文献速递胸部技术与安全CT

CT采集参数对双层光谱CT碘密度测量的影响

Effect of CT Acquisition Parameters on Iodine Density Measurement at Dual-Layer Spectral CT.
PubMed 文献 · AJR Am J Roentgenol · 2018-08-07

研究将两种含不同碘浓度管(水稀释与10%氨基酸溶液稀释)的纵隔碘模体置入拟人胸部模体,在120/140 kVp、20–200 mAs及光谱重建等级0和6下扫描,用线性混合效应模型分析采集参数对碘密度及相对测量误差的影响;管电压与管电流-时间乘积有统计学显著影响但幅度极小,光谱等级无影响,双层光谱CT碘定量不受采集参数影响。

要点

  • 管电压与管电流-时间乘积对碘密度和相对测量误差有统计学显著影响,但效应幅度极小
  • 光谱重建等级不是碘定量的影响因素(碘密度P=0.647,相对测量误差P=0.813)
  • 双层光谱CT碘定量在不同采集参数下均可行

核心结论

  • 双层光谱CT碘定量不受CT采集参数影响,因为采集参数对碘密度和相对测量误差的影响极小。

研究设计与样本

  • 研究为模体实验,将两个纵隔碘模体(分别含用水和10%氨基酸溶液稀释的对比剂,各含0、1、2.5、5、10、20 mg I/mL六个管)置入拟人胸部模体。
  • 扫描参数包括管电压120和140 kVp、管电流-时间乘积20、40、60、80、100、150、200 mAs、光谱重建等级0和6。
  • 用专用软件测量碘密度(mg I/mL),采用线性混合效应模型分析采集参数对碘密度及其相对测量误差的影响。

诊断标准与关键数值

  • 管电压对碘密度和相对测量误差均有统计学显著影响(均P<0.001);不同管电压设置间碘密度估计差异为0至0.8 mg I/mL,相对测量误差估计差异为1.0%至4.2%。
  • 管电流-时间乘积对碘密度(P<0.05,取决于碘密度的交互项)和相对测量误差(P=0.023)有统计学显著影响;改变100 mAs引起碘密度变化约0.1 mg I/mL、相对测量误差变化约0.6%。
  • 光谱等级对碘密度(P=0.647)和相对测量误差(P=0.813)均无显著影响。

临床应用与阅片要点

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

OBJECTIVE: We aimed to evaluate the effect of tube voltage, tube current-time product, and iterative reconstruction on iodine quantification using a dual-layer spectral CT scanner.

MATERIALS AND METHODS: Two mediastinal iodine phantoms, each containing six tubes of different iodine concentrations (0, 1, 2.5, 5, 10, and 20 mg I/mL; the two phantoms had tubes with contrast media diluted in water and in 10% amino acid solution, respectively), were inserted into an anthropomorphic chest phantom and scanned with varying acquisition parameters (120 and 140 kVp; 20, 40, 60, 80, 100, 150, and 200 mAs; and spectral reconstruction levels 0 and 6). Thereafter, iodine density was measured (in milligrams of iodine per milliliter) using a dedicated software program, and the effect of acquisition parameters on iodine density and on its relative measurement error (RME) was analyzed using a linear mixed-effects model.

RESULTS: Tube voltages (all, p < 0.001) and tube current-time products (p < 0.05, depending on the interaction terms for iodine density; p = 0.023 for RME) had statistically significant effects on iodine density and RME. However, the magnitude of their effects was minimal. That is, estimated differences between tube voltage settings ranged from 0 to 0.8 mg I/mL for iodine density and from 1.0% to 4.2% for RME. For tube current-time product, alteration of 100 mAs caused changes in iodine density and RME of approximately 0.1 mg I/mL and 0.6%, respectively. Spectral level was not an affecting factor for iodine quantification (p = 0.647 for iodine density and 0.813 for RME).

CONCLUSION: Iodine quantification using dual-layer spectral CT was feasible irrespective of CT acquisition parameters because their effects on iodine density and RME were minimal.

来源:AJR Am J Roentgenol,查看原文。版权归原作者所有。

引用

  1. Kim H, Park CM, Kang CK, et al. Effect of CT Acquisition Parameters on Iodine Density Measurement at Dual-Layer Spectral CT. AJR Am J Roentgenol. 2018. PMID: 30085834. doi:10.2214/AJR.17.19381

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。