文献速递腹部外周血管CT

基于X射线相位对比CT的三维分支几何方法用于区分早期肝纤维化中的肝内血管类型

A method of three-dimensional branching geometry to differentiate the intrahepatic vascular type in early-stage liver fibrosis using X-ray phase-contrast CT.
PubMed 文献 · Eur J Radiol · 2022-01-22

本研究通过胆管结扎手术诱导小鼠早期肝纤维化,采用X射线相位对比CT(PCCT)对肝叶进行三维成像,研究血管直径、截面积、离心率、分支角、分叉指数、面积比和交界指数等形态特征,以区分肝静脉与门静脉。结果显示,完整肝叶中交界指数的AUC为0.99(95%CI:0.98-1.00),离体肝叶中15、10、5个分支的交界指数AUC分别为0.98(95%CI:0.94-1.00)、0.86(95%CI:0.73-0.99)和0.82(95%CI:0.67-0.97)。结论认为,利用交界指数的三维分支几何方法可通过PCCT区分早期肝纤维化中的肝静脉与门静脉,为进一步分析肝纤维化提供基础。

要点

  • PCCT可无标记、高分辨率地显示小鼠肝叶三维血管结构。
  • 交界指数在完整肝叶区分肝静脉与门静脉的AUC为0.99(95%CI:0.98-1.00)。
  • 离体肝叶中分支数越少,交界指数的区分效能越低(15分支AUC 0.98,5分支AUC 0.82)。

核心结论

  • 利用交界指数的三维分支几何方法可通过PCCT区分早期肝纤维化中的肝静脉与门静脉,为进一步分析肝纤维化提供基础。

研究设计与样本

  • 动物实验:对小鼠行胆管结扎手术诱导早期肝纤维化,采用X射线相位对比CT(PCCT)对肝叶进行三维成像,分析血管形态特征并以ROC曲线评估区分效能。

关键影像表现/征象

  • PCCT显示肝叶三维血管结构;研究的形态特征包括血管直径、截面积、离心率、分支角、分叉指数、面积比和交界指数。

诊断标准与关键数值

  • 完整肝叶中交界指数区分肝静脉与门静脉的AUC为0.99(95%CI:0.98-1.00);离体肝叶中15个分支的交界指数AUC为0.98(95%CI:0.94-1.00),10个分支为0.86(95%CI:0.73-0.99),5个分支为0.82(95%CI:0.67-0.97)。

临床应用与阅片要点

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

英文原文(摘要)· 点击展开

PURPOSE: Differentiating the intrahepatic vascular type is essential for the early diagnosis of liver fibrosis. X-ray phase-contrast computed tomography (PCCT) is a label-free, high-resolution imaging modality for imaging vascular networks in a whole liver lobe. This study explores the use of three-dimensional (3D) branching geometry to differentiate between the hepatic vein (HV) and portal vein (PV) in early-stage liver fibrosis with PCCT.

METHOD: Bile duct ligation surgery was conducted in mice to induce early-stage liver fibrosis. The individual liver lobes of mice were imaged using PCCT, and morphological characteristics, including vascular diameter, cross-sectional area, eccentricity, branch angle, bifurcation index, area ratio and junction exponent, were investigated in 3D modality. These characteristics were used to differentiate the HV from the PV, and their performance was evaluated through receiver operating characteristic (ROC) curve analysis.

RESULTS: PCCT revealed a 3D vascular structure of the liver lobes. For intact lobes, the differentiation method between the HV and PV using the junction exponent had an AUC of 0.99 (95% CI: 0.98-1.00). Moreover, the AUCs of the junction exponent for 15, 10, and 5 branches in dissected lobes for differentiation were 0.98 (95% CI: 0.94-1.00), 0.86 (95% CI: 0.73-0.99) and 0.82 (95% CI: 0.67-0.97), respectively.

CONCLUSION: The method of 3D branching geometry using the junction exponent could differentiate the HV from PV in early-stage liver fibrosis via the PCCT, which provides the foundation for further analysis of liver fibrosis.

来源:Eur J Radiol,查看原文。版权归原作者所有。

引用

  1. Xin X, Xu H, Jian J, et al. A method of three-dimensional branching geometry to differentiate the intrahepatic vascular type in early-stage liver fibrosis using X-ray phase-contrast CT. Eur J Radiol. 2022. PMID: 35091166. doi:10.1016/j.ejrad.2022.110178

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。