基于MRI数据的三维打印肾癌模型:在术前规划中的应用
回顾性选取10例肾肿块病例(肾测量评分大于5,范围6-10),由三名泌尿肿瘤外科医生随机分别基于PACS影像和附加三维打印模型评估手术规划。所有10例中三维打印模型均改变了计划入路,对经腹膜或腹膜后入路及夹闭决策影响最大(30%-50%病例出现改变),模型在所有病例中增加了对所选术式的信心。
要点
- 三维打印肾癌模型基于增强后脂肪抑制梯度回波T1加权序列生成。
- 所有10例中三维打印模型均改变了计划手术入路。
- 经腹膜或腹膜后入路及夹闭决策在30%-50%病例中出现改变。
核心结论
- 基于MRI数据创建的术前实体三维模型可能影响复杂肾癌的手术规划。
研究设计与样本
- 回顾性研究,从正在进行的IRB批准研究中选取10例肾肿块病例,肾测量评分大于5(范围6-10),使用三维增强后脂肪抑制梯度回波T1加权序列生成三维打印模型,由三名有经验的泌尿肿瘤外科医生随机评估仅PACS影像与附加三维打印模型两种情况。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
OBJECTIVE: To determine whether patient-specific 3D printed renal tumor models change pre-operative planning decisions made by urological surgeons in preparation for complex renal mass surgical procedures.
MATERIALS AND METHODS: From our ongoing IRB approved study on renal neoplasms, ten renal mass cases were retrospectively selected based on Nephrometry Score greater than 5 (range 6-10). A 3D post-contrast fat-suppressed gradient-echo T1-weighted sequence was used to generate 3D printed models. The cases were evaluated by three experienced urologic oncology surgeons in a randomized fashion using (1) imaging data on PACS alone and (2) 3D printed model in addition to the imaging data. A questionnaire regarding surgical approach and planning was administered. The presumed pre-operative approaches with and without the model were compared. Any change between the presumed approaches and the actual surgical intervention was recorded.
RESULTS: There was a change in planned approach with the 3D printed model for all ten cases with the largest impact seen regarding decisions on transperitoneal or retroperitoneal approach and clamping, with changes seen in 30%-50% of cases. Mean parenchymal volume loss for the operated kidney was 21.4%. Volume losses >20% were associated with increased ischemia times and surgeons tended to report a different approach with the use of the 3D model compared to that with imaging alone in these cases. The 3D printed models helped increase confidence regarding the chosen operative procedure in all cases.
CONCLUSIONS: Pre-operative physical 3D models created from MRI data may influence surgical planning for complex kidney cancer.
引用
- Wake N, Rude T, Kang SK, et al. 3D printed renal cancer models derived from MRI data: application in pre-surgical planning. Abdom Radiol (NY). 2017. PMID: 28062895. doi:10.1007/s00261-016-1022-2
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。