双层探测器CT:虚拟单能成像减少后路脊柱融合术后金属伪影
本研究纳入20例胸腰椎后路融合术后患者,行120kVp双层探测器CT扫描,由两名独立阅片者比较常规图像与40~200keV虚拟单能图像的质量。结果显示80keV起整体图像质量及各组织评估均显著优于常规图像,180keV为整体图像质量最佳单能设置,不同解剖结构各有最适keV。
要点
- 80keV及以上虚拟单能图像整体质量及各组织评估显著优于常规图像。
- 整体图像质量最佳keV为180keV;植入物所在骨、椎管、椎旁肌、主动脉分别以200、180、160、180keV评估最佳。
- keV升高时伪影最重区HU显著升高,参考区HU无显著变化,SNR与CNR随keV升高而下降。
核心结论
- 高keV虚拟单能图像可显著减少胸腰椎后路融合术后金属伪影,作者推荐针对植入物所在骨、椎管、邻近肌肉或主动脉分别选用专用keV设置,并提出改善整体图像质量的最佳keV。
研究设计与样本
- 研究纳入20例胸腰椎后路脊柱融合术后行120kVp双层探测器CT扫描的患者,两名独立阅片者评估层厚0.9mm的软组织窗与骨窗轴位图像,比较常规图像与40、60、80、100、120、140、160、180、200keV虚拟单能图像。
关键影像表现/征象
- 伪影最重区域的HU随keV升高而显著增加(p < 0.001),含脂肪与肌肉的参考区域HU无显著变化。
- SNR与CNR随虚拟单能图像keV升高而下降。
- 从80keV起,整体图像质量及各组织(植入物所在骨、椎旁肌、椎管、主动脉)评估较常规图像显著改善(p值范围<0.001至0.005)。
诊断标准与关键数值
- 图像质量采用四点Likert量表评估,分别针对整体及植入物所在骨、椎旁肌、椎管、主动脉。
- 整体图像质量最佳单能设置为180keV;植入物所在骨、椎管、椎旁肌、主动脉评估最充分的keV分别为200、180、160、180keV。
- 定性评估的阅片者间一致性高(组内相关系数>0.927;p < 0.05)。
临床应用与阅片要点
- 作者推荐针对植入物所在骨、椎管、邻近肌肉或主动脉等后路脊柱融合术后常关注的结构,分别选用专用keV设置进行评估。
- 作者提出180keV为改善整体图像质量的最佳keV设置。
- 80keV及以上虚拟单能图像的整体及各组织图像质量显著优于常规图像,但SNR与CNR随keV升高而下降。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
INTRODUCTION: To evaluate the clinical potential of dual layer computed tomography (DLCT) for posterior fusions of the thoracic and lumbar spine and determine the optimal keV-settings for an improved overall image quality and effective reduction of metal artefacts affecting the implant inheriting vertebral body, the spinal canal, the paravertebral muscle and aorta.
METHODS AND MATERIALS: Twenty patients with posterior thoracic and lumbar spinal fusion, who underwent a 120kVp- DLCT scan were included in this study. Two independent readers evaluated axial 0.9 mm slides with soft tissue and bone window settings. Image quality of the conventional scan was compared to virtual monoenergetic images (VMI) at 40, 60, 80, 100,120, 140, 160, 180 and 200 keV. Diagnostic image quality was assessed on a four point Likert-scale overall, as well as specifically for the implant inheriting bone, paravertebral muscle, spinal canal or aorta. The Hounsfield Units (HU) of the area with the most pronounced streak artefact as well as HU of a reference area containing fat and muscle were documented for each keV-setting and compared to the conventional image. SNR and CNR were calculated for each of the four anatomic areas. Statistical analysis was conducted for the total collective and separately for the thoracic and lumbar spine level.
RESULTS: Starting from 80 keV qualitative analysis revealed significant improvement of overall image quality and benefit for each tissue separately compared to the conventional images (CI) (p-values in the range from <0.001 to 0.005). 180 keV was considered the optimal monoenergetic setting regarding the overall image quality. For the assessment of the implant inheriting bone, the spinal canal, paravertebral muscle and aorta 200, 180, 160 and 180 keV were rated to be the most sufficient. Our results reveal high inter-reader agreement for qualitative evaluations (intra-class correlation coefficients >0.927; p < 0.05). HU values within the most pronounced streak artefact increased significantly with higher keV (p < 0.001), while there was no significant alteration of HU within the reference area. A decrease in SNR and CNR for higher VMI was revealed by our results.
CONCLUSION: VMIs of higher energies provide significant reduction of metallic artefacts from posterior spinal fusions. Dedicated keV settings to evaluate either the implant inheriting bone, the spinal canal,adjacent muscle or aorta - structures, which are frequently of particular interest after posterior spinal fusion - are recommended. In addition, an optimal keV for an improved overall image quality is proposed.
引用
- Dangelmaier J, Schwaiger BJ, Gersing AS, et al. Dual layer computed tomography: Reduction of metal artefacts from posterior spinal fusion using virtual monoenergetic imaging. Eur J Radiol. 2018. PMID: 30017279. doi:10.1016/j.ejrad.2018.05.034
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。