扩张的升主动脉动态形态及其对胸主动脉腔内修复近端锚定区的意义
本研究对105例升主动脉扩张(40-50 mm)与未扩张(<40 mm)患者行心电门控CT血管造影,比较收缩期与舒张期各平面最大和最小直径。结果显示,若升主动脉中段扩张,窦管交界处呈明显倒漏斗形三维形态,不宜以常规覆膜支架在该处锚定行胸主动脉腔内修复;头臂干处似有应用前景,椭圆形平面宜用平均直径而非最大直径选支架尺寸。
要点
- 升主动脉中段扩张时,窦管交界处呈倒漏斗形,常规覆膜支架近端锚定于该处不合适。
- 头臂干处呈中度漏斗形态,似有应用合适尺寸和顺应性覆膜支架行胸主动脉腔内修复的前景。
- 椭圆形主动脉平面选支架尺寸时,应考虑用平均主动脉直径而非最大升主动脉直径。
核心结论
- 若升主动脉中段扩张,因窦管交界处主动脉段呈明显倒漏斗形节段形态,不宜用常规覆膜支架在该处无额外近端固定行胸主动脉腔内修复。
- 头臂干处主动脉段似有应用合适尺寸和顺应性覆膜支架行胸主动脉腔内修复的前景。
- 在椭圆形主动脉平面形态下,应考虑用平均主动脉直径而非最大升主动脉直径进行覆膜支架尺寸选择。
研究设计与样本
- 研究纳入升主动脉扩张(直径40-50 mm)与未扩张(<40 mm)患者,行心电门控全升主动脉CT血管造影,采集收缩期和舒张期图像。
- 共纳入105例患者,男性54%,中位年龄80岁(IQR 78-85);扩张组35例,未扩张组70例。
- 对每个升主动脉段每个平面记录收缩期和舒张期的最大与最小直径。
主要发现
- 窦管交界处升主动脉段平面较同段远端平面呈更椭圆形,最大与最小直径差分别为8.9%至9.4%和4.8%至5.6%。
- 若升主动脉中段扩张,窦管交界处主动脉段呈更明显倒漏斗形三维形态,近端与远端节段平面直径差在未扩张组为14%(IQR 11%-19%),在扩张组为18%(IQR 16%-22%,p<0.001)。
临床怎么用
- 若升主动脉中段扩张,因窦管交界处呈明显倒漏斗形节段形态且Ia型内漏和覆膜支架移位风险高,不宜在该处近端锚定行胸主动脉腔内修复。
- 头臂干处主动脉段因呈中度漏斗形态,似有应用合适尺寸和顺应性覆膜支架行胸主动脉腔内修复的前景。
- 在椭圆形主动脉平面形态下,应考虑用平均主动脉直径而非最大升主动脉直径进行覆膜支架尺寸选择。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: To improve the outcomes of thoracic endovascular aortic repair (TEVAR), we investigated the dynamic morphology of dilated and nondilated ascending aortas (AAs) to determine whether an appropriate proximal landing zone for TEVAR exists if the middle AA is dilated. MATERIALS AND METHODS: Patients with dilated (diameter 40-50 mm) and nondilated (<40 mm) AAs underwent electrocardiogram-gated computed tomography angiography of the entire AA in the systolic and diastolic phases. For each plane of each AA segment, the maximal and minimal diameters in systole and diastole were recorded. RESULTS: A total of 105 patients were enrolled (54% male; median age: 80 years [IQR 78-85]). A total of 35 patients were included in the dilated AA group (DG), and 70 patients were included in the nondilated AA group (n-DG). The aortic planes of the AA segment at the sinotubular junction (STJ) showed a more oval-shaped morphology compared with the distal planes of the same segment (the differences between the maximum and minimum diameters were 8.9% to 9.4% and 4.8% to 5.6%, respectively). If the mid-ascending aorta was dilated, the aortic segment at the STJ showed a more pronounced reversed-funnel 3D morphology, with a 14% (IQR 11%-19%) difference in diameters between the proximal and distal segmental planes shown in the n-DG and 18% (IQR 16%-22%, p<0.001) in the DG. CONCLUSION: If the middle AA is dilated, it is considered unsuitable to perform TEVAR using conventional endografts without additional proximal fixation in the aortic segment at the STJ due to its pronounced reversed-funnel segmental morphology. By contrast, the aortic segment at the brachiocephalic trunk seems to be promising for performing TEVAR using an endograft of the appropriate size and conformability. Moreover, endograft sizing using the average aortic diameter instead of the maximal AA diameter in an oval-shaped aortic plane morphology should be considered.Clinical ImpactIf the middle ascending aorta is dilated, it is considered unsuitable to perform TEVAR with a proximal landing in the aortic segment at the sinotubular junction due to its pronounced reversed-funnel segmental morphology and high risk of type Ia endoleak and endograft migration. By contrast, the aortic segment at the brachiocephalic trunk seems to be promising for performing TEVAR due to its moderate funnel morphology using an endograft of appropriate size and conformability.
引用
- Skrypnik D, Bischoff MS, Meisenbacher K, et al. Dynamic Morphology of Dilated Ascending Aorta and its Implications for Proximal Landing During Thoracic Endovascular Aortic Repair. J Endovasc Ther. 2024. PMID: 39535121. doi:10.1177/15266028241292462
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。