不同管电压图像的全自动分类模型对骨密度筛查的影响:一项自身对照研究
本研究基于标准剂量胸部CT(SDCT,120 kVp)和低剂量胸部CT(LDCT,80 kVp)开发结合深度学习与影像组学的骨状态预测模型,共纳入1508例回顾性患者。自动分割模型Dice系数在LDCT和SDCT分别为0.98±0.01和0.97±0.02;管电压变化降低影像组学特征可重复性(85.05%特征CCC<0.75),基于LDCT和SDCT模型的AUC分别为0.97±0.01和0.94±0.02,交叉验证提示管电压变化可损害模型诊断效能。
要点
- 基于LDCT或SDCT的自动骨状态预测模型均可准确评估骨状态
- 管电压变化降低影像组学特征可重复性,85.05%特征CCC<0.75
- 影像组学模型不能普遍适用于不同管电压图像,需保证模型开发与采集图像管电压一致
核心结论
- 利用LDCT或SDCT图像的自动骨状态预测模型能够准确评估骨状态;管电压影响特征可重复性和模型预测效能,图像采集时有必要考虑管电压变化。
研究设计与样本
- 回顾性研究,共纳入1508例患者;LDCT采用80 kVp、管电流100-475 mA,SDCT采用120 kVp、管电流100-520 mA;开发自动胸椎松质骨(TVCB)分割模型,提取1184个特征并基于LDCT和SDCT图像开发两个分类器;以定量CT检查诊断结果为参考标准,一级分类器区分骨密度正常或异常(包括骨质疏松和骨量减少),二级分类器鉴别骨质疏松与骨量减少;采用Dice系数评价自动分割模型,计算LDCT与SDCT间影像组学特征的一致性相关系数(CCC)并评估模型性能。
诊断标准与关键数值
- 自动分割模型Dice系数在LDCT为0.98±0.01、在SDCT为0.97±0.02;85.05%的影像组学特征可重复性低(CCC<0.75);基于LDCT和SDCT模型的AUC分别为0.97±0.01和0.94±0.02。
临床应用与阅片要点
- 作者指出,临床应用中确保模型开发所用图像的管电压与患者采集图像的管电压一致至关重要。
局限性
- 原文为回顾性研究
- 交叉验证使用不同管电压扫描的独立测试集,提示管电压变化可损害模型诊断效能
- 影像组学模型不能普遍适用于不同管电压的图像
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
英文原文(摘要)· 点击展开
PURPOSE: To develop two bone status prediction models combining deep learning and radiomics based on standard-dose chest computed tomography (SDCT) and low-dose chest computed tomography (LDCT), and to evaluate the effect of tube voltage on reproducibility of radiomics features and predictive efficacy of these models.
METHODS: A total of 1508 patients were enrolled in this retrospective study. LDCT was conducted using 80 kVp, tube current ranging from 100 to 475 mA. On the other hand, SDCT was performed using 120 kVp, tube current ranging from 100 to 520 mA. We developed an automatic thoracic vertebral cancellous bone (TVCB) segmentation model. Subsequently, 1184 features were extracted and two classifiers were developed based on LDCT and SDCT images. Based on the diagnostic results of quantitative computed tomography examination, the first-level classifier was initially developed to distinguish normal or abnormal BMD (including osteoporosis and osteopenia), while the second-level classifier was employed to identify osteoporosis or osteopenia. The Dice coefficient was used to evaluate the performance of the automated segmentation model. The Concordance Correlation Coefficients (CCC) of radiomics features were calculated between LDCT and SDCT, and the performance of these models was evaluated.
RESULTS: Our automated segmentation model achieved a Dice coefficient of 0.98 ± 0.01 and 0.97 ± 0.02 in LDCT and SDCT, respectively. Alterations in tube voltage decreased the reproducibility of the extracted radiomic features, with 85.05 % of the radiomic features exhibiting low reproducibility (CCC < 0.75). The area under the curve (AUC) using LDCT-based and SDCT-based models was 0.97 ± 0.01 and 0.94 ± 0.02, respectively. Nonetheless, cross-validation with independent test sets of different tube voltage scans suggests that variations in tube voltage can impair the diagnostic efficacy of the model. Consequently, radiomics models are not universally applicable to images of varying tube voltages. In clinical settings, ensuring consistency between the tube voltage of the image used for model development and that of the acquired patient image is critical.
CONCLUSIONS: Automatic bone status prediction models, utilizing either LDCT or SDCT images, enable accurate assessment of bone status. Tube voltage impacts reproducibility of features and predictive efficacy of models. It is necessary to account for tube voltage variation during the image acquisition.
引用
- Tong X, Wang S, Cheng Q, et al. Effect of fully automatic classification model from different tube voltage images on bone density screening: A self-controlled study. Eur J Radiol. 2024. PMID: 38850722. doi:10.1016/j.ejrad.2024.111521
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。