薄层液体对表面波速度测量的影响:肺模型研究
Effect of a Thin Fluid Layer on Surface Wave Speed Measurements: A Lung Phantom Study.
PubMed 文献 · J Ultrasound Med · 2018-09-12
该研究利用海绵和薄层超声耦合剂构建肺及胸膜液模型,在3种波激发频率下比较有无薄凝胶层时海绵表面波速度的SWE测量值。结果显示薄凝胶层不影响海绵表面波速度测量。
要点
- 薄层超声耦合剂模拟的胸膜液层不影响肺模型表面波速度SWE测量。
- 该结果为肺表面波弹性成像在少量胸膜液存在时的测量可靠性提供模型依据。
- 临床解读肺表面波速度时,薄层胸膜液可能不构成显著影响。
核心结论
- 在肺模型中,薄层超声耦合剂模拟的胸膜液层不影响表面波速度的SWE测量。
研究设计与样本
- 肺及胸膜液体模研究,用海绵模拟肺、薄层超声透射凝胶模拟胸膜液,在3种波激发频率下比较有无薄凝胶层的海绵表面波速度SWE测量值。
临床应用与阅片要点
- 阅片及解读肺表面波弹性成像时,薄层胸膜液可能不影响表面波速度测量。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Lung ultrasound (US) surface wave elastography (SWE) is a novel technique that measures superficial lung tissue elastic properties. A thin pleural fluid layer covers a lung, but its effect on lung measurements in SWE is unknown. We modeled a lung and pleural fluid with sponges and a thin layer of US transmission gel. Sponge surface wave speeds measured from SWE were compared for sponges without and with the thin US gel layer at 3 wave excitation frequencies. The comparison showed that the sponge surface wave speed measurements were not affected by the thin gel layer.
来源:J Ultrasound Med,查看原文。版权归原作者所有。
引用
- Zhou J, Zhang X. Effect of a Thin Fluid Layer on Surface Wave Speed Measurements: A Lung Phantom Study. J Ultrasound Med. 2018. PMID: 30208217. doi:10.1002/jum.14802
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。