基于CT重建X线片的胫骨旋转测量放射学标记:准确性与可行性研究
本研究为实验室计算机分析,利用20例下肢CT构建3D模型并模拟4种标准膝踝X线片,由两名观察者描绘4个标记点并分析其与虚拟圆柱的关系,另在尸体小腿植入两枚克氏针行CT和2D透视比较模拟X线片与透视的准确性。结果显示膝正位和踝穴X线片上标记点测量可靠性好(变异系数分别<0.01和=0.01),尸体透视与模拟X线片测量相似。作者提出简单放射学标记可计算3D坐标系以准确评估胫骨干轴向旋转角。
要点
- 膝正位和踝穴X线片上标记点测量可靠性好,变异系数分别<0.01和=0.01。
- 尸体小腿真实透视与模拟X线片的标记点测量结果相似。
- 作者提出简单放射学标记可计算3D坐标系以评估胫骨干轴向旋转角。
核心结论
- 作者提出一个模型,其中简单放射学标记可用于计算3D坐标系,从而准确评估胫骨干的轴向旋转角。
研究设计与样本
- 实验室计算机分析,使用20例下肢CT扫描通过AMIRA©软件构建3D模型,在后髁线和经踝轴植入虚拟3D圆柱,模拟4种标准膝踝X线片,由两名观察者描绘4个标记点并分析其与圆柱的关系以评估准确性和可重复性;另在尸体小腿植入两枚克氏针,行CT扫描和2D透视,比较模拟X线片与透视的准确性。
诊断标准与关键数值
- 膝正位X线片标记点测量的变异系数<0.01。
- 踝穴X线片标记点测量的变异系数=0.01。
- 尸体测量使用真实透视与模拟X线片所得标记点结果相似。
临床应用与阅片要点
- 作者提出简单放射学标记可用于计算3D坐标系,以准确评估胫骨干轴向旋转角。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVES: Malreduction in the axial plane (malrotation) following tibial fracture surgery is often undiagnosed. A few clinical and radiographic methods have been proposed for measuring tibial rotation intraoperatively, yet have failed to match the accuracy of computed tomography (CT). The aim of this study was to develop radiographic tools for future intraoperative assessment of the tibial shaft rotation profile.
METHODS: The setting was a laboratory computerized analysis. Twenty lower limb CT scans were used to construct a three-dimensional (3D) model using AMIRA© software. A virtual 3D cylinder was implanted in the posterior condylar line and in the transmalleolar axis. The 3D models were used to simulate four standard knee and ankle plain radiographs. On each radiograph, four landmarks were depicted by two observers and their relation with the cylinder was measured and analyzed for accuracy and reproducibility. A cadaveric lower leg was implanted with two Kirschner wires. A CT scan was performed in addition to 2D fluoroscopy. The simulated radiographs and the fluoroscopy were compared for accuracy.
RESULTS: Measurement of the landmarks showed reliability in most of the knee anteroposterior and ankle mortise radiographs (coefficients of variation < 0.01 and = 0.01) respectively. Cadaveric measurement of the landmarks using real fluoroscopy and simulated radiographs were similar.
CONCLUSIONS: To date, no reliable and common methods have been reported for the evaluation of tibial axial rotation. We propose a model in which simple radiographic landmarks can be used to calculate a 3D coordinate system that accurately assesses the axial rotation angle of the tibial shaft.
引用
- Hakimian D, Khoury A, Mosheiff R, et al. Radiographic markers for measuring tibial rotation based on CT-reconstructed radiographs: an accuracy and feasibility study. Skeletal Radiol. 2017. PMID: 29128913. doi:10.1007/s00256-017-2810-7
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。