文献速递瓣膜病与结构性心脏病

五种保瓣主动脉根部置换管道构型的体外综合比较:基于3D打印心脏模拟器

Comprehensive Ex Vivo Comparison of 5 Clinically Used Conduit Configurations for Valve-Sparing Aortic Root Replacement Using a 3-Dimensional-Printed Heart Simulator.
PubMed 文献 · Circulation · 2020-10-05

本研究利用3D打印心脏模拟器与猪主动脉根(n=5),在体外比较五种临床用保瓣主动脉根部置换管道构型(反连合折叠、Stanford改良、直管、Uni-Graft及Valsalva graft)与自体根对照的血流动力学与生物力学表现。结果显示各管道血流动力学临床相似,但生物力学性能存在差异,直管最接近自体主动脉根生物力学。

要点

  • 五种管道构型血流动力学与自体根临床相似。
  • 直管与Uni-Graft反流分数最低,反连合折叠最高。
  • 直管最接近自体根的生物力学性能。

核心结论

  • 在体外模拟系统中,临床用保瓣主动脉根部置换管道构型血流动力学可比,但生物力学表现不同,直管最接近自体主动脉根生物力学。

研究设计与样本

  • 采用定制3D打印心脏模拟器与猪主动脉根(n=5),以不完全平衡测量设计串联测试五种管道构型,自体根为对照,使用线性模型分析血流动力学与视频测量数据。

主要发现

  • 直管组根部扩张性显著低于对照根及除Stanford改良外所有其他管道(各P≤0.01)。
  • 除直管外所有管道瓣叶开放速度显著高于自体根(各P<0.01)。
  • 反连合折叠、Stanford改良及Valsalva graft组瓣叶开放力显著高于对照(P<0.01)。
  • 直管组瓣叶关闭速度与自体根相似,且显著低于其他管道(各P≤0.01)。
  • 反连合折叠、Stanford改良及Valsalva graft组相对瓣叶关闭力较自体根高5倍以上。

临床怎么用

  • 直管构型在体外最接近自体主动脉根生物力学,或有助于长期耐久性,但需临床验证。

局限性

  • 研究为体外猪主动脉根模型(n=5),结果不能直接外推至人体。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Many graft configurations are clinically used for valve-sparing aortic root replacement, some specifically focused on recapitulating neosinus geometry. However, the specific impact of such neosinuses on valvular and root biomechanics and the potential influence on long-term durability are unknown. METHODS: Using a custom 3-dimenstional-printed heart simulator with porcine aortic roots (n=5), the anticommissural plication, Stanford modification, straight graft (SG), Uni-Graft, and Valsalva graft configurations were tested in series using an incomplete counterbalanced measures design, with the native root as a control, to mitigate ordering effects. Hemodynamic and videometric data were analyzed using linear models with conduit as the fixed effect of interest and valve as a fixed nuisance effect with post hoc pairwise testing using Tukey's correction. RESULTS: Hemodynamics were clinically similar between grafts and control aortic roots. Regurgitant fraction varied between grafts, with SG and Uni-Graft groups having the lowest regurgitant fractions and anticommissural plication having the highest. Root distensibility was significantly lower in SG versus both control roots and all other grafts aside from the Stanford modification (P≤0.01 for each). All grafts except SG had significantly higher cusp opening velocities versus native roots (P<0.01 for each). Relative cusp opening forces were similar between SG, Uni-Graft, and control groups, whereas anticommissural plication, Stanford modification, and Valsalva grafts had significantly higher opening forces versus controls (P<0.01). Cusp closing velocities were similar between native roots and the SG group, and were significantly lower than observed in the other conduits (P≤0.01 for each). Only SG and Uni-Graft groups experienced relative cusp closing forces approaching that of the native root, whereas relative forces were >5-fold higher in the anticommissural plication, Stanford modification, and Valsalva graft groups. CONCLUSIONS: In this ex vivo modeling system, clinically used valve-sparing aortic root replacement conduit configurations have comparable hemodynamics but differ in biomechanical performance, with the straight graft most closely recapitulating native aortic root biomechanics.

来源:Circulation,查看原文。版权归原作者所有。

引用

  1. Paulsen MJ, Imbrie-Moore AM, Baiocchi M, et al. Comprehensive Ex Vivo Comparison of 5 Clinically Used Conduit Configurations for Valve-Sparing Aortic Root Replacement Using a 3-Dimensional-Printed Heart Simulator. Circulation. 2020. PMID: 33017215. doi:10.1161/CIRCULATIONAHA.120.046612

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。