文献速递主动脉疾病

肾下腹主动脉瘤模型中EVAR与EVAS的血流及壁面剪切应力特征

Flow and wall shear stress characterization after endovascular aneurysm repair and endovascular aneurysm sealing in an infrarenal aneurysm model.
PubMed 文献 · J Vasc Surg · 2017-03-09

在四种腹主动脉瘤体外模型中,比较了三种覆膜支架(Endurant、AFX、Nellix)与对照的血流模式和壁面剪切应力(WSS)。结果显示不同支架设计不影响肾上主动脉血流;EVAR模型肾动脉后壁WSS较低,EVAS模型剪切率较高;所有支架远端均出现低WSS和高振荡剪切指数(OSI)的小区域。

要点

  • 不同支架设计对肾上主动脉WSS和OSI无显著影响。
  • EVAR术后肾动脉后壁出现较低WSS区域。
  • EVAS模型局部剪切率高于其他支架。

核心结论

  • 不同支架设计不影响肾上主动脉血流。
  • EVAR术后肾动脉后壁WSS较低,EVAS模型剪切率较高。
  • 所有支架模型在支架远端流出道附近均有低WSS和高OSI的小区域。

研究设计与样本

  • 体外实验研究,构建四种腹主动脉瘤体模,包括三种支架模型(Endurant、AFX、Nellix)和对照。
  • 在生理静息条件下测试,采用激光粒子成像 velocimetry 可视化血流,量化剪切率、WSS和OSI。

主要发现

  • 肾上主动脉各模型WSS和OSI相当。
  • EVAR模型肾动脉血流轮廓与对照相当,但后壁WSS较低。
  • EVAS模型显示更强射流,部分区域剪切率高于其他模型。
  • 所有支架远端共同髂动脉附近出现低WSS和高OSI小区域,但各区域最大剪切率远低于急性血栓形成病理阈值。

关键数值与推荐

  • 肾上主动脉WSS和OSI在各模型间相当。
  • EVAR模型肾动脉后壁WSS低于对照。
  • EVAS模型部分区域剪切率高于其他模型。
  • 所有支架远端共同髂动脉附近存在低WSS和高OSI小区域。
  • 各感兴趣区域最大剪切率远低于急性血栓形成病理阈值。

临床怎么用

  • EVAR和EVAS术后需关注肾动脉后壁及支架远端血流动力学变化。
  • EVAS局部较高剪切率可能影响血栓风险,但本研究未达病理阈值。

局限性

  • 研究为体外模型,不能完全代表体内生理条件。
  • 样本量小(四种体模),结论需进一步临床验证。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Endovascular aneurysm repair (EVAR) with a modular endograft has become the preferred treatment for abdominal aortic aneurysms. A novel concept is endovascular aneurysm sealing (EVAS), consisting of dual endoframes surrounded by polymer-filled endobags. This dual-lumen configuration is different from a bifurcation with a tapered trajectory of the flow lumen into the two limbs and may induce unfavorable flow conditions. These include low and oscillatory wall shear stress (WSS), linked to atherosclerosis, and high shear rates that may result in thrombosis. An in vitro study was performed to assess the impact of EVAR and EVAS on flow patterns and WSS. METHODS: Four abdominal aortic aneurysm phantoms were constructed, including three stented models, to study the influence of the flow divider on flow (Endurant [Medtronic, Minneapolis, Minn], AFX [Endologix, Irvine, Calif], and Nellix [Endologix]). Experimental models were tested under physiologic resting conditions, and flow was visualized with laser particle imaging velocimetry, quantified by shear rate, WSS, and oscillatory shear index (OSI) in the suprarenal aorta, renal artery (RA), and common iliac artery. RESULTS: WSS and OSI were comparable for all models in the suprarenal aorta. The RA flow profile in the EVAR models was comparable to the control, but a region of lower WSS was observed on the caudal wall compared with the control. The EVAS model showed a stronger jet flow with a higher shear rate in some regions compared with the other models. Small regions of low WSS and high OSI were found near the distal end of all stents in the common iliac artery compared with the control. Maximum shear rates in each region of interest were well below the pathologic threshold for acute thrombosis. CONCLUSIONS: The different stent designs do not influence suprarenal flow. Lower WSS is observed in the caudal wall of the RA after EVAR and a higher shear rate after EVAS. All stented models have a small region of low WSS and high OSI near the distal outflow of the stents.

来源:J Vasc Surg,查看原文。版权归原作者所有。

引用

  1. Boersen JT, Groot Jebbink E, Versluis M, et al. Flow and wall shear stress characterization after endovascular aneurysm repair and endovascular aneurysm sealing in an infrarenal aneurysm model. J Vasc Surg. 2017. PMID: 28285931. doi:10.1016/j.jvs.2016.10.077

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。