文献速递显微修复重建创面修复

显微外科医生超声引导ALT皮瓣设计的逐步指南:基础与高级应用及设备设置

Step-by-step guide to ultrasound-based design of alt flaps by the microsurgeon - Basic and advanced applications and device settings.
PubMed 文献 · J Plast Reconstr Aesthet Surg · 2019-12-01

该指南基于两个重建中心125例游离ALT穿支皮瓣移植经验,介绍超声引导皮瓣设计的结构化方法,涵盖探头选择、设备设置、组织形态解读、穿支定位与皮瓣设计。术前彩色编码双功超声(CCDS)穿支显像与术中所见一致率达100%,支持CCDS作为ALT穿支皮瓣术前穿支定位的有力工具。

要点

  • CCDS术前穿支定位与术中所见一致率达100%。
  • 推荐线阵多频探头(6-15 MHz),预设乳腺、甲状腺和血管程序。
  • 设备设置:深度聚焦2-5 cm,PRF低至0.5-1.5 kHz/3-10 cm/s,彩色增益高,壁滤波低/关(<50 Hz)。

核心结论

  • CCDS是穿支皮瓣(如ALT)术前穿支定位的有力工具。

研究设计与样本

  • 基于两个重建中心125例游离ALT穿支皮瓣移植经验的逐步指南。

主要发现

  • 术前CCDS穿支显像与术中所见一致率达100%。

关键数值与推荐

  • 使用线阵多频探头(6-15 MHz),最佳预设程序为乳腺、甲状腺和血管。
  • 有利设备特性:深度聚焦2-5 cm,PRF/Scale低至0.5-1.5 kHz/3-10 cm/s,彩色增益高,壁滤波低/关(<50 Hz)。

临床怎么用

  • 显微外科医生可依据本指南进行探头选择、设备设置、结构化穿支定位及个体化皮瓣设计。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: The anterolateral thigh (ALT) perforator flap is a popular reconstructive tissue transfer. Consistent with the "hot/cold zone" concept for rapid dissection and thin flap harvest, reliable preoperative perforator mapping is mandatory. Color-coded duplex sonography (CCDS) has been shown to have the highest pooled sensitivity and positive predictive value to identify ALT perforating vessels. By reviewing this guide, the reader should learn: 1. Probe selection and basic/advanced device settings 2. Interpreting tissue morphology 3. Structured mapping approach 4. Pedicle position planning 5. Safe flap design 6. Assess subcutaneous course and flap's thickness for subfascial/epifascial/suprafascial harvest 7. Implement perforators identified into a tailor-made flap design including chimeric flaps. METHODS: Experiences with ultrasound-guided flap design gained from 125 ALT perforator flap free tissue transfers performed in two reconstructive centers was the basis of our guide. Our structured method comprises standardized markings, patient positioning, and simple ergonomics. Basic and advanced CCDS settings, selection, and conventional probe guidance are outlined for the microsurgeon. RESULTS: Linear multifrequency probes (6-15 MHz) were used. Best preset programs were breast, thyroid, and vascular. Favorable device properties were depth focused to 2-5 cm, pulse repetition frequency (PRF/Scale) set low to 0.5-1.5 kHz/3-10 cm/s, color gain high, and wall filter (WF) low/off (< 50 Hz). Additional parameters were discussed. A 100% concordance rate was seen comparing preoperative perforator visualization with CCDS and intraoperative findings. Detailed picture and video material were demonstrated. CONCLUSION: CCDS is a powerful tool for preoperative perforator mapping in perforator flaps such as the ALT.

来源:J Plast Reconstr Aesthet Surg,查看原文。版权归原作者所有。

引用

  1. Kehrer A, Sachanadani NS, da Silva NPB, et al. Step-by-step guide to ultrasound-based design of alt flaps by the microsurgeon - Basic and advanced applications and device settings. J Plast Reconstr Aesthet Surg. 2019. PMID: 32249187. doi:10.1016/j.bjps.2019.11.035

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。