优化MRI后勤流程:对性能、效率和患者流通量的前瞻性分析
该研究在三级学术医疗中心对两台门诊MRI扫描仪进行为期2周的前瞻性工作流程数据采集,共评估305例MRI检查,按增值时间、商业增值时间和非增值时间分层。结果显示非增值时间约占MRI流程周期和患者停留总时长的三分之一;静脉或输液港置管是最常见的延迟原因(频率5.57%),而MRI关节造影因未在排程中计入对比剂关节注射造成的时间延迟影响最大(平均42.2分钟)。
要点
- 非增值时间约占MRI流程周期(25.87%)和患者停留总时长(29.14%)的三分之一。
- 静脉或输液港置管是频率最高的延迟原因(5.57%),平均延迟22.82分钟。
- MRI关节造影因未在排程中计入对比剂关节注射,造成最大时间影响(平均延迟42.2分钟,频率1.64%)。
核心结论
- 非增值时间约占MRI流程周期和患者停留总时长的三分之一,识别具体延迟环节可能有助于实施针对性改进策略,并可能提高收入、效率和整体患者满意度。
研究设计与样本
- 前瞻性研究,在三级学术医疗中心对两台门诊MRI扫描仪进行为期2周的工作流程数据采集,共评估305例MRI检查,按增值时间、商业增值时间和非增值时间分层分析。
诊断标准与关键数值
- MRI流程周期平均为50.97±24.4(SD)分钟/检查,非增值时间平均为13.21±18.77分钟,占流程周期总时间的25.87%。
- 患者停留周期平均为83.51±33.63分钟,非增值时间平均为24.33±24.84分钟,占患者停留总时长的29.14%。
- 静脉或输液港置管延迟频率最高(5.57%),平均延迟22.82分钟。
- MRI关节造影因需关节内注射对比剂但未在排程中计入,时间影响最大(平均延迟42.2分钟,频率1.64%)。
- 305例患者中34例(11.15%)未在预定时间或之前到达。
临床应用与阅片要点
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVE: The objective of this study is to optimize MRI logistics through evaluation of MRI workflow and analysis of performance, efficiency, and patient throughput in a tertiary care academic center.
SUBJECTS AND METHODS: For 2 weeks, workflow data from two outpatient MRI scanners were prospectively collected and stratified by value added to the process (i.e., value-added time, business value-added time, or non-value-added time). Two separate time cycles were measured: the actual MRI process cycle as well as the complete length of patient stay in the department. In addition, the impact and frequency of delays across all observations were measured.
RESULTS: A total of 305 MRI examinations were evaluated, including body (34.1%), neurologic (28.9%), musculoskeletal (21.0%), and breast examinations (16.1%). The MRI process cycle lasted a mean of 50.97 ± 24.4 (SD) minutes per examination; the mean non-value-added time was 13.21 ± 18.77 minutes (25.87% of the total process cycle time). The mean length-of-stay cycle was 83.51 ± 33.63 minutes; the mean non-value-added time was 24.33 ± 24.84 minutes (29.14% of the total patient stay). The delay with the highest frequency (5.57%) was IV or port placement, which had a mean delay of 22.82 minutes. The delay with the greatest impact on time was MRI arthrography for which joint injection of contrast medium was necessary but was not accounted for in the schedule (mean delay, 42.2 minutes; frequency, 1.64%). Of 305 patients, 34 (11.15%) did not arrive at or before their scheduled time.
CONCLUSION: Non-value-added time represents approximately one-third of the total MRI process cycle and patient length of stay. Identifying specific delays may expedite the application of targeted improvement strategies, potentially increasing revenue, efficiency, and overall patient satisfaction.
引用
- Beker K, Garces-Descovich A, Mangosing J, et al. Optimizing MRI Logistics: Prospective Analysis of Performance, Efficiency, and Patient Throughput. AJR Am J Roentgenol. 2017. PMID: 28726508. doi:10.2214/AJR.16.17698
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。