血管外科物理废弃物与透视能量消耗的审计及未来建议
在单家三级医院前瞻性审计18例血管手术的物理废弃物、回顾性审计97例数字减影血管造影的透视能耗,估算二氧化碳当量排放。下肢旁路物理废弃物排放最高(85.75 kg CO2e),颈动脉内膜剥脱术最低(57.22 kg CO2e);血管腔内动脉瘤修复DSA排放最高(41.11 kg),TCAR最低(7.33 kg)。透视时间与CO2e呈线性相关(r²=0.76),手术时长与废弃物CO2e无显著相关。
要点
- 下肢旁路物理废弃物CO2e最高(85.75 kg),颈动脉内膜剥脱术最低(57.22 kg)。
- 血管腔内动脉瘤修复DSA排放最高(41.11 kg),TCAR最低(7.33 kg)。
- 透视时间与CO2e呈线性相关(r²=0.76),手术时长与废弃物无显著相关(r²=0.099)。
核心结论
- 血管手术平均从废弃物和透视产生108.47 kg CO2e,相当于汽油动力车辆行驶278英里。
- 研究发现透视时间增加与CO2e相关,且不同手术的排放速率不同,提示优化透视和术中技术可能有助于降低排放。
研究设计与样本
- 单家三级医院前瞻性审计血管手术的物理废弃物,并回顾性审计同一医院数字减影血管造影的透视能耗。
- 物理废弃物审计纳入18例血管手术,透视能耗审计纳入97例手术。
- 记录透视时间(分钟)、DSA运行次数、振幅和电压,计算功率(kW)和能量(kWh)。
- 使用美国环境保护署认证的温室气体等效计算器估算总二氧化碳当量排放。
主要发现
- 下肢旁路产生的物理废弃物CO2e最高(85.75 kg;95%CI 71.4-100.2 kg),颈动脉内膜剥脱术最低(57.22 kg;95%CI 48.7-65.7 kg)。
- 手术时长与废弃物量之间无显著相关性。
- 血管腔内动脉瘤修复DSA运行产生的CO2e最高(41.11 kg;95%CI 28.82-53.40 kg),TCAR最低(7.33 kg;95%CI 5.15-9.49 kg)。
- 胸主动脉腔内修复DSA CO2e速率最高(3.63 kg/min DSA),TCAR最低(1.37 kg/min DSA)。
- 手术时长与废弃物CO2e无线性相关(r²=0.099),透视时间与CO2e呈线性相关(r²=0.76)。
关键数值与推荐
- 血管手术平均从废弃物和透视产生108.47 kg CO2e,相当于汽油动力车辆行驶278英里。
- 下肢旁路物理废弃物CO2e为85.75 kg(95%CI 71.4-100.2 kg),颈动脉内膜剥脱术为57.22 kg(95%CI 48.7-65.7 kg)。
- 血管腔内动脉瘤修复DSA CO2e为41.11 kg(95%CI 28.82-53.40 kg),TCAR为7.33 kg(95%CI 5.15-9.49 kg)。
- 胸主动脉腔内修复DSA CO2e速率为3.63 kg/min DSA,TCAR为1.37 kg/min DSA。
临床怎么用
- 作者认为,追踪影像设备当前能量输出、投资高效设备以及调整术中设置可能都有助于减少血管手术的环境足迹。
- 作者认为,不同手术排放速率不同,提示优化透视和术中技术可能有助于降低排放。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: Hospitals are responsible for 4% to 5% of global greenhouse gas production and are significant contributors to climate change. We sought to understand the contributions of vascular surgery to the carbon footprint of hospitals by examining emissions from fluoroscopy and physical waste across common vascular surgeries. METHODS: Vascular operations at a single tertiary hospital were prospectively audited for physical waste. Additional cases from the same hospital were audited retrospectively for energy expenditure during fluoroscopy digital subtraction angiography (DSA). The fluoroscopy time (minutes), number of DSA runs, amplitude, and voltage were recorded, and subsequently, power (kW) and energy (kWh) were calculated. The operations were separated into cohorts based on operation: endovascular aneurysm repair, thoracic endovascular aortic repair, transcarotid artery revascularization (TCAR), carotid endarterectomy, femoral endarterectomy with iliac intervention, lower extremity bypass, endovascular lower extremity revascularization. Using a certified Greenhouse Gas Equivalencies Calculator from the United States Environmental Protection Agency, total carbon dioxide emissions (CO2e) were estimated. RESULTS: Eighteen vascular operations were audited for physical waste. Lower extremity bypasses produced the largest amount of CO2e from physical waste (85.75 kg CO2e; 95% confidence interval [CI], 71.4-100.2 kg), whereas the least was produced by carotid endarterectomy (57.22 kg CO2e; 95% CI, 48.7-65.7 kg). No significant correlation was seen between operative length and amount of waste. Ninety-seven operations were retrospectively audited for fluoroscopy energy use during DSA runs. Endovascular aortic repair produced the largest CO2e from DSA runs (41.11 kg; 95% CI, 28.82-53.40 kg), whereas the least was produced by TCAR (7.33 kg; 95% CI, 5.15-9.49 kg). When DSA CO2e were analyzed against fluoroscopy time, thoracic endovascular aortic repair produced CO2e at the highest rate of 3.63 kg/min DSA, whereas TCAR produced CO2e at the lowest rate of 1.37 kg/min DSA. Although no linear correlation was found between operation length and CO2e from waste (r2 = 0.099), a linear correlation was found between fluoroscopy time and CO2e (r2 = 0.76). CONCLUSIONS: Vascular operations, on average, generate 108.47 kg of CO2e from waste and fluoroscopy, the equivalent of driving an average gasoline-powered vehicle for 278 miles. This study found a correlation between increased fluoroscopy time and CO2e. It also found that the rate of emissions differs between different operations, suggesting a role in optimizing fluoroscopy and intraoperative techniques to lower emissions. Efforts to track current energy output from imaging devices, investing in efficient devices, and adjusting intraoperative settings may all play a role in decreasing vascular surgery's environmental footprint.
引用
- Moussa Pasha O, Rowe A, Ebertz DP, et al. An audit of physical waste and fluoroscopy energy consumption in vascular surgery and suggestions for the future. J Vasc Surg. 2025. PMID: 40122310. doi:10.1016/j.jvs.2025.03.186
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。