文献速递主动脉疾病

验证一种新方法以确定腹主动脉瘤腔内修复术后主动脉颈内支架移植物的三维贴附、位置与扩张

Validation of a New Methodology to Determine 3-Dimensional Endograft Apposition, Position, and Expansion in the Aortic Neck After Endovascular Aneurysm Repair.
PubMed 文献 · J Endovasc Ther · 2018-04-06

本研究在体外硅胶模型和24例择期EVAR患者中验证了半自动计算支架与肾下主动脉颈贴附面积的新方法。体外1毫米层厚扫描偏差为2.8%,支架尺寸计算ICC为0.909至0.996,支架直径、织物距离和最短贴附长度的重复性系数分别为2.3毫米、5.2至5.7毫米和4.1毫米。作者认为该方法可准确、低变异性地计算贴附面。

要点

  • 体外硅胶模型验证显示,1毫米层厚扫描的贴附面积计算偏差为2.8%。
  • 24例择期EVAR患者中,支架尺寸计算的ICC为0.909至0.996,一致性优。
  • 支架直径、织物距离和最短贴附长度的重复性系数分别为2.3毫米、5.2至5.7毫米和4.1毫米。

核心结论

  • 这项回顾性验证研究表明,支架移植物与肾下主动脉颈之间的贴附面可被准确计算且变异性低。
  • 确定支架在主动脉颈内的位置与贴附状态并检测随访中的细微变化,对判断EVAR最终失败至关重要。

研究设计与样本

  • 在体外用已知尺寸的圆柱形硅胶模型,比较不同层厚CTA重建上计算贴附面与真实表面的偏差。
  • 回顾性纳入24例择期EVAR患者,用重复性系数和组内相关系数评估计算支架位置、贴附与扩张的观察者间变异性。
  • 将上述计算的变异性与术前及首次术后CTA中心线重建上测量的颈长和颈径变异性进行比较。

主要发现

  • 体外验证显示贴附面积计算准确,1毫米层厚扫描的偏差为2.8%。
  • 支架尺寸计算的一致性优,ICC为0.909至0.996。
  • 支架直径计算的重复性系数为2.3毫米,织物距离为5.2至5.7毫米,最短贴附长度为4.1毫米。
  • 常规颈径测量的重复性系数为0.9至1.1毫米,颈长测量的重复性系数为4.0至8.0毫米。

关键数值与推荐

  • 体外验证中,1毫米层厚扫描计算的贴附面积与真实表面偏差为2.8%。
  • 支架尺寸计算的ICC为0.909至0.996。
  • 支架直径的RC为2.3毫米,织物距离的RC为5.2至5.7毫米,最短贴附长度的RC为4.1毫米。
  • 颈径测量的RC为0.9至1.1毫米,颈长测量的RC为4.0至8.0毫米。

临床怎么用

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

PURPOSE: To validate a novel methodology employing regular postoperative computed tomography angiography (CTA) scans to assess essential factors contributing to durable endovascular aneurysm repair (EVAR), including endograft deployment accuracy, neck adaptation to radial forces, and effective apposition of the fabric within the aortic neck. METHODS: Semiautomatic calculation of the apposition surface between the endograft and the infrarenal aortic neck was validated in vitro by comparing the calculated surfaces over a cylindrical silicon model with known dimensions on CTA reconstructions with various slice thicknesses. Interobserver variabilities were assessed for calculating endograft position, apposition, and expansion in a retrospective series of 24 elective EVAR patients using the repeatability coefficient (RC) and the intraclass correlation coefficient (ICC). The variability of these calculations was compared with variability of neck length and diameter measurements on centerline reconstructions of the preoperative and first postoperative CTA scans. RESULTS: In vitro validation showed accurate calculation of apposition, with deviation of 2.8% from the true surface for scans with 1-mm slice thickness. Excellent agreement was achieved for calculation of the endograft dimensions (ICC 0.909 to 0.996). Variability was low for calculation of endograft diameter (RC 2.3 mm), fabric distances (RC 5.2 to 5.7 mm), and shortest apposition length (RC 4.1 mm), which was the same as variability of regular neck diameter (RC 0.9 to 1.1 mm) and length (RC 4.0 to 8.0 mm) measurements. CONCLUSION: This retrospective validation study showed that apposition surfaces between an endograft and the infrarenal neck can be calculated accurately and with low variability. Determination of the (ap)position of the endograft in the aortic neck and detection of subtle changes during follow-up are crucial to determining eventual failure after EVAR.

来源:J Endovasc Ther,查看原文。版权归原作者所有。

引用

  1. Schuurmann RCL, Overeem SP, van Noort K, et al. Validation of a New Methodology to Determine 3-Dimensional Endograft Apposition, Position, and Expansion in the Aortic Neck After Endovascular Aneurysm Repair. J Endovasc Ther. 2018. PMID: 29623767. doi:10.1177/1526602818764413

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。