基于运动视频的提插手法定量分析:针灸教师与学生对比
本研究采用运动视频分析技术,对比30名针灸教师与60名学生在LI11穴行三种提插手法时的针刺操作客观参数。结果显示教师组拇指尖、食指近端指间关节及食指末端X轴摆动等运动参数高于学生组,且在补法与泻法操作中波谷与波峰离散度更小。提插手法可简化为以拇指和食指掌指关节为轴心的定轴旋转,教师组在提插过程中近端指间关节角变化更大且空间控制更佳。
要点
- 教师组提插时拇指尖与食指近端指间关节运动参数高于学生组。
- 教师组在补泻操作中波峰与波谷离散度更小,空间控制更佳。
- 提插手法可简化为以掌指关节为轴心的定轴旋转。
核心结论
- 提插手法可简化为以拇指和食指掌指关节为轴心的定轴旋转,教师组在提插过程中近端指间关节角变化更大且空间控制更好。
- 两组时间控制相似,提示时间控制可能更容易掌握;重复训练可能有助于提高针刺操作的运动与空间稳定性。
研究设计与样本
- 研究纳入30名针灸教师与60名学生,在LI11穴行针并录制运动视频。
- 记录三种提插手法亚型:轻度补泻、补法、泻法,使用Simi Motion 3D软件分析四个标记点的运动参数。
- 组间差异采用t检验、X2检验和/或秩和检验进行比较。
主要发现
- 教师组拇指尖、食指近端指间关节及食指末端X轴摆动的运动参数高于学生组。
- 教师组在补法操作中波谷离散度更小,在泻法操作中波峰离散度更小。
- 近端指间关节变化与X轴方向运动范围呈正相关。
- 两组时间控制相似。
临床怎么用
- 针刺教学可强调以拇指和食指掌指关节为轴心的定轴旋转模式。
- 可针对食指近端指间关节角变化与空间控制进行重复训练。
局限性
- 原文未报告样本量计算、随机化或盲法信息。
- 原文未报告具体运动参数数值、P值或置信区间。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE: To compare objective measures of needle manipulation between students and teachers of acupuncture using motion video analysis technology, to help support instructional acupuncture education. METHODS: A total of 30 teachers and 60 students participated in this study. Acupuncture needles were inserted at LI11 and motion videos were recorded for three subtypes of 'lifting-thrusting' manipulation: (1) 'mild reinforcing-attenuating'; (2) 'reinforcing'; and (3) 'attenuating'. The videos were analysed using Simi Motion 3D software to acquire the movement parameters of four trace marks: 'thumb tip'; 'forefinger tip'; 'forefinger middle joint'; and 'forefinger base joint'. Differences between the two groups were compared using t-tests, X2 tests and/or rank-sum tests. RESULTS: Changes in the near-end interphalangeal joint were positively associated with a range of movement along the X axis. Motion parameters for the thumb tip, the proximal interphalangeal (PIP) joint of the forefinger and the X axis shaft swing near the end of the forefinger in the teacher group were higher than those in the student group. The teacher group featured smaller trough dispersion and smaller crest dispersion during 'reinforcing' and 'attenuating' manipulations, respectively. CONCLUSIONS: The 'lifting-thrusting' manipulation could be simplified as a fixed-axis rotation using metacarpophalangeal joints in the thumb and forefinger as the shaft centre. Teachers opened at a larger angular variation for the PIP during the lifting and thrusting processes with better spatial control. Temporal control was similar between groups and therefore appears easier to grasp. Repetitive training might be helpful for improving athletic and spatial stability during needle manipulation.
引用
- Tang WC, Yang HY, Liu TY, et al. Motion video-based quantitative analysis of the 'lifting-thrusting' method: a comparison between teachers and students of acupuncture. Acupunct Med. 2017. PMID: 28844062. doi:10.1136/acupmed-2016-011348
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。