文献速递腹部CT

CT纹理分析评估丙型肝炎病毒感染患者肝纤维化

CT texture analysis of the liver for assessing hepatic fibrosis in patients with hepatitis C virus.
PubMed 文献 · Br J Radiol · 2018-10-11

本研究对556例成人腹部多维CT行肝纹理分析,包括健康对照(F0,n=77)、HCV感染F0期(n=49)及F1-F4期患者,评估CT纹理参数与肝纤维化分期的关系。结果显示平均灰度强度随纤维化增加而升高,联合mean、mpp、偏度和峰度的多变量模型对任何纤维化、显著纤维化和晚期纤维化的AUC分别为0.82、0.82和0.86。作者认为CT纹理特征可能与肝纤维化相关,尤其在晚期分期中有应用价值。

要点

  • 平均灰度强度随肝纤维化分期增加而升高。
  • 联合mean、mpp、偏度和峰度的多变量模型对任何纤维化、显著纤维化和晚期纤维化的AUC分别为0.82、0.82和0.86。
  • 偏度和峰度与肝纤维化呈负相关,在肝硬化患者中最明显。

核心结论

  • CT纹理特征可能与肝纤维化相关,并可用于纤维化分期,尤其在晚期水平。

研究设计与样本

  • 对556例成人(360例男性,196例女性;平均年龄49.8岁)的腹部多维CT行定量纹理分析,包括健康对照组(F0,n=77)、HCV感染F0期患者(n=49)及纤维化递增期患者(F1,n=80;F2,n=99;F3,n=87;F4,n=164)。在门静脉期对全肝、Couinaud IV-VIII段及I-III段行单层感兴趣区测量,纹理参数与IV-VIII段肝纤维化分期进行检验,并与1年内肝活检结果进行相关性分析(适用于所有中间纤维化F0-F3病例)。

诊断标准与关键数值

  • 显著纤维化(≥F2)时,mean的受试者工作特征曲线下面积(AUC)为0.80,阈值0.44时敏感度和特异度分别为74%和75%;晚期纤维化(≥F3)的AUC及敏感度/特异度与显著纤维化相似。联合mean、mpp、偏度和峰度的多变量模型对任何纤维化(F0 vs F1-F4)、显著纤维化(F0-1 vs F2-4)和晚期纤维化(F0-2 vs F3-4)的AUC分别为0.82、0.82和0.86。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

OBJECTIVE: To evaluate CT texture analysis (CTTA) for non-invasively staging of hepatic fibrosis (stages F0-F4) in a cohort of patients with hepatitis C virus (HCV).

METHODS: Quantitative texture analysis of the liver was performed on abdominal multidimensional CT scans. Single slice region of interest measurements of the total liver, Couinaud segments IV-VIII and segments I-III were made. CT texture parameters were tested against stage of hepatic fibrosis in segments IV-VIII on the portal venous phase. Texture parameters were correlated with biopsy performed within 1 year for all cases with intermediate fibrosis (F0-F3).

RESULTS: CT scans of 556 adults (360 males, 196 females; mean age, 49.8 years), including a healthy control group (F0, n = 77) and patients with hepatitis C virus and Stage 0 disease (n = 49), and patients with increasing stages of fibrosis (F1, n = 80; F2 n = 99; F3 n = 87; F4 n = 164) were evaluated. Mean gray level intensity increased with increasing fibrosis. For significant fibrosis (≥F2), mean showed receiver operatingcharacteristic area under the curve (AUC) of 0.80 with sensitivity and specificity of 74 and 75% using a threshold of 0.44, with similar receiver operatingcharacteristic AUC and sensitivity/specificity for advanced fibrosis (≥F3). Skewness and kurtosis were inversely associated with hepatic fibrosis, most prominently in cirrhotic patients. A multivariate model combining these four texture features (mean, mpp, skewness and kurtosis) showed slightly improved performance with AUC of 0.82, 0.82 and 0.86 for any fibrosis (F0 vs F1-F4), significant fibrosis (F0-1 vs F2-4) and advanced fibrosis (F0-2 vs F3-4) respectively.

CONCLUSION: CT texture features may be associated with hepatic fibrosis and have utility in staging fibrosis, particularly at advanced levels.

ADVANCES IN KNOWLEDGE: CTTA may be helpful in detecting and staging hepatic fibrosis, particularly at advanced levels. CT measures like CTTA can be retrospectively evaluated without special equipment.

来源:Br J Radiol,查看原文。版权归原作者所有。

引用

  1. Lubner MG, Jones D, Kloke J, et al. CT texture analysis of the liver for assessing hepatic fibrosis in patients with hepatitis C virus. Br J Radiol. 2018. PMID: 30182750. doi:10.1259/bjr.20180153

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。