文献速递神经康复骨科与运动康复

Armeo®Spring外骨骼的重量补偿特性:对临床实践与研究的启示

Weight compensation characteristics of Armeo®Spring exoskeleton: implications for clinical practice and research.
PubMed 文献 · J Neuroeng Rehabil · 2017-02-17

该研究通过测力传感器在矢状面测量Armeo®Spring肘关节静态力,量化不同弹簧与模块长度设置下的重量补偿。结果发现弹簧张力越高、模块长度越短,卸载支持越大(≤6.32 kg),且补偿斜率随长度缩短而下降更快。理解这些设置影响有助于优化临床实践并提高研究保真度。

要点

  • 弹簧张力越高、模块长度越短,重量补偿卸载支持越大(≤6.32 kg)。
  • 补偿斜率随模块长度缩短而下降更快,与弹簧设置无关。
  • 设置差异将操作范围分为不同的卸载与加载区域。

核心结论

  • Armeo®Spring的重量补偿受弹簧张力和模块长度设置影响,理解这些影响有助于定义最佳临床实践并提高研究保真度。

研究设计与样本

  • 采用测力传感器连接Armeo®Spring肘关节,在矢状面测量静态力以量化重量补偿。
  • 检查所有上部弹簧设置,以5°增量在最小、最大及两个中间上下模块长度设置下测量,同时保持下部弹簧最小。
  • 另在最小上部弹簧和最大下部弹簧设置下,于最小和最大模块长度重复测量。
  • 将重量补偿对上部模块角度绘图,并分析每种条件的斜率。

主要发现

  • Armeo®Spring设计促使定义松弛角和平衡角,根据弹簧和长度设置将操作范围分为不同的卸载和加载区域。
  • 较高弹簧张力和较短模块长度提供更大卸载(≤6.32 kg支持)。
  • 重量补偿斜率随长度设置缩短而下降更快(最小长度=-0.082±0.002 kg/°;最大长度=-0.046±0.001 kg/°),与弹簧设置无关。

临床怎么用

  • 临床可根据患者需求调整弹簧张力和模块长度,以提供≤6.32 kg的卸载支持。
  • 注意较短模块长度下补偿斜率下降更快,可能影响支持随角度变化的稳定性。
  • 研究中使用Armeo®Spring时应报告弹簧和长度设置,以提高研究保真度。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Armeo®Spring exoskeleton is widely used for upper extremity rehabilitation; however, weight compensation provided by the device appears insufficiently characterized to fully utilize it in clinical and research settings. METHODS: Weight compensation was quantified by measuring static force in the sagittal plane with a load cell attached to the elbow joint of Armeo®Spring. All upper spring settings were examined in 5° increments at the minimum, maximum, and two intermediate upper and lower module length settings, while keeping the lower spring at minimum. The same measurements were made for minimum upper spring setting and maximum lower spring setting at minimum and maximum module lengths. Weight compensation was plotted against upper module angles, and slope was analyzed for each condition. RESULTS: The Armeo®Spring design prompted defining the slack angle and exoskeleton balance angle, which, depending on spring and length settings, divide the operating range into different unloading and loading regions. Higher spring tensions and shorter module lengths provided greater unloading (≤6.32 kg of support). Weight compensation slope decreased faster with shorter length settings (minimum length = -0.082 ± 0.002 kg/°; maximum length = -0.046 ± 0.001 kg/°) independent of spring settings. CONCLUSIONS: Understanding the impact of different settings on the Armeo®Spring weight compensation should help define best clinical practice and improve fidelity of research.

来源:J Neuroeng Rehabil,查看原文。版权归原作者所有。

引用

  1. Perry BE, Evans EK, Stokic DS, et al. Weight compensation characteristics of Armeo®Spring exoskeleton: implications for clinical practice and research. J Neuroeng Rehabil. 2017. PMID: 28212673. doi:10.1186/s12984-017-0227-0

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。