3D-MRI 与 3D-CT 在股骨髋臼撞击综合征骨性解剖评估中的比较:采用 Dixon 3D FLASH 序列
回顾性比较 17 例(19 髋)疑似股骨髋臼撞击综合征患者的 3D-CT 与 3D-MRI,以 3D-CT 为参考标准。3D-MRI 对凸轮畸形诊断和定位一致率均为 100%(19/19),对前下髂棘变异分型一致率 89.5%(17/19),颈干角与外侧中心边缘角测量一致率均为 64.7%(11/17);使用 3D-MRI 平均每例节省 3.09 mSv 有效剂量,4 年共减少 479 mSv。
要点
- 3D-MRI 对凸轮畸形的诊断和位置判断与 3D-CT 完全一致(19/19,100%)。
- 3D-MRI 对前下髂棘变异分型与 3D-CT 一致率为 89.5%(17/19)。
- 颈干角和外侧中心边缘角测量一致率均为 64.7%(11/17),角度测量需谨慎。
核心结论
- 3D-MRI 可准确诊断和量化股骨髋臼撞击综合征的典型骨性病理改变,并有望免除 3D-CT 检查及其相关辐射暴露和费用。
研究设计与样本
- 回顾性研究,纳入本机构 17 例连续患者(19 髋)疑似股骨髋臼撞击综合征,同一髋均行 3D-CT 和 3D-MRI,由两名接受过专科培训的骨肌放射科医生阅片,以 3D-CT 为参考标准。
关键影像表现/征象
- 3D-CT 上所有 17 例疑似股骨髋臼撞击综合征患者均可见凸轮畸形。
- 3D-CT 显示 3 例 I 型、16 例 II 型前下髂棘变异。
- 3D-MRI 与 3D-CT 对凸轮畸形的诊断一致率为 100%(19/19),位置一致率亦为 100%(19/19)。
- 3D-MRI 与 3D-CT 对前下髂棘变异分型一致率为 89.5%(17/19)。
诊断标准与关键数值
- 以 3D-CT 为参考标准,3D-MRI 诊断凸轮畸形的符合率为 100%(19/19)。
- 3D-MRI 与 3D-CT 对前下髂棘变异分型的符合率为 89.5%(17/19)。
- 3D-MRI 与 3D-CT 测量颈干角的符合率为 64.7%(11/17),测量外侧中心边缘角的符合率亦为 64.7%(11/17)。
临床应用与阅片要点
- 在疑似股骨髋臼撞击综合征的年轻患者中,3D-MRI 可用于评估凸轮畸形及其位置。
- 3D-MRI 可用于前下髂棘变异的分型评估。
- 颈干角和外侧中心边缘角测量在 3D-MRI 与 3D-CT 间一致率均为 64.7%(11/17),原文未就此给出进一步推荐。
- 使用 3D-MRI 平均每例节省 3.09 mSv 有效剂量,4 年共减少 479 mSv。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVE: To determine if hip 3D-MR imaging can be used to accurately demonstrate femoral and acetabular morphology in the evaluation of patients with femoroacetabular impingement.
MATERIALS AND METHODS: We performed a retrospective review at our institution of 17 consecutive patients (19 hips) with suspected femoroacetabular impingement who had both 3D-CT and 3D-MRI performed of the same hip. Two fellowship-trained musculoskeletal radiologists reviewed the imaging for the presence and location of cam deformity, anterior-inferior iliac spine variant, lateral center-edge angle, and neck-shaft angle. Findings on 3D-CT were considered the reference standard. The amount of radiation that was spared following introduction of 3D-MRI was also assessed.
RESULTS: All 17 patients suspected of FAI had evidence for cam deformity on 3D-CT. There was 100% agreement for diagnosis (19 out of 19) and location (19 out of 19) of cam deformity when comparing 3D-MRI with 3D-CT. There were 3 type I and 16 type II anterior-inferior iliac spine variants on 3D-CT imaging with 89.5% (17 out of 19) agreement for the anterior-inferior iliac spine characterization between 3D-MRI and 3D-CT. There was 64.7% agreement when comparing the neck-shaft angle (11 out of 17) and LCEA (11 out of 17) measurements. The use of 3D-MRI spared each patient an average radiation effective dose of 3.09 mSV for a total reduction of 479 mSV over a 4-year period.
CONCLUSION: 3D-MR imaging can be used to accurately diagnose and quantify the typical osseous pathological condition in femoroacetabular impingement and has the potential to eliminate the need for 3D-CT imaging and its associated radiation exposure, and the cost for this predominantly young group of patients.
引用
- Samim M, Eftekhary N, Vigdorchik JM, et al. 3D-MRI versus 3D-CT in the evaluation of osseous anatomy in femoroacetabular impingement using Dixon 3D FLASH sequence. Skeletal Radiol. 2018. PMID: 30182297. doi:10.1007/s00256-018-3049-7
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。