主动脉颈角度测量新「角度」:配对角度公式与三维中心线比较
结果显示配对角度公式与金标准强相关,平均绝对差为6度(95%CI 4-8度),排除严重角度>60度的阴性预测值>99%,较单独二维测量显著降低漏诊率。
要点
- 配对角度公式与三维中心线测量强相关,相关系数与观察者内变异相当。
- 配对角度公式排除严重角度>60度的阴性预测值>99%。
- 相比单独二维测量,配对角度公式将漏诊严重角度>60度的假阴性率从4.8%降至0.7%。
核心结论
- 配对角度公式比单独二维测量检测出更多严重角度,并能准确排除严重角度>60度。
- 该方法可作为主动脉颈角度测量的有用辅助手段,尤其在三维重建软件不易获得时。
研究设计与样本
- 三维中心线主动脉颈角度由放射科主治医师测量,配对角度公式由血管外科医生、住院医师和医学生应用二维冠状面和矢状面角度估算真实角度。
主要发现
- 平均年龄78岁,74%为男性,术前平均动脉瘤直径5.7 cm。
- 平均颈长1.9 cm(1.1-3.2 cm),金标准测量的平均颈角度为39度(2-84度)。
- 线性回归显示三维测量与配对角度公式强相关,组内相关系数范围为0.74-0.87。
- 用户平均估计值与金标准绝对差为6度(95%CI 4-8度),无系统偏倚。
- 配对角度公式排除严重角度>60度的总体阴性预测值>99%,假阴性率从4.8%降至0.7%(P = .032)。
关键数值与推荐
- 严重角度定义为>60度。
- 配对角度公式排除严重角度>60度的阴性预测值>99%。
- 配对角度公式与三维测量的平均绝对差为6度(95%CI 4-8度)。
临床怎么用
- 在缺乏三维重建软件时,可用配对角度公式基于二维冠状面和矢状面角度估算主动脉颈真实角度。
- 配对角度公式有助于准确排除严重角度>60度,减少漏诊。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: Infrarenal aortic neck angulation is one of the most powerful predictors of endovascular aneurysm repair failure. Whereas the "gold standard" to measure this angle is three-dimensional (3D) reconstruction and centerline measurement, many surgeons rely on estimations of angulation based on two-dimensional (2D) views of computed tomography imaging. Unfortunately, these views do not accurately represent the true angle, particularly if aortic angulation is oblique to the standard views. In response to this issue, our group has developed a novel trigonometric formula that uses coronal and sagittal measured angles to calculate the true angle. The purpose of this study was to compare the paired angle formula with 3D centerline measurements for estimating true aortic neck angulation. METHODS: Fifty randomly selected patients treated by endovascular aneurysm repair at The Ottawa Hospital between 2010 and 2015 were studied. The 3D centerline aortic neck angle measurements were made by a radiology staff physician. The paired angle formula was applied by a vascular surgeon, resident, and student using 2D coronal and sagittal angles from computed tomography imaging to estimate the true angle. RESULTS: The average age was 78 years; 74% of patients were male, and average preoperative aneurysm diameter was 5.7 cm. The mean neck length was 1.9 cm (1.1-3.2 cm), and mean neck angulation calculated by the gold standard measurements was 39 degrees (2-84 degrees). Linear regression demonstrated strong association between 3D measurements and the paired angle formula, with correlations comparable to the intraobserver variability (intraclass correlation coefficient values range, 0.74-0.87). The average user estimates deviated minimally from the gold standard (absolute difference, 6 degrees; 95% confidence interval, 4-8 degrees) without systemic bias. The paired angle formula accurately ruled out severe angulation >60 degrees with an overall negative predictive value of >99%. Compared with isolated 2D measurements, application of the paired angle formula significantly decreased the false-negative rate of unappreciated severe angulation >60 degrees from 4.8% to 0.7% (P = .032). CONCLUSIONS: The paired angle formula detects significantly more severe angles than isolated 2D measurements and can accurately rule out severe angulation >60 degrees compared with the 3D measurements. The implementation of this angle estimation method is a useful adjunct in the measurement of aortic neck angulation, especially if 3D reconstruction software is not readily available. Furthermore, the importance of accurate angle measurement is not limited to vascular surgery and has direct relevance to any procedural specialty that relies on preoperative angle measurements.
引用
- Rockley M, Hadziomerovic A, van Walraven C, et al. A new "angle" on aortic neck angulation measurement. J Vasc Surg. 2019. PMID: 30837183. doi:10.1016/j.jvs.2018.11.036
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。