文献速递针灸推拿

电针针体表面腐蚀的检测研究

Examination of needle surface corrosion in electroacupuncture.
PubMed 文献 · Acupunct Med · 2018-05-24

该研究在健康受试者中模拟常见临床实践进行4次电针治疗,每次治疗后立即用扫描电子显微镜检查针体表面,并与未通电的已用针和未使用的原包装针进行对照。共检查32根针,结果显示,使用电荷平衡电针仪刺激30分钟后,任何针均未检测到电解腐蚀的证据。因此建议临床电针选择电荷平衡的电针仪以避免潜在的针体腐蚀。

要点

  • 健康受试者电针30分钟后,SEM未发现针体电解腐蚀证据。
  • 推荐临床使用电荷平衡电针仪以规避潜在针体腐蚀风险。
  • 研究仅检查两种一次性硅涂层不锈钢针,结果需谨慎外推。

核心结论

  • 在健康受试者中使用电荷平衡电针仪进行30分钟电针刺激后,未在任何针上检测到电解腐蚀的证据。

研究设计与样本

  • 研究对健康受试者进行4次电针治疗,模拟常见临床实践,每次治疗后立即进行针体表面检查。
  • 以未通电的已用针和原包装未使用针作为对照,选用两种常用的一次性硅涂层不锈钢针。
  • 使用ES-160数字电针仪(电荷平衡电刺激器)施加刺激,示波器记录波形和电流。
  • 所有针在检查前经灭菌,用扫描电子显微镜(SEM)对针尖和针杆拍照分析,共检查32根针。

主要发现

  • SEM图像展示了针样品的表面光洁度、毛刺附着和表面特征。
  • 在健康受试者中,电荷平衡电针仪刺激30分钟后的任何针上均未检测到电解腐蚀证据。

关键数值与推荐

  • 推荐选择电荷平衡的电针仪,以避免电针临床实践中针的潜在腐蚀。

临床怎么用

  • 临床电针治疗时优先选用电荷平衡的电针仪,以降低针体电解腐蚀的潜在风险。

局限性

  • 研究仅在健康受试者中进行4次电针治疗,未涉及患者或长期使用场景。
  • 实验仅选用两种一次性硅涂层不锈钢针,结果可能不适用于其他类型针具。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Electroacupuncture (EA) is a modern form of acupuncture therapy where stainless steel acupuncture needles are used as percutaneous electrodes to apply electrical stimulation. The concern about electrolytic corrosion of needles during EA has not been conclusively addressed. AIM: To examine whether corrosion of stainless steel acupuncture needles occurs after EA to establish the safety profile of this therapy. METHODS: The study comprised four EA sessions on healthy participants mimicking a common clinical practice, with needle surface examinations conducted immediately after each session. Used acupuncture needles that did not undergo electrical stimulation and unused needles taken from the original package were also examined as control comparisons. Two commonly used types of single-use, silicone-coated, stainless steel needles were selected for the experiment. The ES-160 digital acupunctoscope (a charge-balanced electric stimulator) was used to deliver electrical stimulation, and an oscilloscope was used to record the waveforms and electric currents. All needles were sterilised before examination by a scanning electron microscope (SEM), where images of needle tips and shafts were taken for further analysis. RESULTS AND CONCLUSIONS: 32 needles were examined under the SEM. As the main findings, the SEM images showed the surface finish, burr attachments and surface characteristics of needle samples. No evidence of electrolytic corrosion was detected on any needle that underwent electrical stimulation for 30 min delivered by a charge-balanced acupunctoscope in healthy participants. The choice of a charge-balanced acupunctoscope is recommended to avoid any potential corrosion of needles in EA clinical practice.

来源:Acupunct Med,查看原文。版权归原作者所有。

引用

  1. Zhang CS, Zhang GS, Xu S, et al. Examination of needle surface corrosion in electroacupuncture. Acupunct Med. 2018. PMID: 29798850. doi:10.1136/acupmed-2017-011542

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。