先进模型迭代重建对冠状动脉测量中阅片者间一致性的影响
研究对比先进模型迭代重建(ADMIRE)与滤波反投影(FBP)在冠状动脉CT血管成像(cCTA)测量中的影响,采用体模扫描和27例患者cCTA,发现ADMIRE较FBP降低图像噪声(31.3±9.9 HU vs 55.9±15.7 HU,p<0.001),并改善两位阅片者间管腔直径和狭窄程度测量的一致性,而不影响平均斑块衰减。
要点
- ADMIRE较FBP降低图像噪声,可能改善冠脉管腔直径和狭窄程度测量的阅片者间一致性。
- ADMIRE与FBP的斑块密度测量高度相关(r=0.951 vs 0.967),平均斑块衰减未见明显影响。
核心结论
- ADMIRE较FBP通过降低图像噪声改善cCTA冠状动脉评估,使冠脉管腔直径和狭窄程度测量的阅片者间一致性提高,而不影响平均斑块衰减。
研究设计与样本
- 研究纳入体模扫描和27例患者的冠状动脉CTA检查,采用第三代双源CT扫描仪,分别以FBP和ADMIRE重建图像,体模测量作为参考标准。
- 在患者研究中,对无斑块(n=308)和有斑块(n=40)的冠脉节段代表性轴位层面在相同位置评估FBP和ADMIRE重建,由两名独立且盲法的阅片者分析图像质量、体模和冠脉测量、斑块分析及阅片者间一致性。
诊断标准与关键数值
- ADMIRE重建平均图像噪声为31.3±9.9 HU,FBP重建为55.9±15.7 HU(p<0.001)。
- 两位阅片者管腔直径测量相关性:ADMIRE r=0.987(95%CI 0.983-0.989;p<0.001),FBP r=0.939(95%CI 0.924-0.951;p<0.001)。
- 两位阅片者狭窄程度测量相关性:ADMIRE r=0.818(95%CI 0.680-0.900),FBP r=0.560(95%CI 0.301-0.742);应用ADMIRE后管腔直径和狭窄程度测量的阅片者间一致性均显著提高(p<0.001)。
- 斑块密度测量相关性:FBP r=0.951(95%CI 0.909-0.974),ADMIRE r=0.967(95%CI 0.939-0.983)。
临床应用与阅片要点
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVES: To evaluate the influence of advanced modeled iterative reconstruction (ADMIRE) on coronary artery computed tomography angiography (cCTA) measurements in comparison to filtered back projection (FBP).
MATERIAL AND METHODS: Phantom scans and coronary CTA studies of 27 patients were acquired with a third generation dual-source CT scanner. Images were reconstructed using FBP and ADMIRE. Phantom measurements were used as reference standard. In patient studies, representative axial slices of each coronary artery segment without (n=308) and with coronary plaques (n=40) were assessed in identical positions for comparison of FBP and ADMIRE reconstructions. Image analyses included quality assessment, phantom and coronary artery measurements, plaque analysis, and interreader agreement of two independent and blinded readers.
RESULTS: Mean image noise was lower on ADMIRE reconstructions with 31.3±9.9 HU compared to 55.9±15.7 HU on FBP reconstructions (p<0.001). Measurement precision and interreader agreement of both observers were assessed satisfactorily on phantom images in comparison to the full width half maximum method. In patients, correlation of lumen diameters of both observers improved using ADMIRE with a Pearson's r=0.987 (95% confidence interval [CI], 0.983-0.989; p<0.001) compared to FBP images with r=0.939 (95% CI, 0.924-0.951; p<0.001). Applying ADMIRE, agreement of both observers for lumen diameter measurements significantly increased (p<0.001). This was also observed for the degree of stenosis (p<0.001) with r=0.560 using FBP (95% CI, 0.301-0.742) and with r=0.818 using ADMIRE (95% CI, 0.680-0.900). Plaque density measurements correlated closely with a Pearson's r of 0.951 in FBP (95% CI, 0.909-0.974) and 0.967 in ADMIRE (95% CI, 0.939-0.983).
CONCLUSIONS: Advanced modeled iterative reconstruction significantly improves coronary artery assessment in coronary CTA in comparison to FBP by improved image quality due to image noise removal. This renders improved interobserver agreement for coronary lumen diameter and degree of stenosis measurements without influencing mean plaque attenuation.
引用
- Gassenmaier T, Distelmaier I, Weng AM, et al. Impact of advanced modeled iterative reconstruction on interreader agreement in coronary artery measurements. Eur J Radiol. 2017. PMID: 28712701. doi:10.1016/j.ejrad.2017.06.029
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。