乳腺癌乳房切除术后辅助放疗:先进算法与部分填充物提高薄胸壁照射剂量计算准确性
研究在薄胸壁体模中比较测量与计算的剂量分布,并评估胸壁厚度<15 mm患者有无部分填充物时DVH参数变化。蒙特卡洛和Acuros XB与实验数据吻合良好,各向异性分析算法低估入射和侧向剂量;部分填充物改善所有算法的靶区覆盖并减少几何变异。作者推荐薄胸壁患者使用先进算法和<2 mm分辨率计算,并需特定DVH标准或部分填充物辅助计划评估。
要点
- 蒙特卡洛和Acuros XB计算与热释光剂量计测量吻合良好,各向异性分析算法低估光束入射和侧向剂量。
- 薄胸壁患者DVH参数对计算算法、分辨率、体结构定义和患者几何敏感,CTVTV95%、CTVTD98%和PTVD98%远低于耐受标准。
- 部分填充物改善所有算法的DVH值并减少患者几何导致的变化;胸壁厚度20-25 mm患者无需填充物即可获得足够靶区覆盖。
核心结论
- 作者推荐胸壁薄的患者使用先进算法和分辨率<2 mm进行剂量计算。
- 作者认为该患者群体需要特定DVH标准或实施部分填充物以促进计划制定和评估。
研究设计与样本
- 在胸壁体模中使用热释光剂量计进行测量,并用蒙特卡洛方法、各向异性分析算法和Acuros XB Eclipse算法计算临床计划的剂量分布。
- 评估15例胸壁厚度8至15 mm患者有无部分填充物时临床靶区肿瘤(CTVT)和计划靶区(PTV)的DVH参数及平均剂量,以及10例胸壁厚度20至25 mm患者无填充物时的相应参数。
主要发现
- 测量显示光束入射和侧向2至12 mm深度处的剂量在8 mm深度处剂量的90%以内。
- 蒙特卡洛和Acuros XB计算与实验数据吻合良好,而各向异性分析算法低估了光束入射和侧向剂量。
- 薄胸壁患者的DVH参数对计算算法、分辨率、体结构定义和患者几何敏感,CTVTV95%、CTVTD98%和PTVD98%远低于耐受标准。
- 部分填充物改善了所有算法的数值并减少了患者几何导致的变化。
- 胸壁厚度20至25 mm患者的剂量计算显示足够的靶区覆盖,且对患者几何和计算算法的依赖性低,无需使用填充物。
关键数值与推荐
- 作者推荐胸壁薄的患者使用先进算法和分辨率<2 mm进行剂量计算。
- 作者认为该患者群体需要特定DVH标准或实施部分填充物以促进计划制定和评估。
临床怎么用
- 对于胸壁薄的患者,作者推荐使用先进算法和分辨率<2 mm进行剂量计算,并考虑特定DVH标准或部分填充物以辅助计划制定和评估。
局限性
- 原文未报告局限性
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
PURPOSE: The aim of this study was to examine measured and calculated dose distributions in a thin-chest-wall phantom and estimate the variations in the dose-volume histogram (DVH) parameters used in plan evaluation for patient geometries with chest-wall thicknesses <15 mm with and without bolus implementation. METHODS AND MATERIALS: Measurements were made using thermoluminescent dosimeters in a chest-wall phantom. The Monte Carlo method, anisotropic analytical algorithm, and Acuros XB Eclipse algorithms were used to calculate dose distributions for clinical plans. DVH parameters for clinical target volume tumor (CTVT) and planning target volume (PTV) and mean doses were evaluated for 15 patients with a chest-wall thickness of 8 to 15 mm with and without partial bolus and for 10 patients with a chest-wall thickness of 20 to 25 mm without bolus. RESULTS: Measurements showed that the dose at a depth of 2 to 12 mm at the beam entrance and laterally was within 90% of the dose at 8 mm depth. Monte Carlo and Acuros XB calculations were well aligned with the experimental data, whereas the anisotropic analytical algorithm underestimated the beam entrance and lateral doses. The DVH parameters for the patients with a thin chest wall were sensitive to calculation algorithm, resolution, body structure definition, and patient geometry. The parameters CTVTV95%, CTVTD98%, and PTVD98% were much lower than the tolerance criteria. Partial bolus improved the values for all algorithms and decreased the variations due to patient geometry. Dose calculations for patients with a chest-wall thickness of 20 to 25 mm resulted in sufficient target coverage and low dependence on patient geometry and calculation algorithm without the use of bolus. CONCLUSIONS: Dose calculations using advanced algorithms and resolution <2 mm are recommended for patients with a thin chest wall. Specific DVH criteria or the implementation of partial bolus was needed to facilitate plan development and evaluation for this patient group.
引用
- Lundstedt D, Lindberg A, Gustafsson M, et al. Adjuvant Radiation Treatment of Breast Cancer After Mastectomy: Advanced Algorithms and Partial Bolus Improve the Dose Calculation Accuracy in the Case of Thin-Chest-Wall Irradiation. Adv Radiat Oncol. 2023. PMID: 37124029. doi:10.1016/j.adro.2023.101223
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。