文献速递胸部技术与安全CT

利用基于深度学习的内核转换实现更精确的CT气道定量

Leveraging deep learning-based kernel conversion for more precise airway quantification on CT.
PubMed 文献 · Eur Radiol · 2025-05-22

本回顾性研究纳入两个中心96例非增强胸部CT患者,评估四种重建内核(中软、中锐、锐利、极锐利)及基于深度学习的内核转换对全自动气道定量CT(QCT)测量变异性的影响。结果显示锐利内核下气道QCT指标降低,内核转换可降低部分厂商肺专用内核间的测量变异性,但对非肺专用内核及亚段气道效果有限。

要点

  • 不同重建内核显著影响气道QCT测量值,锐利内核下Pi10、壁厚、壁面积百分比、管腔直径均降低(p<0.001)。
  • 深度学习内核转换可降低部分厂商肺专用锐利内核与中软内核间的测量变异性(CCC提升)。
  • 内核转换对非肺专用锐利内核及亚段气道变异性改善有限,一致的气道分割与精确解剖标记可提升可重复性。

核心结论

  • 基于深度学习的内核转换可降低不同内核和厂商间气道QCT的测量变异性,但对非肺专用内核和亚段气道效果较差;一致的气道分割和精确解剖标记可进一步提高自动定量的可重复性。

研究设计与样本

  • 回顾性研究,纳入两个中心96例接受非增强胸部CT的患者,使用三个厂商的四种内核(中软、中锐、锐利、极锐利)重建图像,以中软内核为参考对锐利内核图像进行内核转换,转换前后进行全自动气道定量。

诊断标准与关键数值

  • 气道QCT指标(如Pi10、壁厚、壁面积百分比、管腔直径)随内核变锐而降低(均p<0.001),变异程度因变量和厂商而异。
  • 内核转换后中软与锐利内核间合并CCC:厂商A从0.59升至0.92,厂商B从0.40升至0.91,厂商C肺专用锐利内核从0.26升至0.71。
  • 厂商C非肺专用锐利内核转换后合并CCC从0.81降至0.43,转换无效。

临床应用与阅片要点

  • 阅片及报告气道定量结果时需注意重建内核类型对测量值的影响,锐利内核下测量值偏低。
  • 对肺专用锐利内核图像可考虑使用深度学习内核转换以降低与中软内核间的测量变异性。
  • 非肺专用锐利内核及亚段气道测量变异性较大,转换改善有限,需谨慎解读。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

OBJECTIVES: To evaluate the variability of fully automated airway quantitative CT (QCT) measures caused by different kernels and the effect of kernel conversion.

MATERIALS AND METHODS: This retrospective study included 96 patients who underwent non-enhanced chest CT at two centers. CT scans were reconstructed using four kernels (medium soft, medium sharp, sharp, very sharp) from three vendors. Kernel conversion targeting the medium soft kernel as reference was applied to sharp kernel images. Fully automated airway quantification was performed before and after conversion. The effects of kernel type and conversion on airway quantification were evaluated using analysis of variance, paired t-tests, and concordance correlation coefficient (CCC).

RESULTS: Airway QCT measures (e.g., Pi10, wall thickness, wall area percentage, lumen diameter) decreased with sharper kernels (all, p < 0.001), with varying degrees of variability across variables and vendors. Kernel conversion substantially reduced variability between medium soft and sharp kernel images for vendors A (pooled CCC: 0.59 vs. 0.92) and B (0.40 vs. 0.91) and lung-dedicated sharp kernels of vendor C (0.26 vs. 0.71). However, it was ineffective for non-lung-dedicated sharp kernels of vendor C (0.81 vs. 0.43) and showed limited improvement in variability of QCT measures at the subsegmental level. Consistent airway segmentation and identical anatomic labeling improved subsegmental airway variability in theoretical tests.

CONCLUSION: Deep learning-based kernel conversion reduced the measurement variability of airway QCT across various kernels and vendors but was less effective for non-lung-dedicated kernels and subsegmental airways. Consistent airway segmentation and precise anatomic labeling can further enhance reproducibility for reliable automated quantification.

KEY POINTS: Question How do different CT reconstruction kernels affect the measurement variability of automated airway measurements, and can deep learning-based kernel conversion reduce this variability? Findings Kernel conversion improved measurement consistency across vendors for lung-dedicated kernels, but showed limited effectiveness for non-lung-dedicated kernels and subsegmental airways. Clinical relevance Understanding kernel-related variability in airway quantification and mitigating it through deep learning enables standardized analysis, but further refinements are needed for robust airway segmentation, particularly for improving measurement variability in subsegmental airways and specific kernels.

来源:Eur Radiol,查看原文。版权归原作者所有。

引用

  1. Choe J, Yun J, Kim MJ, et al. Leveraging deep learning-based kernel conversion for more precise airway quantification on CT. Eur Radiol. 2025. PMID: 40405045. doi:10.1007/s00330-025-11696-w

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。