文献速递主动脉疾病颈动脉与弓上血管

双自制开窗支架行全主动脉弓腔内修复的弓部解剖模式分析

Aortic Arch Anatomy Pattern in Patients Treated Using Double Homemade Fenestrated Stent-Grafts for Total Endovascular Aortic Arch Repair.
PubMed 文献 · J Endovasc Ther · 2020-06-04

回顾性分析33例使用双开窗PMEG行0区TEVAR患者的术前CTA,描述主动脉弓及弓上分支的解剖变异,并建立可用于通用双开窗设计的平均空间构型。结果显示弓部解剖变异常见,97%患者弓上分支可完全落入设定的两个限定区域。

要点

  • 弓部解剖变异常见,但多数分支可纳入通用双开窗限定区域。
  • 以LSA为参考,IA和LCCA的平均钟点位置分别为12:50和12:05。
  • 该形态模式可用于设计即用型双开窗支架移植物。

核心结论

  • 主动脉弓解剖变异多且常见,但可描述出限定变异发生区域的通用形态模式,用于即用型双开窗支架设计。

研究设计与样本

  • 回顾性分析2017年1月至2019年3月连续33例(平均68岁,27例男性)使用双开窗PMEG行0区TEVAR患者的术前胸部CTA。
  • 在血管工作站上采用中心腔线重建标准化技术完成所有测量。
  • 弓部头臂血管分支模式分为8型。

主要发现

  • 弓干构型为I型26例(79%)、II型5例(15%)、III型1例、IV型1例。
  • 升主动脉中段、IA、LCCA、LSA水平平均主动脉直径分别为35.7±3.7、34.2±4.5、33.3±6.7、33.7±4.7 mm。
  • 弓干平均直径分别为12.2±1.7、7.5±1.4、8.0±0.8 mm。
  • LSA与LCCA、LCCA与IA平均纵向中心点间距分别为15.9±2.5 mm和12.1±3.0 mm。
  • 以LSA为参考,IA和LCCA平均钟点位置分别为12:50和12:05。

临床怎么用

  • 该形态模式可为设计即用型双开窗支架移植物提供解剖依据,简化0区TEVAR的器械选择。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

Purpose: To analyze the structural variation of the aortic arch and the supra-aortic arteries and establish an average spatial configuration that would be a pattern for a "universal double fenestration" design for physician-modified endovascular grafts (PMEGs) used in total thoracic endovascular aortic repair (TEVAR). Materials and Methods: Aortic arch morphology was retrospectively analyzed by reviewing the preoperative thoracic computed tomography angiography scans in 33 consecutive patients (mean age 68 years; 27 men) treated between January 2017 and March 2019 using double-fenestrated PMEGs for zone 0 TEVAR. Image analysis was completed according to a standardized technique on a vascular workstation with center lumen line reconstruction for all measurements. Variations in branching pattern of the aortic arch were classified into 8 types. Results: The arch trunk configuration was type I in 26 patients (79%), type II in 5 (15%), type III in 1, and type IV in 1. Mean aortic diameters at the level of mid ascending aorta, innominate artery (IA), left common carotid artery (LCCA), and left subclavian artery (LSA) were 35.7±3.7, 34.2±4.5, 33.3±6.7, and 33.7±4.7 mm, respectively. Mean diameters of the trunk were 12.2±1.7, 7.5±1.4, and 8.0±0.8 mm, respectively. Mean longitudinal center to center lengths were 15.9±2.5 mm between the LSA and LCCA and 12.1±3.0 mm between the LCCA and IA. Mean clock positions using the LSA as reference were 12:50 for the IA and 12:05 for the LCCA. In 32 patients (97%) all the supra-aortic branch vessels fit perfectly inside two delimited areas defined by a proximal common square area of 30×30 mm for the IA and LCCA and a second distal 8-mm-diameter circle for the LSA. Conclusion: Variations of the aortic arch anatomy are numerous and common. A general morphological pattern is described that delimits the aortic area where these variations occur. This information can be utilized for the design of an off-the-shelf double-fenestrated stent-graft for zone 0 TEVAR.

来源:J Endovasc Ther,查看原文。版权归原作者所有。

引用

  1. Chassin-Trubert L, Gandet T, Ozdemir BA, et al. Aortic Arch Anatomy Pattern in Patients Treated Using Double Homemade Fenestrated Stent-Grafts for Total Endovascular Aortic Arch Repair. J Endovasc Ther. 2020. PMID: 32495679. doi:10.1177/1526602820931787

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。