左锁骨下动脉分支支架不同构型的血流动力学研究
本研究基于一例TEVAR术后CT构建三维主动脉弓模型,在计算机中模拟10种左锁骨下动脉分支支架构型并进行计算流体动力学分析。结果显示各构型间压力与能量损失差异很小,但支架突入主动脉腔长度是血流动力学变异的主要因素,突入超过5 mm与更高壁面剪切应力及更明显回流相关,提示潜在血栓风险增加。
要点
- 左锁骨下动脉分支支架不同构型间总压降与能量损失差异较小。
- 支架突入主动脉腔长度是血流动力学变异的主要决定因素。
- 突入超过5 mm与更大面积的高壁面剪切应力及回流相关,提示血栓风险。
核心结论
- 左锁骨下动脉分支支架构型影响动脉血流动力学特征,但压降与能量损失可能无临床意义。
- 支架突入主动脉腔长度产生最大的血流动力学变异,突入不超过5 mm时潜在血栓生成风险较小。
- 突入超过5 mm时血流动力学更紊乱,提示潜在血栓形成风险更大,长期可能具有临床意义。
研究设计与样本
- 基于一例使用单左锁骨下动脉分支主动脉腔内移植物TEVAR患者的术后CT图像提取三维主动脉弓几何模型。
- 在计算机中修改模型获得10种潜在左锁骨下动脉分支支架构型:5种下向构型(0、5、10 mm主动脉突入,内径10–12 mm)、4种弯曲构型(30–60°,顺行/逆行方向)和1种左锁骨下动脉开口错位构型。
- 以0 mm下向支架为基准构型,进行计算流体动力学分析以识别压力、能量和壁面剪切应力相关参数的差异。
主要发现
- 各构型间总压降和能量损失变异分别不大于5 mmHg(平均动脉压的6%)和5.7 mW(心脏做功的0.7%)。
- 突入不超过5 mm产生的血流扰动无临床意义。
- 支架进一步突入主动脉腔产生更复杂血流动力学,特征为更大能量损失和更明显回流。
- 突入主动脉腔大于5 mm与分支支架外表面更大面积的最大壁面剪切应力升高(>20 Pa)相关。
临床怎么用
- 选择左锁骨下动脉分支支架构型时,应关注支架突入主动脉腔的长度。
- 突入不超过5 mm可能降低潜在血栓生成风险。
- 突入超过5 mm需警惕血流动力学紊乱及远期血栓风险。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: Branched stent grafts represent a viable option for left subclavian artery (LSA) revascularisation in patients treated by thoracic endovascular aortic repair (TEVAR) for Zone 2 lesions. This study investigated the haemodynamic performance of different LSA branched stent graft configurations as potential determinants of thrombotic and stroke risks. METHODS: A three dimensional aortic arch geometry extracted from post-operative computed tomography images of a TEVAR patient using a single LSA branched aortic endograft was modified in silico to obtain ten potential LSA branched stent graft configurations: five down facing (0-5 - 10 mm aortic protrusion with 10-12 mm internal diameter), four curved (30-60° with antegrade/retrograde orientation), and one LSA orifice misalignment. The 0 mm down facing stent graft was considered base configuration. Computational fluid dynamic analyses were performed to identify differences in pressure, energy, and wall shear stress (WSS) based parameters. RESULTS: Total pressure drop and energy loss variations among configurations were not greater than 5 mmHg (6% of mean arterial pressure) and 5.7 mW (0.7% of cardiac power), respectively. Protrusions up to 5 mm created clinically insignificant flow disturbances. However, stent graft protrusions further into the aortic lumen created more complex haemodynamics, characterised by larger energy loss and more prominent flow recirculation. Protrusion greater than 5 mm into the lumen was associated with larger areas of elevated maximum WSS (>20 Pa) along the outer surface of the branched stent graft. CONCLUSION: Arterial haemodynamic characteristics are affected by LSA branched stent graft configurations, with pressure drops and energy losses likely to be clinically insignificant. The length of the stent graft protrusion into the aortic lumen generated the largest haemodynamic variations in the aortic system. Protrusions up to 5 mm have smaller risk of potential thrombus generation. Conversely, larger protrusions into the aortic lumen showed more disturbed haemodynamics, suggesting a greater risk of potential thrombus formation, which may be clinically important over time.
引用
- Tricarico R, Tran-Son-Tay R, Laquian L, et al. Haemodynamics of Different Configurations of a Left Subclavian Artery Stent Graft for Thoracic Endovascular Aortic Repair. Eur J Vasc Endovasc Surg. 2019. PMID: 31761570. doi:10.1016/j.ejvs.2019.06.028
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。