Hem-o-lok/Lapra-Ty夹组合在肾部分切除术缝线上的把持强度
本研究通过材料测试系统对Vicryl、Monocryl、Chromic、Stratafix和V-Loc等缝线(直径1至4-0,每种缝线n=7,共161次实验)进行恒定速度牵拉,测量Hem-o-lok/Lapra-Ty夹组合的防滑强度。结果显示Vicryl 4-0把持强度最低(4.3±1.4N),Monocryl 0最高(16.5±1.6N);带刺缝线(Stratafix、V-Loc)相比多数标准缝线表现出更优的把持强度,且倒刺方向不影响把持张力。所有测试缝线的平均把持张力均大于既往研究中认为足够用于组织闭合的3.2N。
要点
- Vicryl 4-0把持强度最低(4.3±1.4N),Monocryl 0最高(16.5±1.6N)。
- 2-0缝线中,Vicryl为5.7N,Stratafix为13.8N,V-Loc为15.9N。
- 所有测试缝线的平均把持张力均大于既往研究认为足够的3.2N。
核心结论
- 该锚定系统对所有测试缝线的平均把持张力均大于既往研究中认为足够用于组织闭合的3.2N。
- 带刺缝线(Stratafix、V-Loc)相比多数标准缝线似乎具有更优的把持强度,且倒刺方向不影响把持张力。
研究设计与样本
- 采用材料测试系统对锚定缝线游离端施加恒定速度牵拉,数字测力计测量缝线在闭合系统中滑动前的张力。
- 每种缝线末端1 cm处附着Lapra-Ty夹作为Hem-o-lok的背挡。
- 测试Vicryl、Monocryl、Chromic、Stratafix和V-Loc缝线,直径1至4-0,每种缝线n=7,共161次实验。
主要发现
- Lapra-Ty/Hem-o-lok夹组合的把持强度在Vicryl 4-0缝线最低(4.3±1.4N),在Monocryl 0缝线最高(16.5±1.6N)。
- 较大缝线(1和0)比小尺寸缝线(4-0和3-0)在更高张力下才滑动。
- 2-0缝线中,把持强度Vicryl为5.7N,Stratafix为13.8N,V-Loc为15.9N。
局限性
- 原文未报告局限性
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: To investigate the anti-slip strength of closing systems employing sutures terminated with a Hem-o-lok/Lapra-Ty clip combination to determine which sutures perform best for this application. Partial nephrectomy is the reference standard for treatment of small renal masses. The main disadvantage of partial nephrectomy is the risk of technical complications, including renorrhaphy site bleeding and urine leak. MATERIALS AND METHODS: A materials testing system produced a constant velocity pull on the free end of an anchored suture. A Lapra-Ty clip was attached 1 cm from the end of each suture as a backstop for the Hem-o-lok. A digital force gauge measured the tension that was applied until the suture slipped in the closing system. Vicryl, Monocryl, Chromic, Stratafix, and V-Loc sutures of diameters 1 to 4-0 were tested (n = 7 for each suture type, 161 total experiments). RESULTS: The holding strength of a Lapra-Ty/Hem-o-lok clip combination is lowest for Vicryl 4-0 (4.3 ± 1.4N) and highest for Monocryl 0 (16.5 ± 1.6N) sutures. Larger sutures (1 and 0) hold at higher tensions than sutures with smaller dimensions (4-0 and 3-0). For 2-0 sutures, the holding strength was 5.7N with Vicryl, 13.8N with Stratafix, and 15.9N with V-Loc sutures. CONCLUSION: The mean values of holding tension of this anchoring system for all sutures tested was greater than the amount found to be sufficient for tissue closure in previous studies (3.2N). Barbed sutures (Stratafix, V-Loc) appeared to have superior holding strength when compared with most standard sutures; barb orientation does not influence holding tension.
引用
- Paka B, Bossemeyer R, Tourojman M, et al. Holding Strength of a Hem-o-lok/Lapra-Ty Clip Combination on Sutures Used During Partial Nephrectomy. Urology. 2017. PMID: 28652162. doi:10.1016/j.urology.2017.06.024
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。