超声测量股二头肌长头肌肉结构
本研究在20名成人中评估超声测量股二头肌长头肌肉结构的信度与重测最小可检测差异,比较6厘米与3厘米图像宽度及图像采集与数字化环节。结果显示同一评估者完成采集与数字化时信度高,6厘米图像的信度高于3厘米图像。
要点
- 同一评估者完成图像采集与数字化时,股二头肌长头肌肉结构超声测量信度高。
- 6厘米图像宽度的评估者间信度高于3厘米图像宽度。
- 6厘米图像的最小可检测差异:肌束长度8.4毫米、肌束角1.5度、肌肉厚度1.6毫米。
核心结论
- 当同一评估者完成图像采集和数字化时,超声可可靠评估股二头肌中部肌肉结构。
研究设计与样本
- 研究纳入20名成人,进行3次评估,使用6厘米图像宽度采集声像图并裁剪为3厘米宽度。
- 计算图像采集和数字化过程分开及合并(会话内)的评估者内和评估者间信度,使用组内相关系数(ICC)和Pearson相关系数(r)。
关键影像表现/征象
- 通过标记肌肉-肌腱连接处距离确定肌肉长度。
- 肌肉长度测量的评估者内信度高(ICC=0.93;r=0.92),评估者间信度高(ICC=0.90;r=0.90)。
诊断标准与关键数值
- 数字化评估者内信度:变异系数0.2%-1.8%;评估者间信度:ICC=0.79-0.99;r=0.80-0.99。
- 6厘米和3厘米图像所有结构参数的会话内评估者内信度:ICC=0.79-0.95;r=0.79-0.95;评估者间信度:ICC=0.51-0.92;r=0.70-0.93。
- 3厘米图像会话内评估者内信度:ICC=0.77-0.93;r=0.79-0.93;评估者间信度:ICC=0.63-0.98;r=0.90-0.98。
- 图像采集和数字化过程的评估者间会话信度:6厘米图像(ICC=0.65-0.86;r=0.67-0.87)高于3厘米图像(ICC=0.28-0.93;r=0.67-0.93)。
- 6厘米图像的最小可检测差异:肌束长度8.4毫米、肌束角1.5度、肌肉厚度1.6毫米。
临床应用与阅片要点
- 作者结论提示,超声可用于可靠评估股二头肌中部肌肉结构,前提是同一评估者完成图像采集和数字化。
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVES: Biceps femoris long-head architectural assessment using ultrasonography (US) has not been previously described in detail for both acquisition (image capture) and digitization (image measurement) processes, and the effect of the US window width is unknown. This study aimed to describe the reliability and test-retest minimum detectable difference of US-based biceps femoris architectural measurements.
METHODS: Muscle length was determined by marking the muscle-tendon junction distances. Sonograms were acquired with a 6-cm image width and cropped for a 3-cm width in 3 assessments (n = 20 adults). Intra- and inter-rater reliability rates were determined for both image (3- and 6-cm widths) acquisition and digitizing processes separated and together (within session) for the biceps femoris fascicle length, fascicle angle, and muscle thickness measurements using intraclass correlation coefficients (ICCs) and Pearson (r) correlation coefficients.
RESULTS: Muscle length was measured with high intra-rater (ICC = 0.93; r = 0.92) and inter-rater (ICC = 0.90; r = 0.90) reliability. Intra-rater (coefficient of variation, 0.2%-1.8%) and inter-rater (ICC = 0.79-0.99; r = 0.80-0.99) digitizing reliability rates were high. High intra-rater (ICC = 0.79-0.95; r = 0.79-0.95) and moderate-to-high inter-rater (ICC = 0.51-0.92; r = 0.70-0.93) session reliability rates were found for all architectural parameters for 6- and 3-cm images (intra-rater ICC = 0.77-0.93; r = 0.79-0.93; inter-rater ICC = 0.63-0.98; r = 0.90-0.98). The inter-rater session reliability rates for both image acquisition and digitizing processes were higher for 6-cm images (ICC = 0.65-0.86; r = 0.67-0.87) than 3-cm images (ICC = 0.28-0.93; r = 0.67-0.93). The minimum detectable differences for the 6-cm images were 8.4 mm, 1.5 °, and 1.6 mm for fascicle length, fascicle angle, and muscle thickness, respectively.
CONCLUSIONS: Ultrasonography can be used to reliably assess midmuscle architecture of the biceps femoris muscle when the same rater performs image acquisition and digitization.
引用
- Freitas SR, Marmeleira J, Valamatos MJ, et al. Ultrasonographic Measurement of the Biceps Femoris Long-Head Muscle Architecture. J Ultrasound Med. 2017. PMID: 29027683. doi:10.1002/jum.14436
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。