文献速递主动脉疾病

3D打印主动脉弓模板辅助胸主动脉腔内修复术中经心尖外置导丝决策

A 3D Printed Aortic Arch Template to Facilitate Decision-Making Regarding the Use of an Externalized Transapical Wire during Thoracic Endovascular Aneurysm Repair.
PubMed 文献 · Ann Vasc Surg · 2018-08-13

本文介绍利用3D打印的严重成角主动脉弓模板模拟支架移植物推进,在牵拉导丝顶端后成功推进,从而辅助决定是否需经心尖途径外置导丝行胸主动脉腔内修复术(TEVAR)。该3D打印模板可预先模拟TEVAR操作,协助其他需额外经心尖途径的决策。

要点

  • 3D打印主动脉弓模板可模拟支架移植物在严重成角弓部的推进。
  • 模拟中牵拉导丝顶端后支架移植物成功推进。
  • 该模拟辅助决定TEVAR中是否需经心尖外置导丝。

核心结论

  • 3D打印主动脉弓模板可预先模拟TEVAR操作,辅助决定是否需经心尖途径外置导丝及其他相关决策。

研究设计与样本

  • 使用严重成角主动脉弓的3D打印模板进行体外模拟,推进支架移植物并牵拉导丝顶端。

主要发现

  • 在3D打印模板上牵拉导丝顶端后,支架移植物成功推进。
  • 该模拟辅助了关于经心尖途径外置导丝的决策。

临床怎么用

  • 作者认为3D主动脉打印可预先用于模拟TEVAR操作,并协助其他需额外经心尖途径的决策。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

Thoracic endovascular aortic repair (TEVAR) is an established treatment option, although some anatomical challenges require a through-and-through wire technique, and subsequently transapical access via minithoracotomy can be required. It is clear that an objective tool to facilitate decision-making is needed. A 3D print of a severely angulated aortic arch was used as a template to advance a stent graft, and this was achieved after pulling the top of the wire. This simulation assisted in decision-making relating to transapical access with a wire externalization. A 3D aortic print could be used in advance to simulate the TEVAR procedure and facilitate any other decisions regarding additional transapical access.

来源:Ann Vasc Surg,查看原文。版权归原作者所有。

引用

  1. Rynio P, Kazimierczak A, Jedrzejczak T, et al. A 3D Printed Aortic Arch Template to Facilitate Decision-Making Regarding the Use of an Externalized Transapical Wire during Thoracic Endovascular Aneurysm Repair. Ann Vasc Surg. 2018. PMID: 30114499. doi:10.1016/j.avsg.2018.06.021

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。