全便携式腕部外骨骼用于卒中后无监督训练的特征与穿戴性评估
本研究开发了一种用于卒中康复中主动腕伸/屈支持的全便携式外骨骼,并对其进行特征描述与穿戴性评估。设备由前臂/手模块(238 g)和上臂模块(224 g)组成,前臂模块可提供高达3.7 Nm的扭矩和530 deg/s的角速度,范围154°;上臂模块含控制电子和电池,正常使用可供电约125分钟。15名健康参与者和2名卒中幸存者经4次练习后均能独立穿脱设备,健康参与者穿戴和脱卸时间分别为61±15秒和24±6秒,卒中幸存者分别为54秒/22秒和113秒/32秒;可用性问卷显示所有参与者对设备持积极态度。
要点
- 全便携式腕部外骨骼重量小于500克,可单手快速穿脱。
- 健康参与者穿戴时间61±15秒,脱卸时间24±6秒。
- 两名卒中幸存者经4次练习后均能独立穿脱设备。
核心结论
- 该研究描述了一种重量小于500克、可单手轻松快速穿脱的主动腕部外骨骼,设计强调穿脱环节,作为可穿戴康复技术迈向患者独立无监督使用的第一步。
研究设计与样本
- 研究首先定义需求并构建外骨骼,然后使用标准化触觉和人机交互指标对设备进行特征描述,并通过定性和定量方法在15名健康参与者和2名卒中幸存者中评估穿戴性。
主要发现
- 前臂模块重量238克,上臂模块重量224克;前臂模块主动支持腕伸和腕屈,扭矩高达3.7 Nm,角速度高达530 deg/s,范围154°;上臂模块含控制电子和电池,正常使用可供电约125分钟。
- 所有参与者在仅4次练习试验后均能独立穿脱设备;健康参与者穿戴和脱卸时间分别为61±15秒和24±6秒;两名卒中幸存者穿戴/脱卸时间分别为54秒/22秒和113秒/32秒。
- 可用性问卷显示,尽管存在轻微困难,所有参与者对设备均持积极态度。
临床怎么用
- 该设备可用于卒中后腕伸/屈的主动支持训练,设计便于患者独立穿脱,为无监督环境下的分布式训练提供可能。
局限性
- 穿戴性评估样本量小,仅纳入15名健康参与者和2名卒中幸存者,且未报告长期训练效果。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Chronic hand and wrist impairment are frequently present following stroke and severely limit independence in everyday life. The wrist orientates and stabilizes the hand before and during grasping, and is therefore of critical importance in activities of daily living (ADL). To improve rehabilitation outcomes, classical therapy could be supplemented by novel therapies that can be applied in unsupervised settings. This would enable more distributed practice and could potentially increase overall training dose. Robotic technology offers new possibilities to address this challenge, but it is critical that devices for independent training are easy and appealing to use. Here, we present the development, characterization and wearability evaluation of a fully portable exoskeleton for active wrist extension/flexion support in stroke rehabilitation. METHODS: First we defined the requirements, and based on these, constructed the exoskeleton. We then characterized the device with standardized haptic and human-robot interaction metrics. The exoskeleton is composed of two modules placed on the forearm/hand and the upper arm. These modules weigh 238 g and 224 g, respectively. The forearm module actively supports wrist extension and flexion with a torque up to 3.7 Nm and an angular velocity up to 530 deg/s over a range of 154∘. The upper arm module includes the control electronics and battery, which can power the device for about 125 min in normal use. Special emphasis was put on independent donning and doffing of the device, which was tested via a wearability evaluation in 15 healthy participants and 2 stroke survivors using both qualitative and quantitative methods. RESULTS: All participants were able to independently don and doff the device after only 4 practice trials. For healthy participants the donning and doffing process took 61 ±15 s and 24 ±6 s, respectively. The two stroke survivors donned and doffed the exoskeleton in 54 s/22 s and 113 s/32 s, respectively. Usability questionnaires revealed that despite minor difficulties, all participants were positive regarding the device. CONCLUSIONS: This study describes an actuated wrist exoskeleton which weighs less than 500 g, and which is easy and fast to don and doff with one hand. Our design has put special emphasis on the donning aspect of robotic devices which constitutes the first barrier a user will face in unsupervised settings. The proposed device is a first and intermediate step towards wearable rehabilitation technologies that can be used independently by the patient and in unsupervised settings.
引用
- Lambelet C, Temiraliuly D, Siegenthaler M, et al. Characterization and wearability evaluation of a fully portable wrist exoskeleton for unsupervised training after stroke. J Neuroeng Rehabil. 2020. PMID: 33028354. doi:10.1186/s12984-020-00749-4
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。