文献速递血液透析通路

血管吻合器与缝线在动静脉瘘创建中的经济学评价

Economic evaluation of suture versus clip anastomosis in arteriovenous fistula creation.
PubMed 文献 · J Vasc Surg · 2020-11-27

该单中心回顾性研究分析了2009至2018年916例上肢动静脉瘘(AVF)创建,比较连续缝线(79%)与非穿透性血管夹(21%)的临床与经济结局。两组1年成熟率、一期通畅率、辅助一期通畅率及并发症无差异,但缝线组成熟时间更短、二期通畅率更高且直接成本更低,支持优先使用标准聚丙烯缝线技术。

要点

  • 缝线组成熟时间4.3个月短于血管夹组5.5个月(P < .01)。
  • 缝线组二期通畅率77.13%高于血管夹组69.59%(P = .03)。
  • 缝线组直接成本$1389.26低于血管夹组$1716.51(P < .01)。

核心结论

  • 上肢AVF创建中缝线与血管夹在1年成熟率、一期通畅率、辅助一期通畅率及并发症方面等效,但血管夹费用更高。
  • 研究结果支持在创建上肢AVF时优先使用标准聚丙烯缝线技术以减轻美国医疗经济负担。

研究设计与样本

  • 单中心回顾性分析2009至2018年所有接受上肢AVF创建的患者,共916例AVF(79%连续缝线,21%非穿透性血管夹)。
  • 对2013至2018年部分患者亚组进行成本分析。

主要发现

  • 两组患者人口学特征和合并症无差异,1年成熟率、一期通畅率、辅助一期通畅率及并发症率均无差异。
  • 缝线组成熟时间4.3个月短于血管夹组5.5个月(P < .01)。
  • 缝线组二期通畅率77.13%高于血管夹组69.59%(P = .03)。
  • 成本分析显示直接成本缝线组$1389.26低于血管夹组$1716.51(P < .01),贡献毛利缝线组$1770.19高于血管夹组$1128.36(P < .01)。

临床怎么用

  • 在创建上肢AVF时,可优先选择标准聚丙烯缝线技术,因其临床结局与血管夹等效且经济成本更低。

局限性

  • 本研究为单中心回顾性分析,成本分析仅基于2013至2018年亚组患者。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

OBJECTIVE: Techniques such as the use of nonpenetrating vascular clips for arteriovenous fistula (AVF) anastomotic creation have been developed in an effort to reduce fistula-related complications. However, the outcomes data for the use of clips have remained equivocal, and the cost evaluations to support their use have been largely theoretical. Therefore, the present study aimed to determine both the clinical and the cost outcomes of AVFs created with nonpenetrating vascular clips compared with the continuous suture technique during a 10-year period at a single institution. METHODS: All patients undergoing AVF creation in the upper extremity from 2009 through 2018 were retrospectively analyzed. The patient demographics and AVF outcomes were collected and compared stratified by the surgical technique used. A cost analysis was performed of a subgroup of patients from 2013 to 2018. RESULTS: During the 10-year study period, 916 AVFs were created (79% using the continuous suture technique and 21% using nonpenetrating vascular clips). Patient demographics and comorbid conditions did not differ between the two groups, and no differences were present in maturation, primary patency, assisted primary patency, or complication rates between the two groups at 1 year. The suture group had a shorter time to maturation (4.3 months vs 5.5 months; P < .01) and improved secondary patency compared with the clip group (77.13% vs 69.59%; P = .03) The cost analysis of the procedures revealed a significant difference in direct costs (suture, $1389.26 vs clip, $1716.51; P < .01) and contribution margin (suture, $1770.19 vs clip, $1128.36; P < .01) for the two groups. CONCLUSIONS: Both suture and clip techniques in AVF creation demonstrated equivalent rates of maturation, primary patency, assisted primary patency, and complications at 1 year with higher expense associated with the use of clips. Thus, in an effort to reduce the economic burden of healthcare in the United States, the findings from the present study support the preferential use of the standard polypropylene suture technique when creating upper extremity AVFs.

来源:J Vasc Surg,查看原文。版权归原作者所有。

引用

  1. Terranella S, Fefferman M, Zhang Y, et al. Economic evaluation of suture versus clip anastomosis in arteriovenous fistula creation. J Vasc Surg. 2020. PMID: 33249206. doi:10.1016/j.jvs.2020.10.076

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。