肝脏铁过量的MR成像定量:放射科医师入门指南
铁过量可为遗传性或继发性,继发性常见于需要长期输血的无效造血(如β-地中海贫血major和镰状细胞病),可导致肝硬化、肝细胞癌及心脏和内分泌并发症。肝脏是主要铁储存器官且最先显示铁过载,因此检测和定量肝铁至关重要。MR成像已广泛用于评估铁分布、检测、分级和监测治疗反应,多种技术各有优缺点。
要点
- 肝铁定量MR技术包括肝-肌信号强度比、R2弛豫测量、R2*和定量磁化率 mapping,各有适用条件和局限。
- 肝-肌信号强度比技术简单易得,但假设参考组织(肌肉)信号正常。
- R2*技术采集速度快、覆盖肝铁含量范围广,适用于1.5T和3.0T,但需额外后处理软件。
核心结论
- MR成像是肝铁定量的常用方法,可用于评估铁分布、检测、分级和监测治疗反应;不同MR技术各有优缺点,应根据设备条件和临床需求选择。
研究设计与样本
- 本文为综述/入门指南(Primer),未报告系统检索范围、纳入文献数量或样本量;总结了肝铁定量的MR成像技术及其优缺点。
诊断标准与关键数值
- 肝-肌信号强度比技术:简单、广泛可用,但假设参考组织信号正常。
- R2弛豫测量:已验证,但采集时间长易受呼吸运动伪影影响,目前仅适用于1.5T成像,且需离线分析增加成本和延迟。
- R2*技术:采集时间快,可覆盖广泛肝铁含量范围,适用于1.5T和3.0T成像,但需要额外后处理软件。
- 定量磁化率 mapping:检测铁沉积敏感性最高,但仍处于研究阶段,与肝铁含量的相关性尚未确立。
临床应用与阅片要点
- 肝脏是铁过量的主要储存器官且最先受累,MR成像可用于检测和定量肝铁以指导治疗和预防并发症。
- 选择MR技术时需考虑设备场强(R2弛豫测量目前仅限1.5T)、采集时间、后处理软件可用性及参考组织假设。
局限性
- R2弛豫测量易受呼吸运动伪影影响,目前仅适用于1.5T成像,且需离线分析增加成本和延迟。
- 肝-肌信号强度比技术假设参考组织信号正常。
- 定量磁化率 mapping仍处于研究阶段,与肝铁含量的相关性尚未确立。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Iron overload is a systemic disorder and is either primary (genetic) or secondary (exogenous iron administration). Primary iron overload is most commonly associated with hereditary hemochromatosis and secondary iron overload with ineffective erythropoiesis (predominantly caused by β-thalassemia major and sickle cell disease) that requires long-term transfusion therapy, leading to transfusional hemosiderosis. Iron overload may lead to liver cirrhosis and hepatocellular carcinoma, in addition to cardiac and endocrine complications. The liver is one of the main iron storage organs and the first to show iron overload. Therefore, detection and quantification of liver iron overload are critical to initiate treatment and prevent complications. Liver biopsy was the historical reference standard for detection and quantification of liver iron content. Magnetic resonance (MR) imaging is now commonly used for liver iron quantification, including assessment of distribution, detection, grading, and monitoring of treatment response in iron overload. Several MR imaging techniques have been developed for iron quantification, each with advantages and limitations. The liver-to-muscle signal intensity ratio technique is simple and widely available; however, it assumes that the reference tissue is normal. Transverse magnetization (also known as R2) relaxometry is validated but is prone to respiratory motion artifacts due to a long acquisition time, is presently available only for 1.5-T imaging, and requires additional cost and delay for off-line analysis. The R2* technique has fast acquisition time, demonstrates a wide range of liver iron content, and is available for 1.5-T and 3.0-T imaging but requires additional postprocessing software. Quantitative susceptibility mapping has the highest sensitivity for detecting iron deposition; however, it is still investigational, and the correlation with liver iron content is not yet established. ©RSNA, 2018.
引用
- Labranche R, Gilbert G, Cerny M, et al. Liver Iron Quantification with MR Imaging: A Primer for Radiologists. Radiographics. 2018. PMID: 29528818. doi:10.1148/rg.2018170079
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。