文献速递主动脉疾病

全自动与半自动主动脉瘤分割及直径测量在增强与非增强CT上的验证研究

Validation Study Comparing Artificial Intelligence for Fully Automatic Aortic Aneurysms Segmentation and Diameter Measurements on Contrast and Noncontrast Enhanced Computed Tomography: A la mémoire de Lucie Salomon du Mont (In memory of Lucie Salomon du Mont).
PubMed 文献 · Ann Vasc Surg · 2025-06-04

本研究为单中心回顾性比较研究,纳入120例CT扫描(60例CTA和60例非增强CT),对比全自动软件与2名血管外科医生半自动方法测量主动脉最大壁对壁直径。全自动与半自动测量在CTA和CT上均呈强相关,中位绝对差异1.1-4.2毫米,全自动处理时间显著更短(中位73秒 vs 700秒,P<0.001)。

要点

  • 全自动与半自动测量在CTA上相关系数0.94-0.96,非增强CT上0.87-0.89。
  • 不同解剖部位中位绝对直径差异为1.1-4.2毫米。
  • 全自动方法中位处理时间73秒,显著快于半自动700秒(P<0.001)。

核心结论

  • 全自动方法在EVAR术前术后不同主动脉部位与半自动测量在CTA和非增强CT上均呈强一致性,且分析时间显著缩短。

研究设计与样本

  • 单中心回顾性比较研究,纳入120例CT扫描(60例CTA和60例非增强CT),含23例EVAR、4例胸主动脉EVAR、1例开窗EVAR及4例对照。

主要发现

  • CTA上全自动与半自动测量的相关系数为0.94-0.96(R2=0.88-0.92),非增强CT上为0.87-0.89(R2=0.76-0.79)。
  • 不同解剖部位主动脉直径中位绝对差异为1.1毫米至4.2毫米。
  • 全自动方法中位执行时间73秒(四分位距57-91),半自动方法700秒(四分位距613-800),P<0.001。

临床怎么用

  • 全自动方法可在临床实践和研究中用于EVAR术前术后主动脉直径测量,可能改善工作流程效率。

局限性

  • 原文未述局限性

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Accurate aortic diameter measurements are essential for diagnosis, surveillance, and procedural planning in aortic disease. Semiautomatic methods remain widely used but require manual corrections, which can be time-consuming and operator-dependent. Artificial intelligence-driven fully automatic methods may offer improved efficiency and measurement accuracy. This study aims to validate a fully automatic method against a semiautomatic approach using computed tomography angiography (CTA) and noncontrast CT scans. METHODS: A monocentric retrospective comparative study was conducted on patients who underwent endovascular aneurysm repair (EVAR) for infrarenal, juxta-renal, or thoracic aneurysms and a control group. Maximum aortic wall-to-wall diameters were measured before and after repair using the fully automatic software (PRAEVAorta2, Nurea, Bordeaux, France) and compared to measurements performed by 2 vascular surgeons using a semiautomatic approach on CTA and noncontrast CT scans. Correlation coefficients (Pearson's R) and absolute differences were calculated to assess agreement. RESULTS: A total of 120 CT scans (60 CTA and 60 noncontrast CT) were included, comprising 23 EVAR, 4 thoracic EVAR, 1 fenestrated EVAR, and 4 control cases. Strong correlations were observed between the fully automatic and semiautomatic measurements in both CTA and noncontrast CT. For CTA, correlation coefficients ranged from 0.94 to 0.96 (R2 = 0.88-0.92), whereas for noncontrast CT, they ranged from 0.87 to 0.89 (R2 = 0.76-0.79). Median absolute differences in aortic diameter measurements varied between 1.1 mm and 4.2 mm across the different anatomical locations. The fully automatic method demonstrated a significantly faster processing time, with a median execution time of 73 sec (interquartile range: 57-91) compared to 700 (interquartile range: 613-800) for the semiautomatic method (P < 0.001). CONCLUSION: The fully automatic method demonstrated strong agreement with semiautomatic measurements for both CTA and noncontrast CT, before and after endovascular repair in different aortic locations, with significantly reduced analysis time. This method could improve workflow efficiency in clinical practice and research applications.

来源:Ann Vasc Surg,查看原文。版权归原作者所有。

引用

  1. Gatinot A, Caradu C, Stephan L, et al. Validation Study Comparing Artificial Intelligence for Fully Automatic Aortic Aneurysms Segmentation and Diameter Measurements on Contrast and Noncontrast Enhanced Computed Tomography: A la mémoire de Lucie Salomon du Mont (In memory of Lucie Salomon du Mont). Ann Vasc Surg. 2025. PMID: 40480487. doi:10.1016/j.avsg.2025.05.045

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。