² b值分析时,弥散较0和700 s/mm²分析轻微下降4%–5%,而FA保持相似。
诊断标准与关键数值
- 正常睾丸以0和700 s/mm² b值分析时平均FA为0.13±0.05,平均λ1为1.36±0.21×10⁻³ mm²/s。
- 以100和700 s/mm² b值分析时弥散较0和700 s/mm²分析下降4%–5%,FA保持相似。
临床应用与阅片要点
- 正常睾丸在3T DTI上呈低FA和较慢弥散,阅片时不应将低各向异性误判为异常。
- 低b值(0与100 s/mm²)的取舍对正常睾丸FA影响不大,对弥散值仅有4%–5%的轻微影响。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
RATIONALE AND OBJECTIVES: The testicles are structured in a well-defined microtubular network formation, which is expected to be reflected in high anisotropic diffusivity. However, preliminary studies reported on low values of fractional-anisotropy (FA) in the normal testicles. Our aim was to design and apply a diffusion-tensor imaging (DTI) protocol in order to elucidate the diffusivity properties of the testicles and their determining factors.
MATERIALS AND METHODS: 16 healthy volunteers were prospectively scanned at 3T. The protocol included T2-weighted and DTI sequences, the latter using 24 directional diffusion gradients and 3 b-values (0, 100, and 700 s/mm2) that were separated for analysis based on the reference b-value of 0 or 100 s/mm2. Image processing of the two DTI datasets yielded the diffusion vector maps and parametric maps of their corresponding principal diffusion coefficients λ1, λ2, λ3, mean diffusivity and FA.
RESULTS: The results demonstrated the feasibility of DTI to provide parametric maps of the testicles. The diffusion tensor parameters obtained using the pair of 0 and 700 s/mm2 b-values, exhibited relatively low diffusivity, with mean λ1 values of 1.36 ± 0.21 × 10-3 mm2/s and low anisotropy, with mean FA values of 0.13 ± 0.05. Analysis of DTI using the 100 and 700 s/mm2 b-values yielded a slight decrease in the diffusivity of 4%-5%, whereas FA remained similar.
CONCLUSION: The diffusivity of the normal testicles is relatively slow, closed-to isotropic and hardly affected by the low b-values regime exclusion. Thus, DTI parameters of the normal testicles are neither dictated by the underlying architectural anisotropy nor microperfusion effects.
引用
- Nissan N, Anaby D, Tavor I, et al. The Diffusion Tensor Imaging Properties of the Normal Testicles at 3 Tesla Magnetic Resonance Imaging. Acad Radiol. 2018. PMID: 30322748. doi:10.1016/j.acra.2018.09.019
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。