基于扩散与体素内不相干运动MR成像的虚拟弹性成像:肝脏假说生成研究
这项回顾性研究纳入15例慢性肝病患者,在3 T下行MR弹性成像和扩散MR成像,寻找MR弹性成像剪切模量与偏移表观扩散系数之间的经验关系,并据此从扩散信号反推肝脏剪切模量、生成IVIM虚拟弹性图。结果显示μMRE与sADC200-1500显著相关(r²=0.90,P=1×10⁻⁷),可用方程μdiff=(-9.8±0.8)ln(S200/S1500)+(14.0±0.9)估算剪切模量,虚拟弹性图可显示病灶新的对比特征。
要点
- 扩散MR成像经标准MR弹性成像校准后,无需机械振动即可定量转换为肝脏剪切模量。
- μMRE与sADC200-1500显著相关,r²=0.90,P=1×10⁻⁷。
- 虚拟弹性图仅需采集并处理两个b值(200与1500 sec/mm²),可显示病灶新的弹性驱动IVIM对比特征。
核心结论
- 扩散MR成像通过用标准MR弹性成像校准sADC200-1500,可在不使用机械振动的情况下定量转换为剪切模量,提供肝纤维化程度信息,且虚拟弹性图仅需两个b值。
研究设计与样本
- 回顾性研究,2016年1月至4月进行,经机构审查委员会批准并豁免知情同意。
- 纳入15例受试者(13男2女,平均年龄±标准差73岁±8)。
- 在3 T下行MR弹性成像和扩散MR成像,参考标准为MR弹性成像剪切模量μMRE。
关键影像表现/征象
- μMRE与sADC200-1500之间观察到显著相关(r²=0.90,P=1×10⁻⁷)。
- 基于μMRE与sADC200-1500的关系,可用方程μdiff=(-9.8±0.8)ln(S200/S1500)+(14.0±0.9)估算扩散-based剪切模量μdiff。
- 可生成IVIM虚拟弹性图,依据伪振动频率和幅度揭示病灶新的对比特征。
- 可模拟传播剪切波,产生新的弹性驱动IVIM对比,其虚拟振动频率和幅度范围不受MR弹性成像或MR成像硬件能力限制。
诊断标准与关键数值
- sADC200-1500由b值200(S200)和1500(S1500)sec/mm²采集的扩散MR信号计算。
- μdiff估算方程:μdiff=(-9.8±0.8)ln(S200/S1500)+(14.0±0.9)。
- μMRE与sADC200-1500相关r²=0.90,P=1×10⁻⁷。
临床应用与阅片要点
- 扩散MR成像经标准MR弹性成像校准后,无需机械振动即可定量估算肝脏剪切模量。
- 虚拟弹性图仅需两个b值(200与1500 sec/mm²)即可采集和处理。
- 虚拟弹性图可显示病灶新的对比特征,并可模拟传播剪切波。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
Purpose To investigate the potential of diffusion magnetic resonance (MR) imaging to provide quantitative estimates of tissue stiffness without using mechanical vibrations in patients with chronic liver diseases and to generate a new elasticity-driven intravoxel incoherent motion (IVIM) contrast. Materials and Methods This retrospective study, conducted from January to April 2016, was approved by an institutional review board that waived the requirement for informed consent. Fifteen subjects were included (13 men and two women; mean age ± standard deviation, 73 years ± 8). MR elastography and diffusion MR imaging were performed at 3 T. A search for an empirical relationship between MR elastographic shear modulus, µMRE, and a shifted apparent diffusion coefficient (sADC) was performed. The sADC was then inverted to estimate patient liver shear modulus directly from diffusion MR imaging signals. Results A significant correlation (r2 = 0.90, P = 1 · 10-7) was observed between µMRE and sADC calculated by using diffusion MR imaging signals acquired with b values of 200 (S200) and 1500 (S1500 ) sec/mm2 (sACD200-1500). On the basis of the relationship between the µMRE and sADC200-1500, a diffusion-based shear modulus, µdiff, could be estimated with the following equation: µdiff = (-9.8 ± 0.8) ln(S200/S1500) + (14.0 ± 0.9). IVIM virtual elastograms also could be generated to reveal new contrast features in lesions, depending on pseudovibration frequency and amplitude. Conclusion Diffusion MR imaging, through a calibration of sADC200-1500 with standard MR elastography, can be converted quantitatively into shear modulus without using mechanical vibrations to provide information on the degree of liver fibrosis; these virtual elastograms require only two b values to be acquired and processed. Propagating shear wave can also be emulated, leading to a new elasticity-driven IVIM contrast with ranges of virtual vibration frequencies and amplitudes not limited by MR elastography or MR imaging hardware capacities. © RSNA, 2017 Online supplemental material is available for this article.
引用
- Le Bihan D, Ichikawa S, Motosugi U, et al. Diffusion and Intravoxel Incoherent Motion MR Imaging-based Virtual Elastography: A Hypothesis-generating Study in the Liver. Radiology. 2017. PMID: 28604279. doi:10.1148/radiol.2017170025
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。