冠状动脉CT血管成像衍生的血流储备分数:机器学习算法与计算流体动力学建模的比较
本研究为单中心回顾性研究,纳入85例患者,比较基于计算流体动力学(FFRCFD)与基于机器学习算法(FFRML)从冠状动脉CT血管成像(CCTA)数据衍生的血流储备分数(FFR)在检测病灶特异性缺血中的表现,以有创FFR为参考标准。结果显示两种方法诊断效能相当,且均优于CCTA和定量冠状动脉造影(QCA)。FFRML处理时间显著短于FFRCFD。
要点
- FFRML与FFRCFD在检测病灶特异性缺血方面诊断效能相当。
- 两种FFR方法均显著优于CCTA和QCA。
- FFRML处理时间显著短于FFRCFD。
核心结论
- FFRML算法在检测病灶特异性缺血方面与FFRCFD表现相当,两种方法均优于CCTA和QCA对限流性狭窄的检测准确性。
研究设计与样本
- 单中心回顾性研究,纳入85例患者(平均年龄62岁±11岁,62%为男性),均接受CCTA后有创FFR检查;使用FFRCFD和FFRML两种方法从CCTA数据集 onsite 衍生FFR值,以有创FFR为参考标准,并与CCTA视觉狭窄分级和QCA比较。
诊断标准与关键数值
- FFRML检测病灶特异性缺血:每病灶敏感度79%、特异度94%,每患者敏感度90%、特异度95%。
- FFRCFD检测病灶特异性缺血:每病灶敏感度79%、特异度93%,每患者敏感度89%、特异度93%。
- 两种方法敏感度比较P=.86,特异度比较P=.92。
- 每病灶AUC:FFRML 0.89,FFRCFD 0.89,CCTA 0.61,QCA 0.69(均P<.0001)。
- 每患者AUC:FFRML 0.91,FFRCFD 0.91,CCTA 0.65,QCA 0.68(均P<.0001)。
临床应用与阅片要点
- FFRML和FFRCFD均可从CCTA数据衍生FFR,用于检测病灶特异性缺血。
- FFRML处理时间(40.5分钟±6.3)显著短于FFRCFD(43.4分钟±7.1),P=.042。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Purpose To compare two technical approaches for determination of coronary computed tomography (CT) angiography-derived fractional flow reserve (FFR)-FFR derived from coronary CT angiography based on computational fluid dynamics (hereafter, FFRCFD) and FFR derived from coronary CT angiography based on machine learning algorithm (hereafter, FFRML)-against coronary CT angiography and quantitative coronary angiography (QCA). Materials and Methods A total of 85 patients (mean age, 62 years ± 11 [standard deviation]; 62% men) who had undergone coronary CT angiography followed by invasive FFR were included in this single-center retrospective study. FFR values were derived on-site from coronary CT angiography data sets by using both FFRCFD and FFRML. The performance of both techniques for detecting lesion-specific ischemia was compared against visual stenosis grading at coronary CT angiography, QCA, and invasive FFR as the reference standard. Results On a per-lesion and per-patient level, FFRML showed a sensitivity of 79% and 90% and a specificity of 94% and 95%, respectively, for detecting lesion-specific ischemia. Meanwhile, FFRCFD resulted in a sensitivity of 79% and 89% and a specificity of 93% and 93%, respectively, on a per-lesion and per-patient basis (P = .86 and P = .92). On a per-lesion level, the area under the receiver operating characteristics curve (AUC) of 0.89 for FFRML and 0.89 for FFRCFD showed significantly higher discriminatory power for detecting lesion-specific ischemia compared with that of coronary CT angiography (AUC, 0.61) and QCA (AUC, 0.69) (all P < .0001). Also, on a per-patient level, FFRML (AUC, 0.91) and FFRCFD (AUC, 0.91) performed significantly better than did coronary CT angiography (AUC, 0.65) and QCA (AUC, 0.68) (all P < .0001). Processing time for FFRML was significantly shorter compared with that of FFRCFD (40.5 minutes ± 6.3 vs 43.4 minutes ± 7.1; P = .042). Conclusion The FFRML algorithm performs equally in detecting lesion-specific ischemia when compared with the FFRCFD approach. Both methods outperform accuracy of coronary CT angiography and QCA in the detection of flow-limiting stenosis.
引用
- Tesche C, De Cecco CN, Baumann S, et al. Coronary CT Angiography-derived Fractional Flow Reserve: Machine Learning Algorithm versus Computational Fluid Dynamics Modeling. Radiology. 2018. PMID: 29634438. doi:10.1148/radiol.2018171291
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。