文献速递腹部CT

MDCT肝脏纹理分析用于评估肝纤维化

Texture analysis of the liver at MDCT for assessing hepatic fibrosis.
PubMed 文献 · Abdom Radiol (NY) · 2017-01-01

本研究在289例成人腹部MDCT上使用TexRAD软件进行肝脏纹理分析,评估其区分肝纤维化分期(F0-F4)的能力。结果显示平均灰度强度随纤维化分期升高,F0 vs F1-4的AUC为0.78;肝硬化(≥F4)时峰度和偏度的AUC分别为0.86和0.87。CTTA可能有助于检测肝纤维化并区分分期,尤其在晚期。

要点

  • 平均灰度强度随纤维化分期增加而升高,可用于区分F0与F1-4。
  • 肝硬化(≥F4)时峰度和偏度降低,粗滤过尺度下AUC分别为0.86和0.87。
  • 偏度在 cutoff 1.3 时诊断肝硬化的敏感度84%、特异度75%。

核心结论

  • CTTA可能有助于检测肝纤维化的存在并区分纤维化分期,尤其在晚期水平。

研究设计与样本

  • 研究纳入289例成人(158男/131女,平均年龄51岁),包括健康对照(F0,n=77)及各期纤维化患者(F1 n=42;F2 n=37;F3 n=53;F4 n=80);对腹部MDCT进行定量纹理分析(QTA),使用商用软件TexRAD(基于滤过-直方图统计技术),测量全肝、Couinaud IV-VIII段及I-III段的单层ROI;所有中间期纤维化(F1-F3)病例的活检在一年内完成。

诊断标准与关键数值

  • 平均灰度强度随纤维化分期增加而升高;F0 vs F1-4在中等滤过下ROC AUC为0.78,cutoff 0.18时敏感度74%、特异度74%。
  • 显著纤维化(≥F2)平均值的AUC在中等和粗滤过纹理中为0.71-0.73,cutoff 0.3时敏感度71%、特异度68%;晚期纤维化(≥F3)表现相似。
  • 熵显示相似趋势;峰度和偏度随纤维化增加而降低,尤其在肝硬化患者。
  • 肝硬化(≥F4)时粗滤过尺度下峰度和偏度的AUC分别为0.86和0.87;偏度在cutoff 1.3时敏感度84%、特异度75%。

临床应用与阅片要点

  • 作者认为CTTA可能有助于检测肝纤维化存在并区分分期,尤其在晚期水平。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

PURPOSE: To evaluate CT texture analysis (CTTA) for staging of hepatic fibrosis (stages F0-F4) METHODS: Quantitative texture analysis (QTA) of the liver was performed on abdominal MDCT scans using commercially available software (TexRAD), which uses a filtration-histogram statistic-based technique. Single-slice ROI measurements of the total liver, Couinaud segments IV-VIII, and segments I-III were obtained. CTTA parameters were correlated against fibrosis stage (F0-F4), with biopsy performed within one year for all cases with intermediate fibrosis (F1-F3).

RESULTS: The study cohort consisted of 289 adults (158M/131W; mean age, 51 years), including healthy controls (F0, n = 77), and patients with increasing stages of fibrosis (F1, n = 42; F2 n = 37; F3 n = 53; F4 n = 80). Mean gray-level intensity increased with fibrosis stage, demonstrating an ROC AUC of 0.78 at medium filtration for F0 vs F1-4, with sensitivity and specificity of 74% and 74% at cutoff 0.18. For significant fibrosis (≥F2), mean showed AUCs ranging from 0.71-0.73 across medium- and coarse- filtered textures with sensitivity and specificity of 71% and 68% at cutoff of 0.3, with similar performance also observed for advanced fibrosis (≥F3). Entropy showed a similar trend. Conversely, kurtosis and skewness decreased with increasing fibrosis, particularly in cirrhotic patients. For cirrhosis (≥F4), kurtosis and skewness showed AUCs of 0.86 and 0.87, respectively, at coarse-filtered scale, with skewness showing a sensitivity and specificity of 84% and 75% at cutoff of 1.3.

CONCLUSION: CTTA may be helpful in detecting the presence of hepatic fibrosis and discriminating between stages of fibrosis, particularly at advanced levels.

来源:Abdom Radiol (NY),查看原文。版权归原作者所有。

引用

  1. Lubner MG, Malecki K, Kloke J, et al. Texture analysis of the liver at MDCT for assessing hepatic fibrosis. Abdom Radiol (NY). 2017. PMID: 28314916. doi:10.1007/s00261-017-1096-5

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。